Temperature-dependent fluorescence decay lifetimes of the phosphor Y3(Al0.5Ga0.5)5O12:Ce 1%

2009 ◽  
Vol 105 (3) ◽  
pp. 036105 ◽  
Author(s):  
S. W. Allison ◽  
J. R. Buczyna ◽  
R. A. Hansel ◽  
D. G. Walker ◽  
G. T. Gillies
Keyword(s):  
Fluorescence Decay ◽  
Temperature Dependent

scholarly journals Temperature dependent excited state relaxation of a red emitting DNA-templated silver nanocluster

2017 ◽  
Vol 53 (93) ◽  
pp. 12556-12559 ◽  
Author(s):  
Cecilia Cerretani ◽  
Miguel R. Carro-Temboury ◽  
Stefan Krause ◽  
Sidsel Ammitzbøll Bogh ◽  
Tom Vosch
Keyword(s):  
Excited State ◽  
Decay Time ◽  
Fluorescence Decay ◽  
Silver Nanoclusters ◽  
Temperature Dependent ◽  
Silver Nanocluster ◽  
Fluorescence Decay Time ◽  
Average Fluorescence

The average fluorescence decay time of DNA-stabilized silver nanoclusters is temperature dependent and could find applications in nanothermometry.

Temperature-dependent fluorescence decay and energy transfer in Nd/Cr:YAG ceramics

2019 ◽  
Vol 90 ◽  
pp. 215-219 ◽  
Author(s):  
Yoshiyuki Honda ◽  
Shinji Motokoshi ◽  
Takahisa Jitsuno ◽  
Kana Fujioka ◽  
Masahiro Nakatsuka ◽  
...  
Keyword(s):  
Energy Transfer ◽  
Fluorescence Decay ◽  
Temperature Dependent

scholarly journals Temperature-Dependent Relaxation of Excitons in Tubular Molecular Aggregates:  Fluorescence Decay and Stokes Shift

2006 ◽  
Vol 110 (41) ◽  
pp. 20268-20276 ◽  
Author(s):  
A. Pugžlys ◽  
R. Augulis ◽  
P. H. M. van Loosdrecht ◽  
C. Didraga ◽  
V. A. Malyshev ◽  
...  
Keyword(s):  
Stokes Shift ◽  
Fluorescence Decay ◽  
Molecular Aggregates ◽  
Temperature Dependent

(111) Monocrystalline Nickel Films

1972 ◽  
Vol 30 ◽  
pp. 512-513
Author(s):  
T.E. Pratt ◽  
R.W. Vook
Keyword(s):  
Film Thickness ◽  
Deposition Rate ◽  
Room Temperature ◽  
Narrow Range ◽  
High Vacuum ◽  
Residual Pressure ◽  
Temperature Dependent ◽  
Deposition Parameters ◽  
Transmission Electron ◽  
Substrate Temperatures

(111) oriented thin monocrystalline Ni films have been prepared by vacuum evaporation and examined by transmission electron microscopy and electron diffraction. In high vacuum, at room temperature, a layer of NaCl was first evaporated onto a freshly air-cleaved muscovite substrate clamped to a copper block with attached heater and thermocouple. Then, at various substrate temperatures, with other parameters held within a narrow range, Ni was evaporated from a tungsten filament. It had been shown previously that similar procedures would yield monocrystalline films of CU, Ag, and Au.For the films examined with respect to temperature dependent effects, typical deposition parameters were: Ni film thickness, 500-800 A; Ni deposition rate, 10 A/sec.; residual pressure, 10-6 torr; NaCl film thickness, 250 A; and NaCl deposition rate, 10 A/sec. Some additional evaporations involved higher deposition rates and lower film thicknesses.Monocrystalline films were obtained with substrate temperatures above 500° C. Below 450° C, the films were polycrystalline with a strong (111) preferred orientation.

Sign in / Sign up

Export Citation Format

Share Document