scholarly journals Depolarization current relaxation process of insulating dielectrics after corona poling under different charging conditions

AIP Advances ◽  
2017 ◽  
Vol 7 (10) ◽  
pp. 105201
Author(s):  
J. W. Zhang ◽  
T. C. Zhou ◽  
J. X. Wang ◽  
X. F. Yang ◽  
F. Zhu ◽  
...  
Keyword(s):  
Relaxation Process ◽  
Depolarization Current ◽  
Corona Poling ◽  
Current Relaxation

UHV-STM studies of silicon nano-pyramid growth on silicon surface at high temperature

1992 ◽  
Vol 50 (2) ◽  
pp. 1144-1145
Author(s):  
T. Sato ◽  
S. Kitamura ◽  
T. Sueyoshl ◽  
M. Iwatukl ◽  
C. Nielsen
Keyword(s):  
High Temperature ◽  
Relaxation Process ◽  
Thermal Effect ◽  
Bias Voltage ◽  
Silicon Surface ◽  
Growth Process ◽  
Tunneling Current ◽  
Fabrication Technique ◽  
Nano Fabrication ◽  
Electromigration Effect

Recently, the growth process and relaxation process of crystalline structures were studied by observing a SI nano-pyramid which was built on a Si surface with a UHV-STM. A UHV-STM (JEOL JSTM-4000×V) was used for studying a heated specimen, and the specimen was kept at high temperature during observation. In this study, the nano-fabrication technique utilizing the electromigration effect between the STM tip and the specimen was applied. We observed Si atoms migrated towords the tip on a high temperature Si surface.Clean surfaces of Si(lll)7×7 and Si(001)2×l were prepared In the UHV-STM at a temperature of approximately 600 °C. A Si nano-pyramid was built on the Si surface at a tunneling current of l0nA and a specimen bias voltage of approximately 0V in both polarities. During the formation of the pyramid, Images could not be observed because the tip was stopped on the sample. After the formation was completed, the pyramid Image was observed with the same tip. After Imaging was started again, the relaxation process of the pyramid started due to thermal effect.

Dielectric Relaxation Studies of Silver Nanoparticles dispersed Liquid Crystal

2015 ◽  
Vol 8 (3) ◽  
pp. 2176-2188 ◽  
Author(s):  
Keisham Nanao Singh
Keyword(s):  
Activation Energy ◽  
Silver Nanoparticles ◽  
Liquid Crystal ◽  
Dielectric Relaxation ◽  
Relaxation Process ◽  
Relaxation Times ◽  
Low Frequency ◽  
Bulk Liquid ◽  
Molecular Rearrangement ◽  
Relaxation Studies

This article reports on the Dielectric Relaxation Studies of two Liquid Crystalline compounds - 7O.4 and 7O.6 - doped with dodecanethiol capped Silver Nanoparticles. The liquid crystal molecules are aligned homeotropically using CTAB. The low frequency relaxation process occurring above 1 MHz is fitted to Cole-Cole formula using the software Dielectric Spectra fit. The effect of the Silver Nanoparticles on the molecular dipole dynamics are discussed in terms of the fitted relaxation times, Cole-Cole distribution parameter and activation energy. The study indicate a local molecular rearrangement of the liquid crystal molecules without affecting the order of the bulk liquid crystal molecules but these local molecules surrounding the Silver Nanoparticles do not contribute to the relaxation process in the studied frequency range. The observed effect on activation energy suggests a change in interaction between the nanoparticles/liquid crystal molecules.

scholarly journals PVDF-HFP/NKBT composite dielectrics: Perovskite particles induce the appearance of an additional dielectric relaxation process in ferroelectric polymer matrix

2021 ◽  
Vol 96 ◽  
pp. 107093
Author(s):  
Vera P. Pavlović ◽  
Dragana Tošić ◽  
Radovan Dojčilović ◽  
Duško Dudić ◽  
Miroslav D. Dramićanin ◽  
...  
Keyword(s):  
Dielectric Relaxation ◽  
Relaxation Process ◽  
Polymer Matrix ◽  
Dielectric Relaxation Process ◽  
Ferroelectric Polymer

scholarly journals Assessment of Thermal aging degree of 10kV Cross-linked polyethylene Cable based on Depolarization current

IEEE Access ◽  
2021 ◽  
pp. 1-1
Author(s):  
Yi-Yi Zhang ◽  
Feng-Yu Jiang ◽  
Xiao-Yong Yu ◽  
Ke Zhou ◽  
Wei Zhang ◽  
...  
Keyword(s):  
Thermal Aging ◽  
Depolarization Current

scholarly journals Research on the Time-Domain Dielectric Response of Multiple Impulse Voltage Aging Oil-Film Dielectrics

Energies ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1948
Author(s):  
Chenmeng Zhang ◽  
Kailin Zhao ◽  
Shijun Xie ◽  
Can Hu ◽  
Yu Zhang ◽  
...  
Keyword(s):  
Time Domain ◽  
Dielectric Response ◽  
Early Stage ◽  
Debye Model ◽  
Polarization Current ◽  
Depolarization Current ◽  
Oil Film ◽  
Impulse Voltage ◽  
The Time Domain ◽  
Film Dielectric

