A temperature dependent simulation of the x‐ray powder spectrum of ice Ih using Metropolis Monte Carlo sampling

1986 ◽  
Vol 85 (8) ◽  
pp. 4660-4666 ◽  
Author(s):  
Peter W. Deutsch ◽  
Tom D. Stanik
Keyword(s):  
Monte Carlo ◽  
Monte Carlo Sampling ◽  
Temperature Dependent ◽  
Powder Spectrum ◽  
X Ray ◽  
Metropolis Monte Carlo

scholarly journals Metropolis Monte Carlo simulation scheme for fast scattered X-ray photon calculation in CT

2019 ◽  
Vol 27 (2) ◽  
pp. 1262 ◽  
Author(s):  
Yuan Xu ◽  
Yusi Chen ◽  
Zhen Tian ◽  
Xun Jia ◽  
Linghong Zhou
Keyword(s):  
Monte Carlo Simulation ◽  
Monte Carlo ◽  
X Ray ◽  
Metropolis Monte Carlo ◽  
Simulation Scheme ◽  
Metropolis Monte Carlo Simulation

Determination of Stoichiometry of GaAs Component in (Gaas)Ge Epitaxially Grown Thin Films by Electron Microprobe X-Ray Analysis

1990 ◽  
Vol 48 (2) ◽  
pp. 264-265
Author(s):  
D. R. Liu ◽  
S. S. Shinozaki ◽  
R. J. Baird
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Monte Carlo Simulation ◽  
Monte Carlo ◽  
Compound Semiconductors ◽  
Energy Dispersive Analysis ◽  
X Ray ◽  
Metastable Alloys ◽  
Lower Voltage

The epitaxially grown (GaAs)Ge thin film has been arousing much interest because it is one of metastable alloys of III-V compound semiconductors with germanium and a possible candidate in optoelectronic applications. It is important to be able to accurately determine the composition of the film, particularly whether or not the GaAs component is in stoichiometry, but x-ray energy dispersive analysis (EDS) cannot meet this need. The thickness of the film is usually about 0.5-1.5 μm. If Kα peaks are used for quantification, the accelerating voltage must be more than 10 kV in order for these peaks to be excited. Under this voltage, the generation depth of x-ray photons approaches 1 μm, as evidenced by a Monte Carlo simulation and actual x-ray intensity measurement as discussed below. If a lower voltage is used to reduce the generation depth, their L peaks have to be used. But these L peaks actually are merged as one big hump simply because the atomic numbers of these three elements are relatively small and close together, and the EDS energy resolution is limited.

Low-voltage EDS of magnesium ferrite Dendrites in a FEG-SEM

1996 ◽  
Vol 54 ◽  
pp. 478-479
Author(s):  
Matthew T. Johnson ◽  
Ian M. Anderson ◽  
Jim Bentley ◽  
C. Barry Carter
Keyword(s):  
Monte Carlo ◽  
Quantitative Analysis ◽  
Monte Carlo Simulations ◽  
Cross Section ◽  
Spatial Resolution ◽  
Low Voltage ◽  
Magnesium Ferrite ◽  
X Ray ◽  
Interaction Volume ◽  
Ferrite Spinel

Energy-dispersive X-ray spectrometry (EDS) performed at low (≤ 5 kV) accelerating voltages in the SEM has the potential for providing quantitative microanalytical information with a spatial resolution of ∼100 nm. In the present work, EDS analyses were performed on magnesium ferrite spinel [(MgxFe1−x)Fe2O4] dendrites embedded in a MgO matrix, as shown in Fig. 1. spatial resolution of X-ray microanalysis at conventional accelerating voltages is insufficient for the quantitative analysis of these dendrites, which have widths of the order of a few hundred nanometers, without deconvolution of contributions from the MgO matrix. However, Monte Carlo simulations indicate that the interaction volume for MgFe2O4 is ∼150 nm at 3 kV accelerating voltage and therefore sufficient to analyze the dendrites without matrix contributions.Single-crystal {001}-oriented MgO was reacted with hematite (Fe2O3) powder for 6 h at 1450°C in air and furnace cooled. The specimen was then cleaved to expose a clean cross-section suitable for microanalysis.

Sign in / Sign up

Export Citation Format

Share Document