Adverse pressure gradient effect on nonlinear varicose instability of a streaky structure in an unswept wing boundary layer

2005 ◽  
Vol 17 (11) ◽  
pp. 118106 ◽  
Author(s):  
Yu. A. Litvinenko ◽  
V. G. Chernoray ◽  
V. V. Kozlov ◽  
G. R. Grek ◽  
L. Löfdahl ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Pressure Gradient ◽  
Adverse Pressure Gradient ◽  
Gradient Effect ◽  
Streaky Structure

Boundary Layer Flashback Model for Hydrogen Flames in Confined Geometries Including the Effect of Adverse Pressure Gradient

2020 ◽  
Author(s):  
Ólafur H. Björnsson ◽  
Sikke A. Klein ◽  
Joeri Tober
Keyword(s):  
Boundary Layer ◽  
Pressure Gradient ◽  
Flow Separation ◽  
Gradient Flow ◽  
Lewis Number ◽  
Adverse Pressure Gradient ◽  
Future Research ◽  
Diffuser Flow ◽  
Combustion Properties ◽  
Quenching Distance

Abstract The combustion properties of hydrogen make premixed hydrogen-air flames very prone to boundary layer flashback. This paper describes the improvement and extension of a boundary layer flashback model from Hoferichter [1] for flames confined in burner ducts. The original model did not perform well at higher preheat temperatures and overpredicted the backpressure of the flame at flashback by 4–5x. By simplifying the Lewis number dependent flame speed computation and by applying a generalized version of Stratford’s flow separation criterion [2], the prediction accuracy is improved significantly. The effect of adverse pressure gradient flow on the flashback limits in 2° and 4° diffusers is also captured adequately by coupling the model to flow simulations and taking into account the increased flow separation tendency in diffuser flow. Future research will focus on further experimental validation and direct numerical simulations to gain better insight into the role of the quenching distance and turbulence statistics.

A Superposition Analysis of the Turbulent Boundary Layer in an Adverse Pressure Gradient

1951 ◽  
Vol 18 (1) ◽  
pp. 95-100
Author(s):  
Donald Ross ◽  
J. M. Robertson
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Wall Shear Stress ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Pressure Gradient ◽  
Adverse Pressure Gradient ◽  
Pressure Recovery ◽  
Stress Coefficient ◽  
Wall Shear

Abstract As an interim solution to the problem of the turbulent boundary layer in an adverse pressure gradient, a super-position method of analysis has been developed. In this method, the velocity profile is considered to be the result of two effects: the wall shear stress and the pressure recovery. These are superimposed, yielding an expression for the velocity profiles which approximate measured distributions. The theory also leads to a more reasonable expression for the wall shear-stress coefficient.

Effects of Area Ratio and Mean Rise Angle on the Aerodynamics of Interturbine Ducts

2018 ◽  
Vol 140 (9) ◽  
Author(s):  
Yanfeng Zhang ◽  
Shuzhen Hu ◽  
Ali Mahallati ◽  
Xue-Feng Zhang ◽  
Edward Vlasic
Keyword(s):  
Boundary Layer ◽  
Pressure Gradient ◽  
Static Pressure ◽  
Computational Study ◽  
Pressure Rise ◽  
Adverse Pressure Gradient ◽  
Boundary Layer Separation ◽  
Wake Flow ◽  
Height Ratio ◽  
Inlet Swirl

This work, a continuation of a series of investigations on the aerodynamics of aggressive interturbine ducts (ITD), is aimed at providing detailed understanding of the flow physics and loss mechanisms in four different ITD geometries. A systematic experimental and computational study was carried out by varying duct outlet-to-inlet area ratios (ARs) and mean rise angles while keeping the duct length-to-inlet height ratio, Reynolds number, and inlet swirl constant in all four geometries. The flow structures within the ITDs were found to be dominated by the boundary layer separation and counter-rotating vortices in both the casing and hub regions. The duct mean rise angle determined the severity of adverse pressure gradient in the casing's first bend, whereas the duct AR mainly governed the second bend's static pressure rise. The combination of upstream wake flow and the first bend's adverse pressure gradient caused the boundary layer to separate and intensify the strength of counter-rotating vortices. At high mean rise angle, the separation became stronger at the casing's first bend and moved farther upstream. At high ARs, a two-dimensional separation appeared on the casing and resulted in increased loss. Pressure loss penalties increased significantly with increasing duct mean rise angle and AR.