Power capacitors suffer multiple impulse voltages during their lifetime. With the multiple impulse voltage aging, the internal insulation, oil-film dielectric may deteriorate and even fail in the early stage, which is called accumulative effect. Hence, the time-domain dielectric response of oil-film dielectric with multiple impulse voltage aging is studied in this paper. At first, the procedure of the preparation of the tested samples were introduced. Secondly, an aging platform, impulse voltage generator was built to test the accumulative effect of capacitor under multiple impulse voltage. Then, a device was used to test the time-domain dielectric response (polarization depolarization current, PDC) of oil-film dielectric in different aging states. And finally, according to the PDC data, extended Debye model and characteristic parameters were obtained by matrix pencil algorithm identification. The results indicated that with the increase of impulse voltage times, the time-domain dielectric response of oil-film dielectric changed accordingly. The polarization current curve moved up gradually, the insulation resistance decreased when subjected to the repeated impulses. In frequency domain, the frequency spectrum of tan δ changed along with the impulse accumulation aging, especially at low frequency. At last, combined with the aging mechanism of oil-film dielectric under multiple impulse voltage, the test results were discussed.

scholarly journals Flexible Multiscale Pore Hybrid Self-Powered Sensor for Heart Sound Detection

Sensors ◽  
2021 ◽  
Vol 21 (13) ◽  
pp. 4508
Author(s):  
Boyan Liu ◽  
Liuyang Han ◽  
Lyuming Pan ◽  
Hongzheng Li ◽  
Jingjing Zhao ◽  
...  
Keyword(s):  
Piezoelectric Coefficient ◽  
Heart Sound ◽  
Piezoelectric Materials ◽  
Ferroelectric Material ◽  
Flexible Sensor ◽  
Β Phase ◽  
Short Processing Time ◽  
Sound Detection ◽  
Corona Poling ◽  
Self Powered

This research introduces an idea of producing both nanoscale and microscale pores in piezoelectric material, and combining the properties of the molecular β-phase dipoles in ferroelectric material and the space charge dipoles in order to increase the sensitivity of the sensor and modulate the response frequency bandwidth of the material. Based on this idea, a bi-nano-micro porous dual ferro-electret hybrid self-powered flexible heart sound detection sensor is proposed. Acid etching and electrospinning were the fabrication processes used to produce a piezoelectric film with nanoscale and microscale pores, and corona poling was used for air ionization to produce an electret effect. In this paper, the manufacturing process of the sensor is introduced, and the effect of the porous structure and corona poling on improving the performance of the sensor is discussed. The proposed flexible sensor has an equivalent piezoelectric coefficient d33 of 3312 pC/N, which is much larger than the piezoelectric coefficient of the common piezoelectric materials. Experiments were carried out to verify the function of the flexible sensor together with the SS17L heart sound sensor (BIOPAC, Goleta, CA, USA) as a reference. The test results demonstrated its practical application for wearable heart sound detection and the potential for heart disease detection. The proposed flexible sensor in this paper could realize batch production, and has the advantages of flexibility, low production cost and a short processing time compared with the existing heart sound detection sensors.

scholarly journals The Structure and Magnetic Properties of Rapidly Quenched Fe72Ni8Nb4Si2B14 Alloy

Materials ◽  
2020 ◽  
Vol 14 (1) ◽  
pp. 5
Author(s):  
Lukasz Hawelek ◽  
Tymon Warski ◽  
Patryk Wlodarczyk ◽  
Marcin Polak ◽  
Przemyslaw Zackiewicz ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Relaxation Process ◽  
Glassy State ◽  
Diffraction Method ◽  
Soft Magnetic Materials ◽  
Process Time ◽  
Complex Permeability ◽  
Soft Magnetic ◽  
Conventional Heat Treatment ◽  
Glass Relaxation

The complex structural and magnetic studies of the annealed rapidly quenched Cu-free Fe72Ni8Nb4Si2B14 alloy (metallic ribbons form) are reported here. Based on the calorimetric results, the conventional heat treatment process (with heating rate 10 °C/min and subsequent isothermal annealing for 20 min) for wound toroidal cores has been optimized to obtain the least lossy magnetic properties (for the minimum value of coercivity and magnetic core losses at 50 Hz). For optimal conditions, the complex permeability in the 104–108 Hz frequency range together with core power losses obtained from magnetic induction dependence up to the frequency of 400 kHz was successfully measured. The average and local crystal structure was investigated by the use of the X-ray diffraction method and the transmission electron microscopy observations and proved its fully glassy state. Additionally, for the three temperature values, i.e., 310, 340 and 370 °C, the glass relaxation process study in the function of annealing time was carried out to obtain a deeper insight into the soft magnetic properties: magnetic permeability and cut-off frequency. For this type of Cu-free soft magnetic materials, the control of glass relaxation process (time and temperature) is extremely important to obtain proper magnetic properties.

Sign in / Sign up

Export Citation Format

Share Document