A binary mixture of monodisperse polymers of fixed architectures, and the critical and the theta states

1998 ◽  
Vol 108 (12) ◽  
pp. 5104-5121 ◽  
Author(s):  
P. D. Gujrati
Keyword(s):  
Binary Mixture ◽  
Monodisperse Polymers

Solidification of a binary mixture in a shear flow

2002 ◽  
Author(s):  
Sophie Mergui ◽  
Boubaker Feroual ◽  
Christine Benard ◽  
Dominique Gobin
Keyword(s):  
Shear Flow ◽  
Binary Mixture

EXPERIMENTAL STUDY OF A BINARY MIXTURE OF RICE HUSK AND SAND IN A FLUIDIZED BED

2019 ◽  
Author(s):  
Fernando Manente Perrella Balestieri ◽  
Carlos Manuel Romero Luna ◽  
Ivonete Ávila
Keyword(s):  
Experimental Study ◽  
Binary Mixture ◽  
Fluidized Bed ◽  
Rice Husk

scholarly journals Density Measurements of an Air-Like Binary Mixture over the Temperature Range from 100 K to 298.15 K at Pressures up to 8.0 MPa

2021 ◽  
Vol 42 (9) ◽  
Author(s):  
Nils von Preetzmann ◽  
Reiner Kleinrahm ◽  
Philipp Eckmann ◽  
Giuseppe Cavuoto ◽  
Markus Richter
Keyword(s):  
Binary Mixture ◽  
Saturated Vapor ◽  
Saturation Pressure ◽  
Transmission Error ◽  
Magnetic Suspension ◽  
Mixture Component ◽  
Liquid Region ◽  
Force Transmission ◽  
Temperature Range ◽  
Combined Uncertainty

AbstractDensities of an air-like binary mixture (0.2094 oxygen + 0.7906 nitrogen, mole fractions) were measured along six isotherms over the temperature range from 100 K to 298.15 K at pressures up to 8.0 MPa, using a low-temperature single-sinker magnetic suspension densimeter. The measurements were carried out at T = (100, 115, and 130) K in the homogeneous gas and liquid region, and at T = (145, 220, and 298.15) K in the supercritical region (critical temperature TC = 132.35 K); in total, we present results for 52 (T, p) state points. The relative expanded combined uncertainty (k = 2) of the experimental densities was estimated to be between 0.03 % and 0.13 %, except for four values near the critical point. The largest error is caused by the magnetic suspension coupling in combination with the mixture component oxygen, which is strongly paramagnetic; the resulting force transmission error is up to 1.1 %. However, this error can be corrected with a proven correction model to an uncertainty contribution in density of less than 0.044 %. Due to a supercritical liquefaction procedure and the integration of a special VLE-cell, it was possible to measure densities in the homogeneous liquid phase without changing the composition of the liquefied mixture. Moreover, saturated liquid and saturated vapor densities were determined at T = (100, 115, and 130) K by extrapolation of the experimental single-phase densities to the saturation pressure. The new experimental results were compared with the mixture model of Lemmon et al. for the system (nitrogen + argon + oxygen) and the GERG-2008 equation of state.

Influences of composition and temperature on the behaviors of a binary mixture containing methanol and 1-ethylimidazole

2021 ◽  
Vol 330 ◽  
pp. 115503
Author(s):  
Xinzi Zhou ◽  
Haiyun Hou ◽  
Junru Wang ◽  
Luohong Zhang ◽  
Haojun Shi ◽  
...  
Keyword(s):  
Binary Mixture
Sign in / Sign up

Export Citation Format

Share Document