Developing of an environmental cell TEM holder for dynamicin situobservation

2016 ◽  
Vol 87 (2) ◽  
pp. 023705 ◽  
Author(s):  
Khaled M. Bataineh
Keyword(s):  
Environmental Cell

Cathodoluminescence of Catalyst Crystallites

1982 ◽  
Vol 40 ◽  
pp. 664-665
Author(s):  
E.D. Boyes ◽  
P.L. Gai ◽  
D.B. Darby ◽  
C. Warwick
Keyword(s):  
Defect Density ◽  
Chemical Properties ◽  
Operating Conditions ◽  
Semiconductor Materials ◽  
Environmental Cell ◽  
High Resolution Structure ◽  
Commercially Important ◽  
Crystallographic Defects ◽  
Resolution Structure

The extended crystallographic defects introduced into some oxide catalysts under operating conditions may be a consequence and accommodation of the changes produced by the catalytic activity, rather than always being the origin of the reactivity. Operation without such defects has been established for the commercially important tellurium molybdate system. in addition it is clear that the point defect density and the electronic structure can both have a significant influence on the chemical properties and hence on the effectiveness (activity and selectivity) of the material as a catalyst. SEM/probe techniques more commonly applied to semiconductor materials, have been investigated to supplement the information obtained from in-situ environmental cell HVEM, ultra-high resolution structure imaging and more conventional AEM and EPMA chemical microanalysis.

An Environmental Wet Cell For High Voltage Electron Microscopy

1973 ◽  
Vol 31 ◽  
pp. 18-19
Author(s):  
N.J. Tighe ◽  
H.M. Flower ◽  
P.R. Swann
Keyword(s):  
Electron Microscopy ◽  
High Temperature ◽  
Image Quality ◽  
Inelastic Scattering ◽  
High Voltage ◽  
High Voltage Electron Microscopy ◽  
Voltage Electron ◽  
Environmental Cell ◽  
Water Saturated ◽  
High Temperature Gas

A differentially pumped environmental cell has been developed for use in the AEI EM7 million volt microscope. In the initial version the column of gas traversed by the beam was 5.5mm. This permited inclusion of a tilting hot stage in the cell for investigating high temperature gas-specimen reactions. In order to examine specimens in the wet state it was found that a pressure of approximately 400 torr of water saturated helium was needed around the specimen to prevent dehydration. Inelastic scattering by the water resulted in a sharp loss of image quality. Therefore a modified cell with an ‘airgap’ of only 1.5mm has been constructed. The shorter electron path through the gas permits examination of specimens at the necessary pressure of moist helium; the specimen can still be tilted about the side entry rod axis by ±7°C to obtain stereopairs.

Hydrated form of some clay minerals observed using a film sealed environmental cell

1978 ◽  
Vol 36 (1) ◽  
pp. 72-73
Author(s):  
N. Kohyama ◽  
K. Fukushima ◽  
A. Fukami
Keyword(s):  
Clay Minerals ◽  
Morphological Changes ◽  
Carbon Film ◽  
Electron Microscopic Observation ◽  
Adsorbed Water ◽  
Electron Microscopic ◽  
Hydrated Form ◽  
Thin Carbon ◽  
Environmental Cell ◽  
Thin Carbon Film

Since the interlayer or adsorbed water of some clay minerals are quite easily dehydrated in dried air, in vacuum, or at moderate temperatures even in the atmosphere, the hydrated forms have not been observed by a conventional electron microscope(TEM). Recently, specific specimen chambers, “environmental cells(E.C.),” have been developed and confirmed to be effective for electron microscopic observation of wet specimen without dehydration. we observed hydrated forms of some clay minerals and their morphological changes by dehydration using a TEM equipped with an E.C..The E.C., equipped with a single hole copper-microgrid sealed by thin carbon-film, attaches to a TEM(JEM 7A) with an accelerating voltage 100KV and both gas pressure (from 760 Torr to vacuum) and relative humidity can be controlled. The samples collected from various localities in Japan were; tubular halloysite (l0Å) from Gumma Prefecture, sperical halloysite (l0Å) from Tochigi Pref., and intermediate halloysite containing both tubular and spherical types from Fukushima Pref..

Contrast and Resolution in Alfresco Microscopy and Thick Specimens

1972 ◽  
Vol 30 ◽  
pp. 570-571
Author(s):  
J. R. Sellar ◽  
J. M. Cowley
Keyword(s):  
Solid Material ◽  
Cell Design ◽  
Current Interest ◽  
High Voltage Electron Microscopy ◽  
Voltage Electron ◽  
Transmission Electron ◽  
Environmental Cell ◽  
Scanning Transmission ◽  
Conventional Transmission Electron Microscope ◽  
Transmission Microscope

Current interest in high voltage electron microscopy, especially in the scanning mode, has prompted the development of a method for determining the contrast and resolution of images of specimens in controlled-atmosphere stages or open to the air, hydrated biological specimens being a good example. Such a method would be of use in the prediction of microscope performance and in the subsequent optimization of environmental cell design for given circumstances of accelerating voltage, cell gas pressure and constitution, and desired resolution.Fig. 1 depicts the alfresco cell of a focussed scanning transmission microscope with a layer of gas L (and possibly a thin window W) between the objective O and specimen T. Using the principle of reciprocity, it may be considered optically equivalent to a conventional transmission electron microscope, if the beams were reversed. The layer of gas or solid material after the specimen in the STEM or before the specimen in TEM has no great effect on resolution or contrast and so is ignored here.

