Drift tube investigation of the reactions H++D2→HD+D+ and  D++H2→HD+H+ in the relative energy range 0.04–0.3 eV

1982 ◽  
Vol 76 (3) ◽  
pp. 1590-1591 ◽  
Author(s):  
H. Villinger ◽  
M. J. Henchman ◽  
W. Lindinger
Keyword(s):  
Energy Range ◽  
Drift Tube ◽  
Relative Energy

scholarly journals Beam dynamics design of an energy-variable superconducting heavy ion accelerator

2021 ◽  
Author(s):  
◽  
Malte Alexander Schwarz
Keyword(s):  
Energy Range ◽  
Linear Accelerator ◽  
Drift Tube ◽  
Heavy Ion ◽  
Beam Dynamics ◽  
Heavy Elements ◽  
Output Energy ◽  
Transverse Beam ◽  
High Charge ◽  
Cw Operation

This dissertation describes the development of the beam dynamics design of a novel superconducting linear accelerator. At a main operating frequency of 216.816 MHz, ions with a mass-to-charge ratio of up to 6 can be accelerated at high duty cycles up to CW operation. Intended for construction at the GSI Helmholtz Centre for Heavy Ion Research in Darmstadt, the focus of the work is on the beam dynamic design of the accelerator section downstream of the high charge injector (HLI) at an injection energy of 1.39 MeV/u. An essential feature of this linear accelerator (Linac) is the use of the EQUUS (Equidistant Multigap Structure) beam dynamics concept for a variably adjustable output energy between 3.5 and 7.3 MeV/u (corresponding to about 12.4 % of the speed of light) with a required low energy spread of maximum 3 keV/u. The GSI Helmholtz Centre for Heavy Ion Research is a large-scale research facility that uses its particle accelerators to perform basic research with ion beams. Research on super-heavy elements ("SHE") is a major focus. It is expected that their production and research will provide answers to a large number of scientific questions. The production and detection of elements with atomic numbers 107 to 112 (Bohrium, Hassium, Meitnerium, Darmstadtium, Röntgenium and Copernicium) was first achieved at GSI between 1981 and 1996. Key to this remarkable progress in SHE research were continuous developments and technical innovations. On the one hand, in the field of experimental sensitivity and detection of the nuclear reaction products and, on the other hand, in the field of accelerator technology. For the acceleration of the projectile beam, the UNILAC (Universal Linear Accelerator), which was put into operation in 1975, has been used at GSI so far. In the course of the reconstruction and expansion of the research infrastructure at GSI, a dedicated new particle accelerator, HELIAC (Helmholtz Linear Accelerator), is now under development to meet the special requirements of the beam parameters for the synthesis of new superheavy elements. Typically, the production rates of super-heavy elements with effective cross sections in the picobarn range are very low. Therefore, a high duty cycle (up to CW operation) is a key feature of HELIAC. Thus, the required beam time for the desired nuclear reactions can be significantly shortened. Theoretical preliminary work by Minaev et al. and newly created knowledge about design, fabrication, and operation of superconducting drift tube cavities have laid the foundation for this work and thus the development of the HELIAC linear accelerator. It consists of a superconducting and a normal conducting part. Acceleration takes place in the superconducting part in four cryomodules, each about 5 m long. These contain three CH cavities, one buncher cavity, two solenoid magnets for transverse beam focusing, and two beam position monitors (BPMs). The following 10 m long normal conducting part is primarily used for beam transport and ends with a buncher cavity. This is operated at a halved frequency of 108.408 MHz. A key feature of this accelerator is the variability of the output energy from 3.5 to 7.3 MeV/u with a small energy uncertainty of ±3 keV/u maximum over the entire output energy range. For the development of HELIAC, the EQUUS beam dynamics concept used combined the advantages of conventional linac designs with the high acceleration gradients of superconducting CH-DTLs. By doubling the frequency (compared to the GSI high charge injector) to 216.816 MHz in the superconducting section and using CH cavities at an acceleration gradient of maximum 7.1 MV/m, an acceleration efficiency with superconducting drift tube structures that is unique in the world is made possible. At the same time, the compact lengths of the CH cavities ensure good handling for both production and operation. EQUUS leads to longitudinal beam stability in all energy ranges of the accelerator with the sliding motion of the synchronous phase within each CH cavity. The rms emittance growth is moderate in all levels. The modular design of the HELIAC with four cryomodules basically allows the Linac to be commissioned starting with the first cryomodule, the so-called Advanced Demonstrator. In the subsequent expansion stage with only the first two cryomodules of HELIAC, the lower limit of the energy range to be provided by HELIAC (3.5 MeV/u) can already be clearly exceeded, so that use in regular beam operation at GSI is already conceivable from here on. By means of error tolerance studies, the stability of the HELIAC beam dynamics design against possible alignment errors of the magnetic focusing elements and accelerator cavities as well as errors of the electric field amplitudes and phases have been investigated, basically confirmed and critical parameters have been determined. An additional steering concept via dipole correction coils at the solenoid magnets allows transverse beam control as well as diagnostics by means of two BPMs per cryomodule. With completion of this work in 2021, the CH1 and CH2 cavities have already been built and are in the final preparation and cold test phase. In parallel, the development of the CH cavities CH3-11 has also been started.

