Some Considerations On Photocurrent Characteristics Of Poly(alkylthiophene) And Photovoltaic Characteristics Of Poly(alkylthiophene)∕ZnO Based Hybrid Solar Cells

2010 ◽  
Author(s):  
Rahmat Hidayat ◽  
Annisa Aprilia ◽  
Herman Bahar ◽  
Bambang Prijamboedi ◽  
Khairurrijal ◽  
...  
RSC Advances ◽  
2016 ◽  
Vol 6 (91) ◽  
pp. 88443-88443 ◽  
Author(s):  
L. Z. Hao ◽  
Y. J. Liu ◽  
W. Gao ◽  
Y. M. Liu ◽  
Z. D. Han ◽  
...  

Correction for ‘Enhanced photovoltaic characteristics of MoS2/Si hybrid solar cells by metal Pd chemical doping’ by L. Z. Hao et al., RSC Adv., 2016, 6, 1346–1350.


RSC Advances ◽  
2016 ◽  
Vol 6 (2) ◽  
pp. 1346-1350 ◽  
Author(s):  
L. Z. Hao ◽  
Y. J. Liu ◽  
W. Gao ◽  
Y. M. Liu ◽  
Z. D. Han ◽  
...  

MoS2/Si hybrid solar cells are fabricated and the device performances are improved via Pd chemical doping. Due to the incorporation of the Pd atoms, the photovoltaic characteristics of the fabricated Pd:MoS2/Si solar cell are enhanced significantly.


2015 ◽  
Vol 827 ◽  
pp. 162-167 ◽  
Author(s):  
Rahmat Hidayat ◽  
Yolla Sukma Handayani ◽  
Priastuti Wulandari

Organic solar cells have been much studied because of the simplicity in their fabrication process in comparison to solar cells based on crystalline inorganic semiconductors. However, the actual power conversion efficiency is still much lower than the theoretical prediction, which may indicate the effect of inefficient charge transfer or charge recombination loss inside the cell. We have studied the photovoltaic characteristics of hybrid solar cells with transition metal doped ZnO layer as electron transport layers. Under dark condition, their J-V curves show a deviation from an ideal diode characteristic, which is indicated by current flow below the threshold voltage. Further investigations to clarify the photovoltaic characteristics of those cells were then carried out by the measurements of impedance spectroscopy. The impedance characteristics are dependent on the transport layer used, where the Nyquist plots of cells with TiZO exhibit larger impedance than those of cells with ZnO. However, those cells with larger impedance show better working performances. This fact was then interpreted as the result from smaller interfacial charge transfer loss, which may take place via charge carrier recombination at the interface of the transport layer and active layer, in the cells with TiZO.


2012 ◽  
Vol 2 (2) ◽  
pp. 147-167
Author(s):  
Xuehua Zhang ◽  
Yujing Xia ◽  
Xuemin Li ◽  
Tao He

2012 ◽  
Vol 571 ◽  
pp. 120-124
Author(s):  
Liang Min Zhang

Hybrid photovoltaic concepts based on a nanoscale combination of organic and inorganic semiconductors are promising way to enhance the cost efficiency of solar cells through a better use of the solar spectrum, a higher ratio of interface-to-volume, and the flexible processability of polymers. In this work, two types of thin film solar cells have been developed. In both types of solar cells, poly-N-vinylcarbazole (PVK) is used as electron donor, cadmium sulfide (CdS) and titanium dioxide (TiO2) nanocrystals are used as electron acceptors, respectively. Since TiO2 has a wide band gap and can only absorb UV light, in the second type of solar cell, ruthenium dye is used as photo-sensitizer. The preliminary results of photoconductive and photovoltaic characteristics of these two inorganic-organic composites are presented.


2018 ◽  
Vol 1 (9) ◽  
pp. 4899-4905
Author(s):  
Bingbing Chen ◽  
Jianhui Chen ◽  
Kunpeng Ge ◽  
Linlin Yang ◽  
Yanjiao Shen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document