Turbulence Regimes of the Solar Wind in the Region of its Acceleration and Initial Stage of Supersonic Motion

2003 ◽  
Author(s):  
L. N. Samoznaev
Keyword(s):  
Solar Wind ◽  
Initial Stage ◽  
Supersonic Motion

Saturn's E, G and F rings: modulated by the plasma sheet

1984 ◽  
Vol 75 ◽  
pp. 597
Author(s):  
E. Grün ◽  
G.E. Morfill ◽  
T.V. Johnson ◽  
G.H. Schwehm
Keyword(s):  
Solar Wind ◽  
Direct Contact ◽  
Transport Processes ◽  
Time Variable ◽  
Dust Particles ◽  
Spatial Diffusion ◽  
Drag Forces ◽  
Orbit Perturbation ◽  
Time Variations ◽  
F Ring

ABSTRACTSaturn's broad E ring, the narrow G ring and the structured and apparently time variable F ring(s), contain many micron and sub-micron sized particles, which make up the “visible” component. These rings (or ring systems) are in direct contact with magnetospheric plasma. Fluctuations in the plasma density and/or mean energy, due to magnetospheric and solar wind processes, may induce stochastic charge variations on the dust particles, which in turn lead to an orbit perturbation and spatial diffusion. It is suggested that the extent of the E ring and the braided, kinky structure of certain portions of the F rings as well as possible time variations are a result of plasma induced electromagnetic perturbations and drag forces. The G ring, in this scenario, requires some form of shepherding and should be akin to the F ring in structure. Sputtering of micron-sized dust particles in the E ring by magnetospheric ions yields lifetimes of 102to 104years. This effect as well as the plasma induced transport processes require an active source for the E ring, probably Enceladus.

Reaction couples of ceramic thin films prepared by CVD

1988 ◽  
Vol 46 ◽  
pp. 798-799
Author(s):  
D.W. Susnitzky ◽  
S.R. Summerfelt ◽  
C.B. Carter
Keyword(s):  
Thin Film ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Deposition Process ◽  
Solid State Reactions ◽  
Spatial Distributions ◽  
Diffusion Couples ◽  
Kinetics Studies ◽  
Ceramic Thin Films ◽  
Initial Stage

Solid-state reactions have traditionally been studied in the form of diffusion couples. This ‘bulk’ approach has been modified, for the specific case of the reaction between NiO and Al2O3, by growing NiAl2O4 (spinel) from electron-transparent Al2O3 TEM foils which had been exposed to NiO vapor at 1415°C. This latter ‘thin-film’ approach has been used to characterize the initial stage of spinel formation and to produce clean phase boundaries since further TEM preparation is not required after the reaction is completed. The present study demonstrates that chemical-vapor deposition (CVD) can be used to deposit NiO particles, with controlled size and spatial distributions, onto Al2O3 TEM specimens. Chemical reactions do not occur during the deposition process, since CVD is a relatively low-temperature technique, and thus the NiO-Al2O3 interface can be characterized. Moreover, a series of annealing treatments can be performed on the same sample which allows both Ni0-NiAl2O4 and NiAl2O4-Al2O3 interfaces to be characterized and which therefore makes this technique amenable to kinetics studies of thin-film reactions.

Decoration technique and surface physics

1978 ◽  
Vol 36 (1) ◽  
pp. 436-437 ◽  
Author(s):  
H. Bethge
Keyword(s):  
Diffusion Path ◽  
Special Importance ◽  
Surface Physics ◽  
Step Structure ◽  
Initial Stage ◽  
Special Cases ◽  
Atomic Surface ◽  
The Mean ◽  
Bulk Structure ◽  
Decoration Technique

Besides the atomic surface structure, diverging in special cases with respect to the bulk structure, the real structure of a surface Is determined by the step structure. Using the decoration technique /1/ it is possible to image step structures having step heights down to a single lattice plane distance electron-microscopically. For a number of problems the knowledge of the monatomic step structures is important, because numerous problems of surface physics are directly connected with processes taking place at these steps, e.g. crystal growth or evaporation, sorption and nucleatlon as initial stage of overgrowth of thin films.To demonstrate the decoration technique by means of evaporation of heavy metals Fig. 1 from our former investigations shows the monatomic step structure of an evaporated NaCI crystal. of special Importance Is the detection of the movement of steps during the growth or evaporation of a crystal. From the velocity of a step fundamental quantities for the molecular processes can be determined, e.g. the mean free diffusion path of molecules.

