Origin of Short‐Pulse Emission by Passively Switched Lasers

1968 ◽  
Vol 39 (7) ◽  
pp. 3318-3327 ◽  
Author(s):  
J. A. Fleck
Keyword(s):  
2020 ◽  
Vol 27 (6) ◽  
pp. 063102 ◽  
Author(s):  
Damien F. G. Minenna ◽  
Alexandre Poyé ◽  
Philip Bradford ◽  
Nigel Woolsey ◽  
Vladimir T. Tikhonchuk

2006 ◽  
Vol 2 (14) ◽  
pp. 90-90
Author(s):  
Guillermo G. Giménez de Castro ◽  
Joaquim E. Rezende Costa ◽  
Adriana Válio Roque da Silva

During the rising phase of the August 30, 2002 X1.5 flare a short pulse with a total duration of 8 seconds was observed. Its background-subtracted radio spectrum ranges only from 5 to 12 GHz with a maximum flux density of approximately 900 s.f.u. at 7 GHz and a steep optically thin spectral index α ≃ 8. Maximum degree of polarization at 7 GHz is around 5%. The hard X-ray pulse emission above the background in the range of 30–150 keV observed by RHESSI is coincident in time with the microwave observation. Hard X-ray images reveal very compact (∼ 10″) footpoint sources. Below 30 keV, a thermal source is observed.


2006 ◽  
Vol 51 (12) ◽  
pp. 1409-1412
Author(s):  
V. N. Kornienko ◽  
A. P. Privezentsev

2017 ◽  
Vol 187 (11) ◽  
pp. 1280-1287 ◽  
Author(s):  
Leonid V. Keldysh

2013 ◽  
Vol 20 (2) ◽  
pp. 183-190 ◽  
Author(s):  
A. Barna ◽  
I. B. Földes ◽  
Z. Gingl ◽  
R. Mingesz

Abstract In experiments with short-pulse lasers the measurement control of the energy of the laser pulse is of crucial importance. Generally it is difficult to measure the amplitude of the pulses of short-pulse lasers using electronic devices, their response time being longer than the duration of the laser pulses. The electric response of the detector is still too fast to be directly digitized therefore a peak-hold unit can be used to allow data processing for the computer. In this paper we present a device which measures the energy of UV short (fs) pulses shot-byshot, digitizes and sends the data to the PC across an USB interface. The circuit is based on an analog peak detect and hold unit and the use of fiber optical coupling between the PC and the device provides a significant improvement to eliminate potential ground loops and to reduce conductive and radiated noise as well. The full development is open source and has been made available to download from our web page (http://www.noise.inf.u-szeged.hu/Instruments/PeakHold/).


Sign in / Sign up

Export Citation Format

Share Document