Ionic Jump Distance and Glass Transition of Polyvinyl Chloride

1971 ◽  
Vol 42 (9) ◽  
pp. 3388-3392 ◽  
Author(s):  
Masamitsu Kosaki ◽  
Koichi Sugiyama ◽  
Masayuki Ieda
Keyword(s):  
Glass Transition ◽  
Polyvinyl Chloride ◽  
Jump Distance

The Effect of Triacetin on the Plasticization Efficiency and Tensile Properties of Polyvinyl Chloride/di-2-Ethyl Hexyl Phthalate/Triacetin Compounds

2016 ◽  
Vol 1133 ◽  
pp. 206-210 ◽  
Author(s):  
Arjulizan Rusli ◽  
Nur Farhana Asul Kahar
Keyword(s):  
Molecular Weight ◽  
Tensile Strength ◽  
Glass Transition ◽  
Tensile Properties ◽  
Polyvinyl Chloride ◽  
Chemical Structure ◽  
Low Molecular Weight ◽  
Migration Ability ◽  
Elongation At Break ◽  
Before And After

The use of triacetin as an alternative plasticizer to polyvinyl chloride (PVC) was studied in term of plasticizer efficiency and tensile properties before and after ageing. The efficiency of plasticizers was evaluated based on the glass transition temperature (Tg) and the hardness value of the compounds. The Tg and hardness of all PVC/DEHP/Triacetin compounds are lower than PVC/50DEHP and PVC/50Triacetin compounds indicating synergistic plasticisation effect between both DEHP and Triacetin within the PVC compounds. The low molecular weight and chemical structure of triacetin are believed to contribute to the highest tensile strength, elongation at break and modulus of the PVC/triacetin compared with PVC/DEHP and PVC/DEHP/triacetin compounds. However, the migration ability of the triacetin plasticizer is believed to result in the biggest changes of the tensile properties of PVC compounds plasticized with triacetin before and after ageing.

A Replica Technique for the Inside Surfaces of Small Diameter Pipes and Tubes

1967 ◽  
Vol 25 ◽  
pp. 352-353
Author(s):  
T. G. Gregory
Keyword(s):  
Polyvinyl Chloride ◽  
Small Diameter ◽  
Replica Technique ◽  
Tube Size ◽  
Inside Diameter ◽  
Complete Inspection ◽  
Operating Limits

A nondestructive replica technique permitting complete inspection of bore surfaces having an inside diameter from 0.050 inch to 0.500 inch is described. Replicas are thermally formed on the outside surface of plastic tubing inflated in the bore of the sample being studied. This technique provides a new medium for inspection of bores that are too small or otherwise beyond the operating limits of conventional inspection methods.Bore replicas may be prepared by sliding a length of plastic tubing completely through the bore to be studied as shown in Figure 1. Polyvinyl chloride tubing suitable for this replica process is commercially available in sizes from 0.037- to 0.500-inch diameter. A tube size slightly smaller than the bore to be replicated should be used to facilitate insertion of the plastic replica blank into the bore.

Sign in / Sign up

Export Citation Format

Share Document