Pressure gradient effects on the large-scale structure of turbulent boundary layers

2013 ◽  
Vol 715 ◽  
pp. 477-498 ◽  
Author(s):  
Zambri Harun ◽  
Jason P. Monty ◽  
Romain Mathis ◽  
Ivan Marusic
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Pressure Gradient ◽  
Boundary Layers ◽  
Amplitude Modulation ◽  
Large Scale ◽  
Outer Region ◽  
Adverse Pressure Gradient ◽  
Turbulent Boundary Layers ◽  
Small Scale

AbstractResearch into high-Reynolds-number turbulent boundary layers in recent years has brought about a renewed interest in the larger-scale structures. It is now known that these structures emerge more prominently in the outer region not only due to increased Reynolds number (Metzger & Klewicki, Phys. Fluids, vol. 13(3), 2001, pp. 692–701; Hutchins & Marusic, J. Fluid Mech., vol. 579, 2007, pp. 1–28), but also when a boundary layer is exposed to an adverse pressure gradient (Bradshaw, J. Fluid Mech., vol. 29, 1967, pp. 625–645; Lee & Sung, J. Fluid Mech., vol. 639, 2009, pp. 101–131). The latter case has not received as much attention in the literature. As such, this work investigates the modification of the large-scale features of boundary layers subjected to zero, adverse and favourable pressure gradients. It is first shown that the mean velocities, turbulence intensities and turbulence production are significantly different in the outer region across the three cases. Spectral and scale decomposition analyses confirm that the large scales are more energized throughout the entire adverse pressure gradient boundary layer, especially in the outer region. Although more energetic, there is a similar spectral distribution of energy in the wake region, implying the geometrical structure of the outer layer remains universal in all cases. Comparisons are also made of the amplitude modulation of small scales by the large-scale motions for the three pressure gradient cases. The wall-normal location of the zero-crossing of small-scale amplitude modulation is found to increase with increasing pressure gradient, yet this location continues to coincide with the large-scale energetic peak wall-normal location (as has been observed in zero pressure gradient boundary layers). The amplitude modulation effect is found to increase as pressure gradient is increased from favourable to adverse.

Turbine Cascade Flow Control Using a “Wake Filling” Pulsed Plasma Actuator

2005 ◽  
Author(s):  
H. Perez-Blanco ◽  
Robert Van Dyken ◽  
Aaron Byerley ◽  
Tom McLaughlin
Keyword(s):  
Boundary Layer ◽  
Pressure Gradient ◽  
Laminar Boundary Layer ◽  
Separation Bubble ◽  
Adverse Pressure Gradient ◽  
Suction Side ◽  
Plasma Actuator ◽  
Pulsed Plasma ◽  
Power Cost ◽  
Hot Film

