scholarly journals Role of dissimilar interfaces in thin films of cylinder-forming block copolymers

2004 ◽  
Vol 120 (2) ◽  
pp. 1127-1137 ◽  
Author(s):  
K. S. Lyakhova ◽  
G. J. A. Sevink ◽  
A. V. Zvelindovsky ◽  
A. Horvat ◽  
R. Magerle
Keyword(s):  
Thin Films ◽  
Block Copolymers

The study of interfacial reactions of nickel thin films on GaAs

1983 ◽  
Vol 41 ◽  
pp. 156-157
Author(s):  
L.J. Chen ◽  
Y.F. Hsieh
Keyword(s):  
Thin Films ◽  
Integrated Circuits ◽  
Interfacial Reactions ◽  
Metal Contacts ◽  
Nickel Thin Films ◽  
Thin Foils ◽  
The Status ◽  
Si Doped ◽  
Electron Microscopes

One measure of the maturity of a device technology is the ease and reliability of applying contact metallurgy. Compared to metal contact of silicon, the status of GaAs metallization is still at its primitive stage. With the advent of GaAs MESFET and integrated circuits, very stringent requirements were placed on their metal contacts. During the past few years, extensive researches have been conducted in the area of Au-Ge-Ni in order to lower contact resistances and improve uniformity. In this paper, we report the results of TEM study of interfacial reactions between Ni and GaAs as part of the attempt to understand the role of nickel in Au-Ge-Ni contact of GaAs.N-type, Si-doped, (001) oriented GaAs wafers, 15 mil in thickness, were grown by gradient-freeze method. Nickel thin films, 300Å in thickness, were e-gun deposited on GaAs wafers. The samples were then annealed in dry N2 in a 3-zone diffusion furnace at temperatures 200°C - 600°C for 5-180 minutes. Thin foils for TEM examinations were prepared by chemical polishing from the GaA.s side. TEM investigations were performed with JE0L- 100B and JE0L-200CX electron microscopes.

Transmission Electron Microscopy studies of texture of Cr underlayer of magnetic recording hard disk

1991 ◽  
Vol 49 ◽  
pp. 580-581
Author(s):  
L. Tang ◽  
G. Thomas ◽  
M. R. Khan ◽  
S. L. Duan
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Magnetic Recording ◽  
Magnetic Thin Films ◽  
Magnetic Films ◽  
Substrate Bias ◽  
Epitaxial Relationship ◽  
Transmission Electron

Cr thin films are often used as underlayers for Co alloy magnetic thin films, such as Co1, CoNi2, and CoNiCr3, for high density longitudinal magnetic recording. It is belived that the role of the Cr underlayer is to control the growth and texture of the Co alloy magnetic thin films, and, then, to increase the in plane coercivity of the films. Although many epitaxial relationship between the Cr underlayer and the magnetic films, such as ﹛1010﹜Co/ {110﹜Cr4, ﹛2110﹜Co/ ﹛001﹜Cr5, ﹛0002﹜Co/﹛110﹜Cr6, have been suggested and appear to be related to the Cr thickness, the texture of the Cr underlayer itself is still not understood very well. In this study, the texture of a 2000 Å thick Cr underlayer on Nip/Al substrate for thin films of (Co75Ni25)1-xTix dc-sputtered with - 200 V substrate bias is investigated by electron microscopy.

Transmission Electron Microscopy of Evaporated Perylene Thin Films

1990 ◽  
Vol 48 (2) ◽  
pp. 336-337
Author(s):  
C. Ewins ◽  
J.R. Fryer
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Molecular Electronics ◽  
High Vacuum ◽  
Amorphous Layer ◽  
Electric Heater ◽  
Transmission Electron ◽  
Polycyclic Aromatic

The preparation of thin films of organic molecules is currently receiving much attention because of the need to produce good quality thin films for molecular electronics. We have produced thin films of the polycyclic aromatic, perylene C10H12 by evaporation under high vacuum onto a potassium chloride (KCl) substrate. The role of substrate temperature in determining the morphology and crystallography of the films was then investigated by transmission electron microscopy (TEM).The substrate studied was the (001) face of a freshly cleaved crystal of KCl. The temperature of the KCl was controlled by an electric heater or a cold finger. The KCl was heated to 200°C under a vacuum of 10-6 torr and allowed to cool to the desired temperature. The perylene was then evaporated over a period of one minute from a molybdenum boat at a distance of 10cm from the KCl. The perylene thin film was then backed with an amorphous layer of carbon and floated onto copper microscope grids.

scholarly journals The role of the substrate on the mechanical and thermal stability of Pd thin films during hydrogen (de)sorption

2021 ◽  
Vol 46 (5) ◽  
pp. 4137-4153
Author(s):  
Neha Verma ◽  
Rob Delhez ◽  
Niek M. van der Pers ◽  
Frans D. Tichelaar ◽  
Amarante J. Böttger
Keyword(s):  
Thin Films ◽  
Thermal Stability ◽  
Thermal Stability Of

The role of intermediate S-polymorph towards high piezoelectricity in La-doped BiFeO3 epitaxial thin films

2021 ◽  
Vol 207 ◽  
pp. 116683
Author(s):  
Jun Young Lee ◽  
Gopinathan Anoop ◽  
Sanjith Unithrattil ◽  
WooJun Seol ◽  
Youngki Yeo ◽  
...  
Keyword(s):  
Thin Films ◽  
Epitaxial Thin Films ◽  
La Doped

The role of Ga and Bi doping on the local structure of transparent zinc oxide thin films

2021 ◽  
pp. 159489
Author(s):  
Filipe C. Correia ◽  
Joana M. Ribeiro ◽  
Alexei Kuzmin ◽  
Inga Pudza ◽  
Aleksandr Kalinko ◽  
...  
Keyword(s):  
Thin Films ◽  
Zinc Oxide ◽  
Local Structure ◽  
Oxide Thin Films ◽  
Bi Doping

Role of the interfaces in the crystallization and hysteresis mechanisms of amorphous Fe-B thin films

2021 ◽  
pp. 159276
Author(s):  
U. Urdiroz ◽  
F.J. Palomares ◽  
A. Mayoral ◽  
I.V. Soldatov ◽  
R. Schäfer ◽  
...  
Keyword(s):  
Thin Films

scholarly journals The role of pinhole structures in Mo thin films on multi-layer graphene synthesis

2020 ◽  
Vol 3 (2) ◽  
pp. 025004
Author(s):  
Seda Kizir ◽  
Wesley van den Beld ◽  
Bart Schurink ◽  
Robbert van de Kruijs ◽  
Jos Benschop ◽  
...  
Keyword(s):  
Thin Films ◽  
Layer Graphene ◽  
Graphene Synthesis
Sign in / Sign up

Export Citation Format

Share Document