Boundary layer receptivity to free-stream turbulence and surface roughness over a swept flat plate

2011 ◽  
Vol 23 (3) ◽  
pp. 034107 ◽  
Author(s):  
Thomas Kurian ◽  
Jens H. M. Fransson ◽  
P. Henrik Alfredsson
Keyword(s):  
Boundary Layer ◽  
Surface Roughness ◽  
Flat Plate ◽  
Free Stream ◽  
Free Stream Turbulence

Effect of Elevated Free-Stream Turbulence on Transitional Heat Transfer Over Dual-Scaled Rough Surfaces

2003 ◽  
Author(s):  
Ting Wang ◽  
Matthew C. Rice
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Surface Roughness ◽  
Vortex Shedding ◽  
Free Stream ◽  
Leading Edge ◽  
Test Surface ◽  
Dominant Effect ◽  
Free Stream Turbulence ◽  
Heat Transfer Phenomenon

The surface roughness over a serviced turbine airfoil is usually multi-scaled with varying features that are difficult to be universally characterized. However, it was previously discovered in low freestream turbulence conditions that the height of larger roughness produces separation and vortex shedding, which trigger early transition and exert a dominant effect on flow pattern and heat transfer. The geometry of the roughness and smaller roughness scales played secondary roles. This paper extends the previous study to elevated turbulence conditions with free-stream turbulence intensity ranging from 0.2–6.0 percent. A simplified test condition on a flat plate is conducted with two discrete regions having different surface roughness. The leading edge roughness is comprised of a sandpaper strip or a single cylinder. The downstream surface is either smooth or covered with sandpaper of grit sizes ranging from 100 ∼ 40 (Ra = 37 ∼ 119 μm). Hot wire measurements are conducted in the boundary layer to study the flow structure. The results of this study verify that the height of the largest-scale roughness triggers an earlier transition even under elevated turbulence conditions and exerts a more dominant effect on flow and heat transfer than does the geometry of the roughness. Heat transfer enhancements of about 30 ∼ 40 percent over the entire test surface are observed. The vortical motion, generated by the backward facing step at the joint of two roughness regions, is believed to significantly increase momentum transport across the boundary layer and bring the elevated turbulence from the freestream towards the wall. No such long-lasting heat transfer phenomenon is observed in low FSTI cases even though vortex shedding also exists in the low turbulence cases. The heat transfer enhancement decreases, instead of increases, as the downstream roughness height increases.

Receptivity to free-stream vorticity of flow past a flat plate with elliptic leading edge

2010 ◽  
Vol 653 ◽  
pp. 245-271 ◽  
Author(s):  
L.-U. SCHRADER ◽  
L. BRANDT ◽  
C. MAVRIPLIS ◽  
D. S. HENNINGSON
Keyword(s):  
Boundary Layer ◽  
Flat Plate ◽  
Free Stream ◽  
Three Dimensional ◽  
Low Frequency ◽  
Leading Edge ◽  
Sound Waves ◽  
Streamwise Vorticity ◽  
Low Frequencies ◽  
Free Stream Turbulence

Receptivity of the two-dimensional boundary layer on a flat plate with elliptic leading edge is studied by numerical simulation. Vortical perturbations in the oncoming free stream are considered, impinging on two leading edges with different aspect ratio to identify the effect of bluntness. The relevance of the three vorticity components of natural free-stream turbulence is illuminated by considering axial, vertical and spanwise vorticity separately at different angular frequencies. The boundary layer is most receptive to zero-frequency axial vorticity, triggering a streaky pattern of alternating positive and negative streamwise disturbance velocity. This is in line with earlier numerical studies on non-modal growth of elongated structures in the Blasius boundary layer. We find that the effect of leading-edge bluntness is insignificant for axial free-stream vortices alone. On the other hand, vertical free-stream vorticity is also able to excite non-modal instability in particular at zero and low frequencies. This mechanism relies on the generation of streamwise vorticity through stretching and tilting of the vertical vortex columns at the leading edge and is significantly stronger when the leading edge is blunt. It can thus be concluded that the non-modal boundary-layer response to a free-stream turbulence field with three-dimensional vorticity is enhanced in the presence of a blunt leading edge. At high frequencies of the disturbances the boundary layer becomes receptive to spanwise free-stream vorticity, triggering Tollmien–Schlichting (T-S) modes and receptivity increases with leading-edge bluntness. The receptivity coefficients to free-stream vortices are found to be about 15% of those to sound waves reported in the literature. For the boundary layers and free-stream perturbations considered, the amplitude of the T-S waves remains small compared with the low-frequency streak amplitudes.

The generation of Tollmien-Schlichting waves by free-stream turbulence

1996 ◽  
Vol 312 ◽  
pp. 341-371 ◽  
Author(s):  
P. W. Duck ◽  
A. I. Ruban ◽  
C. N. Zhikharev
Keyword(s):  
Boundary Layer ◽  
Flat Plate ◽  
Free Stream ◽  
Stokes Equations ◽  
Leading Edge ◽  
Wave Generation ◽  
Generation Process ◽  
Viscous Boundary Layer ◽  
Free Stream Turbulence ◽  
Tollmien Schlichting

The phenomenon of Tollmien-Schlichting wave generation in a boundary layer by free-stream turbulence is analysed theoretically by means of asymptotic solution of the Navier-Stokes equations at large Reynolds numbers (Re → ∞). For simplicity the basic flow is taken to be the Blasius boundary layer over a flat plate. Free-stream turbulence is taken to be uniform and thus may be represented by a superposition of vorticity waves. Interaction of these waves with the flat plate is investigated first. It is shown that apart from the conventional viscous boundary layer of thickness O(Re−1/2), a ‘vorticity deformation layer’ of thickness O(Re−1/4) forms along the flat-plate surface. Equations to describe the vorticity deformation process are derived, based on multiscale asymptotic techniques, and solved numerically. As a result it is shown that a strong singularity (in the form of a shock-like distribution in the wall vorticity) forms in the flow at some distance downstream of the leading edge, on the surface of the flat plate. This is likely to provoke abrupt transition in the boundary layer. With decreasing amplitude of free-stream turbulence perturbations, the singular point moves far away from the leading edge of the flat plate, and any roughness on the surface may cause Tollmien-Schlichting wave generation in the boundary layer. The theory describing the generation process is constructed on the basis of the ‘triple-deck’ concept of the boundary-layer interaction with the external inviscid flow. As a result, an explicit formula for the amplitude of Tollmien-Schlichting waves is obtained.

Sign in / Sign up

Export Citation Format

Share Document