Simultaneous measurements of Seebeck coefficient and thermal conductivity across superlattice

2002 ◽  
Vol 80 (10) ◽  
pp. 1758-1760 ◽  
Author(s):  
B. Yang ◽  
J. L. Liu ◽  
K. L. Wang ◽  
G. Chen
Keyword(s):  
Thermal Conductivity ◽  
Seebeck Coefficient ◽  
Simultaneous Measurements

Simultaneous Measurements of Thermal Conductivity and Seebeck Coefficients of Roughened Nanowire Arrays

2012 ◽  
Vol 1456 ◽  
Author(s):  
J. S. Sadhu ◽  
T. Hongxiang ◽  
J. Ma ◽  
J. Kim ◽  
S. Sinha
Keyword(s):  
Thermal Conductivity ◽  
Seebeck Coefficient ◽  
Silicon Nanowires ◽  
Nanowire Array ◽  
Temperature Drop ◽  
Nanowire Arrays ◽  
Measured Temperature ◽  
Si Substrates ◽  
Seebeck Coefficients ◽  
Simultaneous Measurements

ABSTRACTWe report simultaneous measurements of thermal conductivity and Seebeck coefficient on array-scale silicon nanowires fabricated by metal assisted chemical etching. The measurements are conducted on the solid and the mesoporous nanowire arrays (NWAs) obtained from etching 1 ohm-cm and 0.002 ohm-cm Si substrates respectively. We demonstrate control on sidewall morphology and doping of the arrays that have an aspect ratio up to 20 and 30 % areal coverage. We employ differential frequency-domain measurements, separately on the array and the corresponding substrate to obtain the temperature drop and Seebeck voltage contribution of the nanowire array. The technique is validated by measurements on bulk silicon across the resistivity 0.002-1 ohm-cm. The Seebeck measurements reveal quenching of the phonon drag in the nanowires in comparison to the bulk in the measured temperature range of 300 K- 500 K. The Seebeck coefficient shows a ~18 % decrease in the solid NWAs and ~22 % increase in the mesoporous NWAs at room temperature. The thermal conductivity is close to Casimir limit for the solid wires while it drops to ~2.5 W/mK in the mesoporous nanowires.

Investigation of Thermoelectric Materials: Substitution effect of Bi on the Ag1-xPb18MTe20 (M = Sb, Bi) (x = 0, 0.14, 0.3)

2007 ◽  
Vol 1044 ◽  
Author(s):  
Mi-kyung Han ◽  
Huijun Kong ◽  
Ctirad Uher ◽  
Mercouri G Kanatzidis
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Lattice Thermal Conductivity ◽  
Substitution Effect ◽  
Dimensionless Figure Of Merit ◽  
The Matrix ◽  
Mass Fluctuation

AbstractWe performed comparative investigations of the Ag1-xPb18MTe20 (M = Bi, Sb) (x = 0, 0.14, 0.3) system to better understand the roles of Sb and Bi on the thermoelectric properties. In both systems, the electrical conductivity nearly keeps the same values, while the Seebeck coefficient decreases dramatically in going from Sb to Bi. Compared to the lattice thermal conductivity of PbTe, that of AgPb18BiTe20 is substantially reduced. The lattice thermal conductivity of the Bi analog, however, is higher than that of AgPb18SbTe20 and this is attributed largely to the decrease in the degree of mass fluctuation between the nanostructures and the matrix (for the Bi analog). As a result the dimensionless figure of merit ZT of Ag1-xPb18MTe20 (M = Bi) is found to be smaller than that of Ag1-xPb18MTe20 (M = Sb).

scholarly journals Thermoelectric Materials for Textile Applications

Molecules ◽  
2021 ◽  
Vol 26 (11) ◽  
pp. 3154
Author(s):  
Kony Chatterjee ◽  
Tushar K. Ghosh
Keyword(s):  
Thermal Conductivity ◽  
Carbon Nanotubes ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Inorganic Materials ◽  
Peltier Effect ◽  
Electronic Textiles ◽  
Heating And Cooling ◽  
Recent Attention