Separation bubbles in high-camber blades under part-load conditions have been addressed via continuous and pulsed jets, and also via plasma actuators. Numerous passive techniques have been employed as well. In this type of blades, the laminar boundary layer cannot overcome the adverse pressure gradient arising along the suction side, resulting on a separation bubble. When separation is abated, a common explanation is that kinetic energy added to the laminar boundary layer speeds up its transition to turbulent. In the present study, a plasma actuator installed in the trailing edge (i.e. “wake filling configuration”) of a cascade blade is used to excite the flow in pulsed and continuous ways. The pulsed excitation can be directed to the frequencies of the large coherent structures (LCS) of the flow, as obtained via a hot-film anemometer, or to much higher frequencies present in the suction-side boundary layer, as given in the literature. It is found that pulsed frequencies much higher than that of LCS reduce losses and improve turning angles further than frequencies close to those of LCS. With the plasma actuator 50% on time, good loss abatement is obtained. Larger “on time” values yield improvements, but with decreasing returns. Continuous high-frequency activation results in the largest loss reduction, at increased power cost. The effectiveness of high frequencies may be due to separation abatement via boundary layer excitation into transition, or may simply be due to the creation of a favorable pressure gradient that averts separation as the actuator ejects fluid downstream. Both possibilities are discussed in light of the experimental evidence.

Predicting Turbulent Boundary Layer Wall Pressure Fluctuations in Adverse Pressure Gradients

2005 ◽  
Author(s):  
Frank J. Aldrich
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Pressure Gradient ◽  
Pressure Fluctuations ◽  
Adverse Pressure Gradient ◽  
Wall Pressure ◽  
Prediction Tool ◽  
Pressure Gradients ◽  
Wall Pressure Fluctuations ◽  
The Difference

A physics-based approach is employed and a new prediction tool is developed to predict the wavevector-frequency spectrum of the turbulent boundary layer wall pressure fluctuations for subsonic airfoils under the influence of adverse pressure gradients. The prediction tool uses an explicit relationship developed by D. M. Chase, which is based on a fit to zero pressure gradient data. The tool takes into account the boundary layer edge velocity distribution and geometry of the airfoil, including the blade chord and thickness. Comparison to experimental adverse pressure gradient data shows a need for an update to the modeling constants of the Chase model. To optimize the correlation between the predicted turbulent boundary layer wall pressure spectrum and the experimental data, an optimization code (iSIGHT) is employed. This optimization module is used to minimize the absolute value of the difference (in dB) between the predicted values and those measured across the analysis frequency range. An optimized set of modeling constants is derived that provides reasonable agreement with the measurements.

scholarly journals Instability and Transition of a Boundary Layer over a Backward-Facing Step

Fluids ◽  
2022 ◽  
Vol 7 (1) ◽  
pp. 35
Author(s):  
Ming Teng ◽  
Ugo Piomelli
Keyword(s):  
Boundary Layer ◽  
Pressure Gradient ◽  
Velocity Distribution ◽  
Adverse Pressure Gradient ◽  
Transition Process ◽  
Transition To Turbulence ◽  
Recirculation Region ◽  
Backward Facing Step ◽  
Freestream Velocity ◽  
Displacement Thickness

The development of secondary instabilities in a boundary layer over a backward-facing step is investigated numerically. Two step heights are considered, h/δo*=0.5 and 1.0 (where δo* is the displacement thickness at the step location), in addition to a reference flat-plate case. A case with a realistic freestream-velocity distribution is also examined. A controlled K-type transition is initiated using a narrow ribbon upstream of the step, which generates small and monochromatic perturbations by periodic blowing and suction. A well-resolved direct numerical simulation is performed. The step height and the imposed freestream-velocity distribution exert a significant influence on the transition process. The results for the h/δo*=1.0 case exhibit a rapid transition primarily due to the Kelvin–Helmholtz instability downstream of step; non-linear interactions already occur within the recirculation region, and the initial symmetry and periodicity of the flow are lost by the middle stage of transition. In contrast, case h/δo*=0.5 presents a transition road map in which transition occurs far downstream of the step, and the flow remains spatially symmetric and temporally periodic until the late stage of transition. A realistic freestream-velocity distribution (which induces an adverse pressure gradient) advances the onset of transition to turbulence, but does not fundamentally modify the flow features observed in the zero-pressure gradient case. Considering the budgets of the perturbation kinetic energy, both the step and the induced pressure-gradient increase, rather than modify, the energy transfer.

Sign in / Sign up

Export Citation Format

Share Document