Nucleation and initial growth of Pd2Si crystals on Si(111)

1993 ◽  
Vol 51 ◽  
pp. 844-845
Author(s):  
Xianghong Tong ◽  
Oliver Pohland ◽  
J. Murray Gibson
Keyword(s):  
High Vacuum ◽  
Dark Field ◽  
Ultra High Vacuum ◽  
Initial Growth ◽  
Surface And Interface ◽  
Dark Field Imaging ◽  
Transmission Electron ◽  
Initial Stage ◽  
Effect Of Surface

The nucleation and initial stage of Pd2Si crystals on Si(111) surface is studied in situ using an Ultra-High Vacuum (UHV) Transmission Electron Microscope (TEM). A modified JEOL 200CX TEM is used for the study. The Si(111) sample is prepared by chemical thinning and is cleaned inside the UHV chamber with base pressure of 1x10−9 τ. A Pd film of 20 Å thick is deposited on to the Si(111) sample in situ using a built-in mini evaporator. This room temperature deposited Pd film is thermally annealed subsequently to form Pd2Si crystals. Surface sensitive dark field imaging is used for the study to reveal the effect of surface and interface steps.The initial growth of the Pd2Si has three stages: nucleation, growth of the nuclei and coalescence of the nuclei. Our experiments shows that the nucleation of the Pd2Si crystal occurs randomly and almost instantaneously on the terraces upon thermal annealing or electron irradiation.

Quantitative surface damage studies by H.R.E.M.

1989 ◽  
Vol 47 ◽  
pp. 632-633
Author(s):  
S. R. Singh ◽  
H. J. Fan ◽  
L. D. Marks
Keyword(s):  
Solar Wind ◽  
Quantitative Analysis ◽  
Surface Science ◽  
Surface Damage ◽  
Space Environment ◽  
Oxygen Desorption ◽  
The Past ◽  
Diffusion Controlled ◽  
Original Observation ◽  
Substantial Interest

Since the original observation that the surfaces of materials undergo radiation damage in the electron microscope similar to that observed by more conventional surface science techniques there has been substantial interest in understanding these phenomena in more detail; for a review see. For instance, surface damage in a microscope mimics damage in the space environment due to the solar wind and electron beam lithographic operations.However, purely qualitative experiments that have been done in the past are inadequate. In addition, many experiments performed in conventional microscopes may be inaccurate. What is needed is careful quantitative analysis including comparisons of the behavior in UHV versus that in a conventional microscope. In this paper we will present results of quantitative analysis which clearly demonstrate that the phenomena of importance are diffusion controlled; more detailed presentations of the data have been published elsewhere.As an illustration of the results, Figure 1 shows a plot of the shrinkage of a single, roughly spherical particle of WO3 versus time (dose) driven by oxygen desorption from the surface.

Anisotropy of interfacial defects in the initial stage of MOVPE GaAs growth On Si

1990 ◽  
Vol 48 (4) ◽  
pp. 592-593
Author(s):  
C. Vannuffel ◽  
C. Schiller ◽  
J. P. Chevalier
Keyword(s):  
Early Stage ◽  
Threading Dislocations ◽  
Mbe Growth ◽  
Detailed Mechanism ◽  
Si Substrates ◽  
Initial Stage ◽  
Interfacial Defects ◽  
Interfacial Dislocations ◽  
Step Growth ◽  
Essential Problem

Recently, interest has focused on the epitaxy of GaAs on Si as a promising material for electronic applications, potentially for integration of optoelectronic devices on silicon wafers. The essential problem concerns the 4% misfit between the two materials, and this must be accommodated by a network of interfacial dislocations with the lowest number of threading dislocations. It is thus important to understand the detailed mechanism of the formation of this network, in order to eventually reduce the dislocation density at the top of the layers.MOVPE growth is carried out on slightly misoriented, (3.5°) from (001) towards , Si substrates. Here we report on the effect of this misorientation on the interfacial defects, at a very early stage of growth. Only the first stage, of the well-known two step growth process, is thus considered. Previously, we showed that full substrate coverage occured for GaAs thicknesses of 5 nm in contrast to MBE growth, where substantially greater thicknesses are required.

Sign in / Sign up

Export Citation Format

Share Document