Effects of weak planetary rotation on the stability and dynamics of internal stratified jets

2018 ◽  
Vol 30 (9) ◽  
pp. 096602 ◽  
Author(s):  
Timour Radko ◽  
David Lorfeld
Keyword(s):  
Planetary Rotation ◽  
The Stability

scholarly journals Implications of different stellar spectra for the climate of tidally locked Earth-like exoplanets

2020 ◽  
Vol 639 ◽  
pp. A99
Author(s):  
Jake K. Eager ◽  
David J. Reichelt ◽  
Nathan J. Mayne ◽  
F. Hugo Lambert ◽  
Denis E. Sergeev ◽  
...  
Keyword(s):  
The Sun ◽  
Stellar Spectrum ◽  
Stellar Spectra ◽  
Cloud Coverage ◽  
Planetary Rotation ◽  
Stellar Radiation ◽  
Simulated Climate ◽  
The Stability ◽  
The Uk ◽  
Host Stars

The majority of detected potentially habitable exoplanets orbit stars cooler than the Sun and are therefore irradiated by a stellar spectrum that peaks at longer wavelengths than the spectrum incident on Earth. Here, we present results from a set of simulations of tidally locked terrestrial planets orbiting three different host stars to isolate the effect of the stellar spectra on the simulated climate. Specifically, we perform simulations based on TRAPPIST-1e, adopting an Earth-like atmosphere and using the UK Met Office Unified Model in an idealised ‘aqua-planet’ configuration. Whilst holding the planetary parameters constant, including the total stellar flux (900 W m−2) and orbital period (6.10 Earth days), we compare results between simulations where the stellar spectrum is that of a quiescent TRAPPIST-1, Proxima Centauri, and the Sun. In simulations with cooler host stars, an increased proportion of incident stellar radiation was absorbed directly by the troposphere compared to the surface. This in turn led to an increase in the stability against convection, that is, a reduction in overall cloud coverage on the dayside (reducing scattering), leading to warmer surface temperatures. The increased direct heating of the troposphere also led to more efficient heat transport from the dayside to the nightside and therefore to a reduced day-night temperature contrast. We inferred that planets with an Earth-like atmosphere orbiting cooler stars had lower dayside cloud coverage, potentially allowing habitable conditions at increased orbital radii, compared to similar planets orbiting hotter stars for a given planetary rotation rate.

scholarly journals Symmetric Stability of Compressible Zonal Flows on a Generalized Equatorial β Plane

2008 ◽  
Vol 65 (6) ◽  
pp. 1927-1940 ◽  
Author(s):  
Mark D. Fruman ◽  
Theodore G. Shepherd
Keyword(s):  
Angular Momentum ◽  
Linear Stability ◽  
Euler Equations ◽  
Coriolis Force ◽  
Sufficient Conditions ◽  
Zonal Flow ◽  
Positive Definiteness ◽  
Planetary Rotation ◽  
The Stability ◽  
Invariant Functional

Abstract Sufficient conditions are derived for the linear stability with respect to zonally symmetric perturbations of a steady zonal solution to the nonhydrostatic compressible Euler equations on an equatorial β plane, including a leading order representation of the Coriolis force terms due to the poleward component of the planetary rotation vector. A version of the energy–Casimir method of stability proof is applied: an invariant functional of the Euler equations linearized about the equilibrium zonal flow is found, and positive definiteness of the functional is shown to imply linear stability of the equilibrium. It is shown that an equilibrium is stable if the potential vorticity has the same sign as latitude and the Rayleigh centrifugal stability condition that absolute angular momentum increase toward the equator on surfaces of constant pressure is satisfied. The result generalizes earlier results for hydrostatic and incompressible systems and for systems that do not account for the nontraditional Coriolis force terms. The stability of particular equilibrium zonal velocity, entropy, and density fields is assessed. A notable case in which the effect of the nontraditional Coriolis force is decisive is the instability of an angular momentum profile that decreases away from the equator but is flatter than quadratic in latitude, despite its satisfying both the centrifugal and convective stability conditions.

Open discussion

1982 ◽  
Vol 99 ◽  
pp. 605-613
Author(s):  
P. S. Conti
Keyword(s):  
Buenos Aires ◽  
Large Mass ◽  
List Type ◽  
Common Phenomenon ◽  
Open Discussion ◽  
The Stability ◽  
Ring Nebulae

Conti: One of the main conclusions of the Wolf-Rayet symposium in Buenos Aires was that Wolf-Rayet stars are evolutionary products of massive objects. Some questions:–Do hot helium-rich stars, that are not Wolf-Rayet stars, exist?–What about the stability of helium rich stars of large mass? We know a helium rich star of ∼40 MO. Has the stability something to do with the wind?–Ring nebulae and bubbles : this seems to be a much more common phenomenon than we thought of some years age.–What is the origin of the subtypes? This is important to find a possible matching of scenarios to subtypes.