In situ study of electron beam-induced chemical vapor deposition of Au in an environmental TEM

1995 ◽  
Vol 53 ◽  
pp. 256-257
Author(s):  
J. Drucker ◽  
R. Sharma ◽  
J. Kouvetakis ◽  
K.H.J. Weiss
Keyword(s):  
Electron Beam ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Quantum Effect ◽  
Line Drawing ◽  
Chemical Vapor ◽  
Environmental Cell ◽  
Engineering Changes ◽  
Kinetics Of

Patterning of metals is a key element in the fabrication of integrated microelectronics. For circuit repair and engineering changes constructive lithography, writing techniques, based on electron, ion or photon beam-induced decomposition of precursor molecule and its deposition on top of a structure have gained wide acceptance Recently, scanning probe techniques have been used for line drawing and wire growth of W on a silicon substrate for quantum effect devices. The kinetics of electron beam induced W deposition from WF6 gas has been studied by adsorbing the gas on SiO2 surface and measuring the growth in a TEM for various exposure times. Our environmental cell allows us to control not only electron exposure time but also the gas pressure flow and the temperature. We have studied the growth kinetics of Au Chemical vapor deposition (CVD), in situ, at different temperatures with/without the electron beam on highly clean Si surfaces in an environmental cell fitted inside a TEM column.

Environmental cell studies of deformation and fracture

1990 ◽  
Vol 48 (4) ◽  
pp. 516-517
Author(s):  
H. K. Birnbaum ◽  
I. M. Robertson
Keyword(s):  
National Laboratory ◽  
Argonne National Laboratory ◽  
Damage Threshold ◽  
Chromatic Aberration ◽  
Good Choice ◽  
Point Of View ◽  
Deformation And Fracture ◽  
Environmental Cell ◽  
Gas Molecules ◽  
The University

Studies of the effects of hydrogen environments on the deformation and fracture of fcc, bcc and hep metals and alloys have been carried out in a TEM environmental cell. The initial experiments were performed in the environmental cell of the HVEM facility at Argonne National Laboratory. More recently, a dedicated environmental cell facility has been constructed at the University of Illinois using a JEOL 4000EX and has been used for these studies. In the present paper we will describe the general design features of the JEOL environmental cell and some of the observations we have made on hydrogen effects on deformation and fracture.The JEOL environmental cell is designed to operate at 400 keV and below; in part because of the available accelerating voltage of the microscope and in part because the damage threshold of most materials is below 400 keV. The gas pressure at which chromatic aberration due to electron scattering from the gas molecules becomes excessive does not increase rapidly with with accelerating voltage making 400 keV a good choice from that point of view as well. A series of apertures were placed above and below the cell to control the pressures in various parts of the column.

In-Situ Observation of Clay Minerals Hydrated and Intercalated With Liquid Chemicals Using Film-Sealed Environmental Cell

1980 ◽  
Vol 38 ◽  
pp. 208-209 ◽  
Author(s):  
K. Fukushima ◽  
N. Kohyama ◽  
A. Fukami
Keyword(s):  
Carbon Film ◽  
Resolving Power ◽  
In Situ Observation ◽  
Interlayer Water ◽  
Saturated Water ◽  
Structure Changes ◽  
Environmental Cell ◽  
Gas Layer ◽  
20 Nm

A film-sealed high resolution environmental cell(E.C) for observing hydrated materials had been developed by us(l). Main specification of the E.C. is as follows: 1) Accelerated voltage; 100 kV. 2) Gas in the E.C.; saturated water vapour with carrier gas of 50 Torr. 3) Thickness of gas layer; 50 μm. 4) Sealing film; evaporated carbon film(20 nm thick) with plastic microgrid. 5) Resolving power; 1 nm. 6) Transmittance of electron beam; 60% at 100 kV. The E.C. had been successfully applied to the study of hydrated halloysite(2) (3). Kaolin minerals have no interlayer water and are basically non-expandable but form intercalation compounds with some specific chemicals such as hydrazine, formamide and etc. Because of these compounds being mostly changed in vacuum, we tried to reveal the structure changes between in wet air and in vacuum of kaolin minerals intercalated with hydrazine and of hydrated state of montmori1lonite using the E.C. developed by us.

scholarly journals Sealed Environmental Cell Microscopy

2003 ◽  
Vol 9 (S02) ◽  
pp. 902-903 ◽  
Author(s):  
Hiromi Konishi ◽  
Akira Ishikawa ◽  
Ying-Bing Jiang ◽  
Peter Buseck ◽  
Huifang Xu
Keyword(s):  
Environmental Cell ◽  
Cell Microscopy
Sign in / Sign up

Export Citation Format

Share Document