Solar Flare Energetic Neutral Emission Measurements in the Project Coronas-I

1994 ◽  
Vol 144 ◽  
pp. 635-639
Author(s):  
J. Baláž ◽  
A. V. Dmitriev ◽  
M. A. Kovalevskaya ◽  
K. Kudela ◽  
S. N. Kuznetsov ◽  
...  
Keyword(s):  
Solar Flare ◽  
Energy Range ◽  
Gamma Rays ◽  
Pulse Shape ◽  
Gamma Ray ◽  
Pulse Shape Discrimination ◽  
Shape Discrimination ◽  
Solar Neutron ◽  
Low Altitude

AbstractThe experiment SONG (SOlar Neutron and Gamma rays) for the low altitude satellite CORONAS-I is described. The instrument is capable to provide gamma-ray line and continuum detection in the energy range 0.1 – 100 MeV as well as detection of neutrons with energies above 30 MeV. As a by-product, the electrons in the range 11 – 108 MeV will be measured too. The pulse shape discrimination technique (PSD) is used.

The Possibilities for Analytical Methods in Photoemission and Low-Energy Electron Microscopy

1990 ◽  
Vol 48 (1) ◽  
pp. 348-349
Author(s):  
Ernst Bauer
Keyword(s):  
Chemical Characterization ◽  
Emission Angle ◽  
Relative Energy ◽  
Objective Lens ◽  
Chemical Information ◽  
Magnetic Lens ◽  
Incident Intensity ◽  
X Ray ◽  
Leed Pattern ◽  
Image Position

One of the major shortcomings of conventional PEEM and of LEEM is the lack of chemical information about the surface. Although the imaging of the LEED pattern in the back focal plane of the objective lens of a LEEM instrument allows chemical characterization via the crystalline structure derived from the LEED pattern, this method fails in the absence of a characteristic LEED pattern. Direct information about the atomic composition of the surface is then needed which can be best obtained from inner shell electrons either directly by x-ray-induced photoemission (XPEEM) or by x-ray- or electron-induced Auger electron emission (AEEM). These modes of excitation and imaging can be combined with conventional PEEM and LEEM in one instrument which is presently being developed. Thus a complete structural and chemical characterization becomes possible in one instrument, with parallel detection and high resolution.In contrast to LEEM, in which up to more than 50% of the incident intensity is available for image formation, the intensity of the emitted electrons is much lower in XPEEM and AEEM and the signal is much lower than the background in AEEM. Therefore, intensity I and resolution d have to be optimized simultaneously which is best done by maximizing Q = I/d2 with respect to maximum emission angle α and relative energy distribution ε = ΔVo/V accepted by the instrument. For a well-designed magnetic lens section of the cathode lens its aberrations are determined by the accelerating field F in front of the specimen. For a homogeneous accelerating field F and a cosine emission distribution one obtains for the optimum α and ε values αo,εo a radius of the minimum disc of confusion of

L X-RAY FLUORESCENCE CROSS-SECTIONS MEASUREMENTS FOR ELEMENTS 56≤Z≤66 IN THE ENERGY RANGE 11-41 keV

1987 ◽  
Vol 48 (C9) ◽  
pp. C8-669-C8-672 ◽  
Author(s):  
S. SINGH ◽  
S. KUMAR ◽  
D. MEHTA ◽  
M. L. GARG ◽  
N. SINGH ◽  
...  
Keyword(s):  
Energy Range ◽  
Cross Sections ◽  
X Ray
Sign in / Sign up

Export Citation Format

Share Document