Symmetric Multistep Methods Revisited: II. Numerical Experiments

1999 ◽  
Vol 173 ◽  
pp. 309-314 ◽  
Author(s):  
T. Fukushima
Keyword(s):  
Multistep Methods ◽  
Computational Time ◽  
Integration Time ◽  
Implicit Methods ◽  
Symmetric Methods ◽  
Celestial Bodies ◽  
The Stability ◽  
Predictor Corrector ◽  
Symmetric Multistep Methods ◽  
Integration Errors

AbstractBy using the stability condition and general formulas developed by Fukushima (1998 = Paper I) we discovered that, just as in the case of the explicit symmetric multistep methods (Quinlan and Tremaine, 1990), when integrating orbital motions of celestial bodies, the implicit symmetric multistep methods used in the predictor-corrector manner lead to integration errors in position which grow linearly with the integration time if the stepsizes adopted are sufficiently small and if the number of corrections is sufficiently large, say two or three. We confirmed also that the symmetric methods (explicit or implicit) would produce the stepsize-dependent instabilities/resonances, which was discovered by A. Toomre in 1991 and confirmed by G.D. Quinlan for some high order explicit methods. Although the implicit methods require twice or more computational time for the same stepsize than the explicit symmetric ones do, they seem to be preferable since they reduce these undesirable features significantly.

Uniformity of Magnification from Different Electron Microscopes

1967 ◽  
Vol 25 ◽  
pp. 32-33
Author(s):  
Godfrey C. Hoskins ◽  
V. Williams ◽  
V. Allison
Keyword(s):  
Diffraction Grating ◽  
The Other ◽  
Carbon Replica ◽  
Electron Microscopes ◽  
The Stability

The method demonstrated is an adaptation of a proven procedure for accurately determining the magnification of light photomicrographs. Because of the stability of modern electrical lenses, the method is shown to be directly applicable for providing precise reproducibility of magnification in various models of electron microscopes.A readily recognizable area of a carbon replica of a crossed-line diffraction grating is used as a standard. The same area of the standard was photographed in Phillips EM 200, Hitachi HU-11B2, and RCA EMU 3F electron microscopes at taps representative of the range of magnification of each. Negatives from one microscope were selected as guides and printed at convenient magnifications; then negatives from each of the other microscopes were projected to register with these prints. By deferring measurement to the print rather than comparing negatives, correspondence of magnification of the specimen in the three microscopes could be brought to within 2%.

Effect of Improved ThO2 Particle Dispersion in Nickel on High-Temperature Strength

1970 ◽  
Vol 28 ◽  
pp. 444-445
Author(s):  
E. R. Kimmel ◽  
H. L. Anthony ◽  
W. Scheithauer
Keyword(s):  
High Temperature ◽  
Metal Matrix ◽  
Oxide Particle ◽  
Oxide Phase ◽  
Dislocation Motion ◽  
Particle Dispersion ◽  
High Temperature Strength ◽  
Strengthening Effect ◽  
Oxide Particles ◽  
The Stability

The strengthening effect at high temperature produced by a dispersed oxide phase in a metal matrix is seemingly dependent on at least two major contributors: oxide particle size and spatial distribution, and stability of the worked microstructure. These two are strongly interrelated. The stability of the microstructure is produced by polygonization of the worked structure forming low angle cell boundaries which become anchored by the dispersed oxide particles. The effect of the particles on strength is therefore twofold, in that they stabilize the worked microstructure and also hinder dislocation motion during loading.

