Titanium Diffusion and Phase Formation in Tube-Type Rod-In-Tube and Internal-Tin Nb3Sn Strands

2006 ◽  
Author(s):  
X. Wu
Keyword(s):  
Phase Formation ◽  
Tube Type ◽  
Titanium Diffusion

Characterization of reactive phase formation in sputter-deposited Ni/Al multilayer thin films using TEM

1996 ◽  
Vol 54 ◽  
pp. 1000-1001
Author(s):  
G. Lucadamo ◽  
K. Barmak ◽  
C. Michaelsen
Keyword(s):  
Thin Films ◽  
Phase Formation ◽  
Dark Field ◽  
Nickel Layer ◽  
Multilayer Thin Films ◽  
Cross Sectional ◽  
Dark Field Imaging ◽  
Transmission Electron ◽  
Sputter Deposited ◽  
Constant Heating

The subject of reactive phase formation in multilayer thin films of varying periodicity has stimulated much research over the past few years. Recent studies have sought to understand the reactions that occur during the annealing of Ni/Al multilayers. Dark field imaging from transmission electron microscopy (TEM) studies in conjunction with in situ x-ray diffraction measurements, and calorimetry experiments (isothermal and constant heating rate), have yielded new insights into the sequence of phases that occur during annealing and the evolution of their microstructure.In this paper we report on reactive phase formation in sputter-deposited lNi:3Al multilayer thin films with a periodicity A (the combined thickness of an aluminum and nickel layer) from 2.5 to 320 nm. A cross-sectional TEM micrograph of an as-deposited film with a periodicity of 10 nm is shown in figure 1. This image shows diffraction contrast from the Ni grains and occasionally from the Al grains in their respective layers.

Analysis of LPG diffusion flame in tube type burner

2019 ◽  
Vol 13 (3) ◽  
pp. 5278-5293
Author(s):  
Vipul Patel ◽  
Rupesh Shah
Keyword(s):  
Diffusion Flame ◽  
Emission Characteristic ◽  
Flame Stability ◽  
Liquefied Petroleum Gas ◽  
Air Velocity ◽  
Length Fraction ◽  
Low Emission ◽  
Tube Type ◽  
Stability Limits ◽  
Co Emission

The present research aims to analyse diffusion flame in a tube type burner with Liquefied petroleum gas (LPG) as a fuel. An experimental investigation is performed to study flame appearance, flame stability, Soot free length fraction (SFLF) and CO emission of LPG diffusion flame. Effects of varying air and fuel velocities are analysed to understand the physical process involved in combustion. SFLF is measured to estimate the reduction of soot. Stability limits of the diffusion flame are characterized by the blowoff velocity. Emission characteristic in terms of CO level is measured at different equivalence ratios. Experimental results show that the air and fuel velocity strongly influences the appearance of LPG diffusion flame. At a constant fuel velocity, blue zone increases and the luminous zone decreases with the increase in air velocity. It is observed that the SFLF increases with increasing air velocity at a constant fuel velocity. It is observed that the blowoff velocity of the diffusion flame increases as fuel velocity increases. Comparison of emission for flame with and without swirl indicates that swirl results in low emission of CO and higher flame stability. Swirler with 45° vanes achieved the lowest CO emission of 30 ppm at Φ = 1.3.

On the trustability of semi-empirical methods to the calculation of gas phase formation enthalpies of inorganic compounds containing heavy metals: tin borates

2017 ◽  
Author(s):  
Robson de Farias
Keyword(s):  
Heavy Metals ◽  
Gas Phase ◽  
Phase Formation ◽  
Inorganic Compounds ◽  
Formation Enthalpy ◽  
Computational Time ◽  
Gas Formation ◽  
Formation Enthalpies ◽  
Knudsen Effusion Mass Spectrometry ◽  
Semi Empirical

<p>In the present work, are calculated the gas formation enthalpies (SE; PM3 and PM6) for tin borates: SnB<sub>2</sub>O<sub>4</sub><sup> </sup>and Sn<sub>2</sub>B<sub>2</sub>O<sub>5</sub>. The calculated values are compared with experimental ones, obtained by Knudsen effusion mass spectrometry [3]. It is shown that SE methods, besides their lower computational time consuming can, indeed, provide reliable gas phase formation enthalpy values for inorganic compounds containing heavy metals.</p>

The results of field trials of the codling moth pheromone preparations in 2020

2020 ◽  
Author(s):  
S.V. Dmitriyeva ◽  
◽  
I.M. Mityushev
Keyword(s):  
Russian Federation ◽  
Central Region ◽  
Cydia Pomonella ◽  
Codling Moth ◽  
Field Trials ◽  
Field Screening ◽  
Tube Type ◽  
The Russian Federation ◽  
Polyethylene Dispenser

This article presents the results of field screening of pheromone preparations of the codling moth, Cydia pomonella L., conducted in 2020 under conditions of the Central Region of the Russian Federation. The new «Tube» type dispensers were tested vs. standard foil-polyethylene dispenser.

Simulation of load following mode of operation for a natural circulation pressure tube type BWR

Kerntechnik ◽  
2011 ◽  
Vol 76 (4) ◽  
pp. 237-243
Author(s):  
R. Kumar ◽  
A. J. Gaikwad ◽  
A. D. Contractor ◽  
A. Srivastava ◽  
H. G. Lele ◽  
...  
Keyword(s):  
Natural Circulation ◽  
Pressure Tube ◽  
Load Following ◽  
Mode Of Operation ◽  
Tube Type
Sign in / Sign up

Export Citation Format

Share Document