Transmission Electron Microscope Observations of Magnetic Domain Walls

1961 ◽  
Vol 32 (7) ◽  
pp. 1261-1265 ◽  
Author(s):  
J. T. Michalak ◽  
R. C. Glenn
Keyword(s):  
Electron Microscope ◽  
Transmission Electron Microscope ◽  
Domain Walls ◽  
Magnetic Domain ◽  
Transmission Electron ◽  
Magnetic Domain Walls

The direct determination of magnetic domain wall profiles using a split detector STEM

1978 ◽  
Vol 36 (1) ◽  
pp. 466-467
Author(s):  
J.N. Chapman ◽  
P.E. Batson ◽  
E.M. Waddell ◽  
R.P. Ferrier
Keyword(s):  
Electron Microscope ◽  
Domain Wall ◽  
Transmission Electron Microscope ◽  
Domain Walls ◽  
Photographic Plate ◽  
Magnetic Domain ◽  
Direct Determination ◽  
Quantitative Information ◽  
Scanning Transmission Electron Microscope ◽  
Transmission Electron

By far the most commonly used mode of Lorentz microscopy in the examination of ferromagnetic thin films is the Fresnel or defocus mode. Use of this mode in the conventional transmission electron microscope (CTEM) is straightforward and immediately reveals the existence of all domain walls present. However, if such quantitative information as the domain wall profile is required, the technique suffers from several disadvantages. These include the inability to directly observe fine image detail on the viewing screen because of the stringent illumination coherence requirements, the difficulty of accurately translating part of a photographic plate into quantitative electron intensity data, and, perhaps most severe, the difficulty of interpreting this data. One solution to the first-named problem is to use a CTEM equipped with a field emission gun (FEG) (Inoue, Harada and Yamamoto 1977) whilst a second is to use the equivalent mode of image formation in a scanning transmission electron microscope (STEM) (Chapman, Batson, Waddell, Ferrier and Craven 1977), a technique which largely overcomes the second-named problem as well.

In situ observation of the motion of ferroelectric domain walls in Bi4Ti3O12 single crystals

2016 ◽  
Vol 49 (5) ◽  
pp. 1645-1652 ◽  
Author(s):  
Wanneng Ye ◽  
Lingli Tang ◽  
Chaojing Lu ◽  
Huabing Li ◽  
Yichun Zhou
Keyword(s):  
Electron Beam ◽  
Electron Microscope ◽  
Single Crystals ◽  
Transmission Electron Microscope ◽  
Domain Walls ◽  
Domain Switching ◽  
Ferroelectric Domain ◽  
In Situ Observation ◽  
Transmission Electron

Five types of ferroelectric domain walls (DWs) are present in Bi4Ti3O12 single crystals (Ye et al., 2015). Here their motion was investigated in situ using transmission electron microscopy and optical microscopy. The motion of P (a)-90° DWs, P (a)-180° DWs and P (c)-180° DWs was observed through electron beam poling in a transmission electron microscope. The growth of new P s(a)-180° nanodomains was frequently seen and they tended to nucleate at preexisting P s(a)-90° DWs. Irregularly curved P (c)-180° DWs exhibit the highest mobility, while migration over a short range occurs occasionally for faceted P s(a)-90° DWs. In addition, the motion of P s(a)-90° DWs and the growth/annihilation of new needle-like P s(a)-90° domains in a 20 µm-thick crystal were observed under an external electric field on an optical microscope. Most of the new needle-like P s(a)-90° domains nucleate at preexisting P s(a)-90° DWs and the former are much smaller than the latter. This is very similar to the situation for P s(a)-180° domain switching induced by electron beam poling in a transmission electron microscope. Our observations suggest the energy hierarchy for different domains of P s(c)-180° ≤ P s(a)-180° ≤ P s(a)-90° ≤ new needle-like P s(a)-90° in ferroelectric Bi4Ti3O12.

