Thermal Conductivity Measurements of He, Ne, Ar, Kr, N2 and CO[sub 2] with a Transient Hot Wire Method

1973 ◽  
Author(s):  
J. W. Haarman ◽  
Hugh C. Wolfe ◽  
J. Kestin
Keyword(s):  
Thermal Conductivity ◽  
Conductivity Measurements ◽  
Transient Hot Wire ◽  
Hot Wire ◽  
Transient Hot Wire Method ◽  
Wire Method

scholarly journals Application and testing of a new simple experimental set-up for thermal conductivity measurements of liquids

2017 ◽  
Vol 21 (3) ◽  
pp. 1195-1202 ◽  
Author(s):  
Andrej Stanimirovic ◽  
Emila Zivkovic ◽  
Nenad Milosevic ◽  
Mirjana Kijevcanin
Keyword(s):  
Thermal Conductivity ◽  
Measurement Uncertainty ◽  
Thermophysical Properties ◽  
Deionized Water ◽  
Conductivity Measurements ◽  
Transient Hot Wire ◽  
Hot Wire ◽  
New Apparatus ◽  
Wire Method ◽  
Set Up

Transient hot wire method is considered a reliable and precise technique for measuring the thermal conductivity of liquids. The present paper describes a new transient hot wire experimental set-up and its initial testing. The new apparatus was tested by performing thermal conductivity measurements on substances whose reference thermophysical properties data existed in literature, namely on pure toluene and double distilled deionized water. The values of thermal conductivity measured in the temperature range 25 to 45 ?C deviated +2.2% to +3% from the literature data, while the expanded measurement uncertainty was estimated to be ?4%.

Analysis of the Transient Hot-Wire Method to Measure Thermal Conductivity of Silica Aerogel: Influence of Wire Length, and Radiation Properties

2014 ◽  
Vol 136 (4) ◽  
Author(s):  
Ellann Cohen ◽  
Leon Glicksman
Keyword(s):  
Thermal Conductivity ◽  
Silica Aerogel ◽  
Test Method ◽  
Wire Radius ◽  
Wire Length ◽  
Transient Hot Wire ◽  
Hot Wire ◽  
End Effects ◽  
Transient Hot Wire Method ◽  
Wire Method

When the transient hot-wire method is used to measure the thermal conductivity of very low thermal conductivity silica aerogel (in the range of 10 mW/m·K at 1 atm) end effects due to the finite wire size and radiation corrections must be considered. An approximate method is presented to account for end effects with realistic boundary conditions. The method was applied to small experimental samples of the aerogel using different wire lengths. Initial conductivity results varied with wire length. This variation was eliminated by the use of the end effect correction. The test method was validated with the NIST (National Institute of Standards and Technology) Standard Reference Material 1459, fumed silica board to within 1 mW/m·K. The aerogel is semitransparent. Due to the small wire radius and short transient, radiation heat transfer may not be fully accounted for. In a full size aerogel panel radiation will augment the phonon conduction by a larger amount.

scholarly journals A Study on Thermal Conductivity of Mixture of Magnesia Particle and Molten Nitrate by a Transient Hot Wire Method

Netsu Bussei ◽  
2005 ◽  
Vol 19 (3) ◽  
pp. 142-146 ◽  
Author(s):  
Kazuyuki Kitano ◽  
Katsuya Hanyuda ◽  
Eisyun Takegoshi ◽  
Masatoshi Sawada ◽  
Yoshio Hirasawa ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Transient Hot Wire ◽  
Hot Wire ◽  
Transient Hot Wire Method ◽  
Wire Method
Sign in / Sign up

Export Citation Format

Share Document