Evaluation of active flow control applied to wind turbine blade section

2010 ◽  
Vol 2 (6) ◽  
pp. 063101 ◽  
Author(s):  
O. Stalnov ◽  
A. Kribus ◽  
A. Seifert
Keyword(s):  
Flow Control ◽  
Wind Turbine ◽  
Turbine Blade ◽  
Active Flow Control ◽  
Wind Turbine Blade ◽  
Blade Section ◽  
Active Flow

Experimental investigation of the effect of active flow control on the wake of a wind turbine blade

2021 ◽  
pp. 095440622110089
Author(s):  
GholamHossein Maleki ◽  
Ali Reza Davari ◽  
Mohammad Reza Soltani
Keyword(s):  
Experimental Investigation ◽  
Wind Turbine ◽  
Turbine Blade ◽  
Active Flow Control ◽  
Leading Edge ◽  
Wind Turbine Blade ◽  
Plasma Actuators ◽  
Plasma Actuation ◽  
Surface Pressure Distribution ◽  
Stall Angle

An extensive experimental investigation was conducted to study the effects of Dielectric Barrier Discharge (DBD), on the flow field of an airfoil at low Reynolds number. The DBD was mounted near the leading edge of a section of a wind turbine blade. It is believed that DBD can postpone the separation point on the airfoil by injecting momentum to the flow. The effects of steady actuations on the velocity profiles in the wake region have been investigated. The tests were performed at α = 4 to 36 degrees i.e. from low to deep stall angles of attack regions. Both surface pressure distribution and wake profile show remarkable improvement at high angles of attack, beyond the static stall angle of the airfoil when the plasma actuation was implemented. The drag calculated from the wake momentum deficit has further shown the favorable role of the plasma actuators to control the flow over the airfoil at incidences beyond the static stall angle of attack of this airfoil. The results demonstrated that DBD has been able to postpone the stall onset significantly. It has been observed that the best performance for the plasma actuation for this airfoil is in the deep stall angles of attack range. However, below and near the static stall angles of attack, plasma augmentation was pointed out to have a negligible improvement in the aerodynamic behavior.

High Efficiency Wind Turbine Using Co-Flow Jet Active Flow Control

2021 ◽  
Author(s):  
Kewei Xu ◽  
Gecheng Zha
Keyword(s):  
Flow Control ◽  
Wind Turbine ◽  
Flow Separation ◽  
Power Output ◽  
Pitch Angle ◽  
Active Flow Control ◽  
Horizontal Axis Wind Turbine ◽  
Negative Power ◽  
Freestream Velocity ◽  
Active Flow

Abstract This paper applies Co-flow Jet (CFJ) active flow control airfoil to a NREL horizontal axis wind turbine for power output improvement. CFJ is a zero-net-mass-flux active flow control method that dramatically increases airfoil lift coefficient and suppresses flow separation at a low energy expenditure. The 3D Reynolds Averaged Navier-Stokes (RANS) equations with one-equation Spalart-Allmaras (SA) turbulence model are solved to simulate the 3D flows of the wind turbines. The baseline wind turbine is the NREL 10.06m diameter phase VI wind turbine and is modified to a CFJ blade by implementing CFJ along the span. The baseline wind turbine performance is validated with the experiment at three wind speeds, 7m/s, 15m/s, and 25m/s. The predicted blade surface pressure distributions and power output agree well with the experimental measurements. The study indicates that the CFJ can enhance the power output at the condition where angle of attack is increased to the level that conventional wind turbine is stalled. At the speed of 7m/s that the NREL turbine is designed to achieve the optimum efficiency at the pitch angle of 3°, the CFJ turbine does not increase the power output. When the pitch angle is reduced by 13° to −10°, the baseline wind turbine is stalled and generates negative power output at 7m/s. But the CFJ wind turbine increases the power output by 12.3% assuming CFJ fan efficiency of 80% at the same wind speed. This is an effective method to extract more power from the wind at all speeds. It is particularly useful at low speeds to decrease cut-in speed and increase power output without exceeding the structure limit. At the freestream velocity of 15m/s and the CFJ momentum coefficient Cμ of 0.23, the net power output is increased by 207.7% assuming the CFJ fan efficiency of 80%, compared to the baseline wind turbine due to the removal of flow separation. The CFJ wind turbine appears to open a door to a new area of wind turbine efficiency improvement and adaptive control for optimal loading.

Numerical investigation of active flow control with co-flowing jet in a horizontal axis wind turbine

2020 ◽  
pp. 0309524X2096139
Author(s):  
Fangrui Shi ◽  
Yingqiao Xu ◽  
Xiaojing Sun
Keyword(s):  
Flow Control ◽  
Wind Turbine ◽  
Performance Enhancement ◽  
Active Flow Control ◽  
Three Dimensional ◽  
Horizontal Axis ◽  
Suction Surface ◽  
Horizontal Axis Wind Turbine ◽  
Momentum Coefficient ◽  
Active Flow

In this paper, a three-dimensional numerical simulation of the aerodynamic performance of a horizontal axis wind turbine (HAWT) whose blades are equipped with a new active flow control concept called Co-Flowing Jet (CFJ) is carried out. Numerical results show that the use of CFJ over the blade suction surface can effectively delay flow separation, thus improving the net torque and power output of HAWT. Besides, this increment in the net power produced by the turbine is considerably higher than the power consumed by the CFJ. Thus, the overall efficiency of the HAWT can be greatly increased. Furthermore, influences of different CFJ operating parameters including location of injection port, jet momentum coefficient and slot length on the performance enhancement of a HAWT are also systematically studied and the optimal combination of these parameters to obtain the best possible turbine efficiency throughout a range of different wind speeds has been identified.

Trailing edge noise reduction of wind turbine blades by active flow control

Wind Energy ◽  
2014 ◽  
Vol 18 (5) ◽  
pp. 909-923 ◽  
Author(s):  
Alexander Wolf ◽  
Thorsten Lutz ◽  
Werner Würz ◽  
Ewald Krämer ◽  
Oksana Stalnov ◽  
...  
Keyword(s):  
Flow Control ◽  
Wind Turbine ◽  
Noise Reduction ◽  
Active Flow Control ◽  
Turbine Blades ◽  
Wind Turbine Blades ◽  
Trailing Edge ◽  
Trailing Edge Noise ◽  
Active Flow
Sign in / Sign up

Export Citation Format

Share Document