Microstruoture-Property Relationships in Magenqubnch Magnets

1987 ◽  
Vol 96 ◽  
Author(s):  
Raja K. Rishra
Keyword(s):  
Melt Spinning ◽  
Domain Walls ◽  
Magnetic Domain ◽  
Processing Parameters ◽  
Second Phase ◽  
Lorentz Microscopy ◽  
Transmission Electron ◽  
Melt Spun ◽  
Magnetic Domain Walls ◽  
Two Phases

ABSTRACTTransmission electron microscopy has been used to characterize the microstructure of Nd-Fe-B magnets produced by melt-spinning and subsequent hot-pressing/die-upsetting. For a material of starting composition Nd.135Fe.815B.05, the basic microstructure od melt-spun, hot-pressed and dieupset magnets consists of two phases. In the optimally processed melt-spun ribbons and hot-pressed samples, small and randomly oriented Nd2Fe14B grains are surrounded by a thin noncrystalline Nd-rlch phase. The die-upset material consists of closely stacked flat Nd2Fe14B grains surrounded by a second phase of approximate composition Nd7Fe3. No Nd11Fe4B4 phase is observed in these materials, but it can form if the chemical composition and/or processing parameters are varied. In all these materials, Lorentz microscopy reveals that magnetic domain walls are pinned by the second phase. The differences in the hard magnetic properties of the three kinds of MAGNEQUENCH magnets closely correlate with the differences in the distribution of Nd2Fe14B crystallites and the pinning sites.

Magnetic Properties of TbCo/(SiNx/Co)n Films

2008 ◽  
Vol 47-50 ◽  
pp. 785-788
Author(s):  
G.P. Lin ◽  
Po Cheng Kuo ◽  
P.L. Lin ◽  
Y.H. Fang ◽  
K.T. Huang
Keyword(s):  
Magnetic Properties ◽  
Electron Microscope ◽  
High Resolution ◽  
Magnetron Sputtering ◽  
Transmission Electron Microscope ◽  
Domain Walls ◽  
Film Plane ◽  
Interface Roughness ◽  
Cross Sectional ◽  
Transmission Electron

The Tb32Co68/(SiNx/Co)n films (n = 0~3) were prepared by magnetron sputtering. The magnetic anisotropy of all Tb32Co68/(SiNx/Co)n films are perpendicular to the film plane. It is found that the saturation magnetization (Ms) and perpendicular coercivity (Hc⊥ ) of the Tb32Co68/(SiNx/Co)3 film are 263 emu/cm3 and 3592 Oe, respectively. This film appears to be a promising material as a heat-assisted magnetic recording (HAMR) medium. The cross-sectional high resolution transmission electron microscope (HRTEM) images show that the interface roughness between the (SiNx/Co)n layers and TbCo layer increases as n is increased. The rough surface provides more obstacles and pinning sites that hinder the motion of the domain walls at interface between the (SiNx/Co)n layers and TbCo layer. Therefore, the Hc values are profoundly influenced by the interface roughness.

A Reproducible Selective Stain for Cardiac Sarcoplasmic Reticulum

1974 ◽  
Vol 32 ◽  
pp. 214-215
Author(s):  
R. A. Waugh ◽  
J. R. Sommer
Keyword(s):  
Complex System ◽  
Electron Microscope ◽  
Sarcoplasmic Reticulum ◽  
Transmission Electron Microscope ◽  
Electron Microscopic ◽  
Cardiac Sarcoplasmic Reticulum ◽  
Transmission Electron

Cardiac sarcoplasmic reticulum (SR) is a complex system of intracellular tubules that, due to their small size and juxtaposition to such electron-dense structures as mitochondria and myofibrils, are often inconspicuous in conventionally prepared electron microscopic material. This study reports a method with which the SR is selectively “stained” which facilitates visualizationwith the transmission electron microscope.

Surface Structure of the Spores of Glugea Weissenbergi

1969 ◽  
Vol 27 ◽  
pp. 238-239
Author(s):  
Sanford H. Vernick ◽  
Anastasios Tousimis ◽  
Victor Sprague
Keyword(s):  
Electron Microscope ◽  
Surface Structure ◽  
Transmission Electron Microscope ◽  
Mature Spore ◽  
Spore Surface ◽  
Sectioned Material ◽  
Transmission Electron ◽  
Surface Detail

Recent electron microscope studies have greatly expanded our knowledge of the structure of the Microsporida, particularly of the developing and mature spore. Since these studies involved mainly sectioned material, they have revealed much internal detail of the spores but relatively little surface detail. This report concerns observations on the spore surface by means of the transmission electron microscope.