An Analysis of Dissociation of Molecules in a High Resolution Electron Microscope

1973 ◽  
Vol 31 ◽  
pp. 486-487
Author(s):  
Mihir Parikh
Keyword(s):  
Electron Microscope ◽  
High Resolution ◽  
Cross Sections ◽  
Resolving Power ◽  
Peak Intensity ◽  
Molecular Film ◽  
Resolution Electron ◽  
Dissociation Cross Section ◽  
High Resolution Electron Microscope ◽  
The Stability

It is well known that the resolution of bio-molecules in a high resolution electron microscope depends not just on the physical resolving power of the instrument, but also on the stability of these molecules under the electron beam. Experimentally, the damage to the bio-molecules is commo ly monitored by the decrease in the intensity of the diffraction pattern, or more quantitatively by the decrease in the peaks of an energy loss spectrum. In the latter case the exposure, EC, to decrease the peak intensity from IO to I’O can be related to the molecular dissociation cross-section, σD, by EC = ℓn(IO /I’O) /ℓD. Qu ntitative data on damage cross-sections are just being reported, However, the microscopist needs to know the explicit dependence of damage on: (1) the molecular properties, (2) the density and characteristics of the molecular film and that of the support film, if any, (3) the temperature of the molecular film and (4) certain characteristics of the electron microscope used

Formation and Structure of Casein Micelles in Lactating Mammary Tissue

1970 ◽  
Vol 28 ◽  
pp. 150-151
Author(s):  
Robert J. Carroll ◽  
Marvin P. Thompson ◽  
Harold M. Farrell
Keyword(s):  
Size Distribution ◽  
G Protein ◽  
Milk Proteins ◽  
Mammary Tissue ◽  
Colloidal System ◽  
Casein Micelles ◽  
The Stability

Milk is an unusually stable colloidal system; the stability of this system is due primarily to the formation of micelles by the major milk proteins, the caseins. Numerous models for the structure of casein micelles have been proposed; these models have been formulated on the basis of in vitro studies. Synthetic casein micelles (i.e., those formed by mixing the purified αsl- and k-caseins with Ca2+ in appropriate ratios) are dissimilar to those from freshly-drawn milks in (i) size distribution, (ii) ratio of Ca/P, and (iii) solvation (g. water/g. protein). Evidently, in vivo organization of the caseins into the micellar form occurs in-a manner which is not identical to the in vitro mode of formation.

TEM Analysis of Long-Period Polytypes in SiC—S

1976 ◽  
Vol 34 ◽  
pp. 630-631
Author(s):  
S. Shinozaki ◽  
J. W. Sprys
Keyword(s):  
Electron Diffraction ◽  
Isothermal Annealing ◽  
Tem Analysis ◽  
Long Period ◽  
Transmission Electron ◽  
Average Grain Size ◽  
High Resolution Tem ◽  
Structural Lattice ◽  
The Stability ◽  
Continuous Curves

In reaction sintered SiC (∽ 5um average grain size), about 15% of the grains were found to have long-period structures, which were identifiable by transmission electron microscopy (TEM). In order to investigate the stability of the long-period polytypes at high temperature, crystal structures as well as microstructural changes in the long-period polytypes were analyzed as a function of time in isothermal annealing.Each polytype was analyzed by two methods: (1) Electron diffraction, and (2) Electron micrograph analysis. Fig. 1 shows microdensitometer traces of ED patterns (continuous curves) and calculated intensities (vertical lines) along 10.l row for 6H and 84R (Ramsdell notation). Intensity distributions were calculated based on the Zhdanov notation of (33) for 6H and [ (33)3 (32)2 ]3 for 84R. Because of the dynamical effect in electron diffraction, the observed intensities do not exactly coincide with those intensities obtained by structure factor calculations. Fig. 2 shows the high resolution TEM micrographs, where the striped patterns correspond to direct resolution of the structural lattice periodicities of 6H and 84R structures and the spacings shown in the figures are as expected for those structures.

Field Distribution of Strongly Excited Magnetic Lenses

1975 ◽  
Vol 33 ◽  
pp. 140-141
Author(s):  
M. Strojnik
Keyword(s):  
Flux Density ◽  
Field Distribution ◽  
Optical Axis ◽  
Operating Point ◽  
Pole Piece ◽  
Partial Saturation ◽  
Axial Flux ◽  
The Stability

Magnetic lenses operating in partial saturation offer two advantages in HVEM: they exhibit small cs and cc and their power depends little on the excitation IN. Curve H, Fig. 1, shows that the maximal axial flux density Bz max of one of the lenses investigated changes between points (3) and (4) by 5% as the excitation varies by 40%. Consequently, the designer can relax the requirements concerning the stability of the lens current supplies. Saturated lenses, however, can only be used if (i) unwanted fields along the optical axis can be controlled, (ii) 'wobbling' of the optical axis due to inhomogeneous saturation around the pole piece faces is prevented, (iii) ample ampere-turns can be squeezed into the space available, and (iv) the lens operating point covers a sufficient range of accelerating voltages.

Sign in / Sign up

Export Citation Format

Share Document