The single-valued diffusion coefficient for ionic diffusion through porous media

2007 ◽  
Vol 101 (2) ◽  
pp. 024907 ◽  
Author(s):  
Sylvie Lorente ◽  
Dorinel Voinitchi ◽  
Pascale Bégué-Escaffit ◽  
Xavier Bourbon
2018 ◽  
Vol 21 (12) ◽  
pp. 1253-1263
Author(s):  
Ruifei Wang ◽  
Hongqing Song ◽  
Jiulong Wang ◽  
Yuhe Wang

2019 ◽  
Vol 6 (6) ◽  
pp. 181902 ◽  
Author(s):  
Junchen Lv ◽  
Yuan Chi ◽  
Changzhong Zhao ◽  
Yi Zhang ◽  
Hailin Mu

Reliable measurement of the CO 2 diffusion coefficient in consolidated oil-saturated porous media is critical for the design and performance of CO 2 -enhanced oil recovery (EOR) and carbon capture and storage (CCS) projects. A thorough experimental investigation of the supercritical CO 2 diffusion in n -decane-saturated Berea cores with permeabilities of 50 and 100 mD was conducted in this study at elevated pressure (10–25 MPa) and temperature (333.15–373.15 K), which simulated actual reservoir conditions. The supercritical CO 2 diffusion coefficients in the Berea cores were calculated by a model appropriate for diffusion in porous media based on Fick's Law. The results show that the supercritical CO 2 diffusion coefficient increases as the pressure, temperature and permeability increase. The supercritical CO 2 diffusion coefficient first increases slowly at 10 MPa and then grows significantly with increasing pressure. The impact of the pressure decreases at elevated temperature. The effect of permeability remains steady despite the temperature change during the experiments. The effect of gas state and porous media on the supercritical CO 2 diffusion coefficient was further discussed by comparing the results of this study with previous study. Based on the experimental results, an empirical correlation for supercritical CO 2 diffusion coefficient in n -decane-saturated porous media was developed. The experimental results contribute to the study of supercritical CO 2 diffusion in compact porous media.


2019 ◽  
Vol 89 (10) ◽  
pp. 1630
Author(s):  
В.П. Беляев ◽  
С.В. Мищенко ◽  
П.С. Беляев

A new method for studying mass transfer process in porous media has been considered, which allows the rapid diffusion coefficient control in thin products without destroying them and without the preliminary calibration of the diffuser concentration meter. The method provides an increase in the measurement accuracy due to the possibility of choosing the measured parameters included in the design expression. Parameters are taking from the segments of converter static characteristic. The converter has high sensitivity and noise immunity.


2006 ◽  
Vol 258-260 ◽  
pp. 207-212
Author(s):  
Miranda M.N.N. ◽  
M.A. Silva

In the drying of porous media, the mass transport occurs in the pores as well as on the surface of the solid. The mechanisms involved can take place simultaneously, influenced by the predominant one and can change depending on the moisture content. In this work, the moisture effective diffusivity was estimated in solids with distinct structural properties in order to verify the predominant mechanisms according to the moisture content, analyzing the influence of the physical properties. The materials studied were NaY Zeolite, Kaolin, Silica and Alumina. The results of diffusion coefficient present a minimum at low moisture content that can be related to pore size.


Sign in / Sign up

Export Citation Format

Share Document