A New High Resolution Transmission Electron Microscope with Second-Zone Objective Lens

1969 ◽  
Vol 27 ◽  
pp. 176-177 ◽  
Author(s):  
H. Tochigi ◽  
H. Uchida ◽  
S. Shirai ◽  
K. Akashi ◽  
D. J. Evins ◽  
...  
Keyword(s):  
Electron Microscope ◽  
High Resolution ◽  
Transmission Electron Microscope ◽  
Objective Lens ◽  
High Excitation ◽  
Transmission Electron ◽  
New Instrument

A New High Excitation Objective Lens (Second-Zone Objective Lens) was discussed at Twenty-Sixth Annual EMSA Meeting. A new commercially available Transmission Electron Microscope incorporating this new lens has been completed.Major advantages of the new instrument allow an extremely small beam to be produced on the specimen plane which minimizes specimen beam damages, reduces contamination and drift.

X-ray microanalysis of thin specimens in the transmission electron microscope at voltages up to 1000 Kv.

1978 ◽  
Vol 36 (1) ◽  
pp. 540-541
Author(s):  
G. Cliff ◽  
M.J. Nasir ◽  
G.W. Lorimer ◽  
N. Ridley
Keyword(s):  
Electron Microscope ◽  
Transmission Electron Microscope ◽  
Weight Fraction ◽  
Present Series ◽  
Constant Independent ◽  
X Ray ◽  
Transmission Electron ◽  
Series Of Experiments ◽  
Image Position ◽  
X Ray Absorption

In a specimen which is transmission thin to 100 kV electrons - a sample in which X-ray absorption is so insignificant that it can be neglected and where fluorescence effects can generally be ignored (1,2) - a ratio of characteristic X-ray intensities, I1/I2 can be converted into a weight fraction ratio, C1/C2, using the equationwhere k12 is, at a given voltage, a constant independent of composition or thickness, k12 values can be determined experimentally from thin standards (3) or calculated (4,6). Both experimental and calculated k12 values have been obtained for K(11<Z>19),kα(Z>19) and some Lα radiation (3,6) at 100 kV. The object of the present series of experiments was to experimentally determine k12 values at voltages between 200 and 1000 kV and to compare these with calculated values.The experiments were carried out on an AEI-EM7 HVEM fitted with an energy dispersive X-ray detector.

Aspects of microanalysis in a transmission electron microscope

1978 ◽  
Vol 36 (1) ◽  
pp. 510-511
Author(s):  
R. Sinclair ◽  
B.E. Jacobson
Keyword(s):  
Grain Size ◽  
Electron Beam ◽  
Electron Microscope ◽  
Chemical Analysis ◽  
Transmission Electron Microscope ◽  
Vapor Deposition ◽  
Critical Currents ◽  
X Ray ◽  
Fine Grain ◽  
Transmission Electron

INTRODUCTIONThe prospect of performing chemical analysis of thin specimens at any desired level of resolution is particularly appealing to the materials scientist. Commercial TEM-based systems are now available which virtually provide this capability. The purpose of this contribution is to illustrate its application to problems which would have been intractable until recently, pointing out some current limitations.X-RAY ANALYSISIn an attempt to fabricate superconducting materials with high critical currents and temperature, thin Nb3Sn films have been prepared by electron beam vapor deposition [1]. Fine-grain size material is desirable which may be achieved by codeposition with small amounts of Al2O3 . Figure 1 shows the STEM microstructure, with large (∽ 200 Å dia) voids present at the grain boundaries. Higher quality TEM micrographs (e.g. fig. 2) reveal the presence of small voids within the grains which are absent in pure Nb3Sn prepared under identical conditions. The X-ray spectrum from large (∽ lμ dia) or small (∽100 Ǻ dia) areas within the grains indicates only small amounts of A1 (fig.3).

Sign in / Sign up

Export Citation Format

Share Document