Since prehistoric times, textiles have served an important role–providing necessary protection and comfort. Recently, the rise of electronic textiles (e-textiles) as part of the larger efforts to develop smart textiles, has paved the way for enhancing textile functionalities including sensing, energy harvesting, and active heating and cooling. Recent attention has focused on the integration of thermoelectric (TE) functionalities into textiles—making fabrics capable of either converting body heating into electricity (Seebeck effect) or conversely using electricity to provide next-to-skin heating/cooling (Peltier effect). Various TE materials have been explored, classified broadly into (i) inorganic, (ii) organic, and (iii) hybrid organic-inorganic. TE figure-of-merit (ZT) is commonly used to correlate Seebeck coefficient, electrical and thermal conductivity. For textiles, it is important to think of appropriate materials not just in terms of ZT, but also whether they are flexible, conformable, and easily processable. Commercial TEs usually compromise rigid, sometimes toxic, inorganic materials such as bismuth and lead. For textiles, organic and hybrid TE materials are more appropriate. Carbon-based TE materials have been especially attractive since graphene and carbon nanotubes have excellent transport properties with easy modifications to create TE materials with high ZT and textile compatibility. This review focuses on flexible TE materials and their integration into textiles.

MeV Ion-Beam Bombardment Effects on The Thermoelectric Figures of Merit of Zn4Sb3 and ZrNiSn-Based half-heusler compounds

2007 ◽  
Vol 1020 ◽  
Author(s):  
S. Budak ◽  
S. Guner ◽  
C. Muntele ◽  
C. C. Smith ◽  
B. Zheng ◽  
...  
Keyword(s):  
Thin Films ◽  
Thermal Conductivity ◽  
Seebeck Coefficient ◽  
Measurement System ◽  
Ion Beam ◽  
Electrical Energy ◽  
Figures Of Merit ◽  
Material Systems ◽  
The Cross ◽  
Conductivity Of Thin Films

AbstractSemiconducting â-Zn4Sb3and ZrNiSn-based half-heusler compound thin films were prepared by co-evaporation for the application of thermoelectric (TE) materials. High-purity solid zinc and antimony were evaporated by electron beam to grow the â-Zn4Sb3thin film while high-purity zirconium powder and nickel tin powders were evaporated by electron beam to grow the ZrNiSn-based half-heusler compound thin film. Rutherford backscattering spectrometry (RBS) was used to analyze the composition of the thin films. The grown thin films were subjected to 5 MeV Si ions bombardments for generation of nanostructures in the films. We measured the thermal conductivity, Seebeck coefficient, and electrical conductivity of these two systems before and after 5 MeV Si ions beam bombardments. The two material systems have been identified as promising TE materials for the application of thermal-to-electrical energy conversion, but the efficiency still limits their applications. The electronic energy deposited due to ionization in the track of MeV ion beam can cause localized crystallization. The nanostructures produced by MeV ion beam can cause significant change in both the electrical and the thermal conductivity of thin films, thereby improving the efficiency. We used the 3ù-method measurement system to measure the cross-plane thermal conductivity ,the Van der Pauw measurement system to measure the cross-plane electrical conductivity, and the Seebeck-coefficient measurement system to measure the cross-plane Seebeck coefficient. The thermoelectric figures of merit of the two material systems were then derived by calculations using the measurement results. The MeV ion-beam bombardment was found to decrease the thermal conductivity of thin films and increase the efficiency of thermal-to-electrical energy conversion.

Thermoelectric Properties of Semiconducting Intermetallic Compounds: FeGa3and RuGa3

2003 ◽  
Vol 793 ◽  
Author(s):  
Y. Amagai ◽  
A. Yamamoto ◽  
C. H. Lee ◽  
H. Takazawa ◽  
T. Noguchi ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Electrical Resistivity ◽  
High Temperature ◽  
Seebeck Coefficient ◽  
Transport Properties ◽  
Figure Of Merit ◽  
Room Temperature ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
High Seebeck Coefficient

ABSTRACTWe report transport properties of polycrystalline TMGa3(TM = Fe and Ru) compounds in the temperature range 313K<T<973K. These compounds exhibit semiconductorlike behavior with relatively high Seebeck coefficient, electrical resistivity, and Hall carrier concentrations at room temperature in the range of 1017- 1018cm−3. Seebeck coefficient measurements reveal that FeGa3isn-type material, while the Seebeck coefficient of RuGa3changes signs rapidly from large positive values to large negative values around 450K. The thermal conductivity of these compounds is estimated to be 3.5Wm−1K−1at room temperature and decreased to 2.5Wm−1K−1for FeGa3and 2.0Wm−1K−1for RuGa3at high temperature. The resulting thermoelectric figure of merit,ZT, at 945K for RuGa3reaches 0.18.

Simultaneous enhancements in the Seebeck coefficient and conductivity of PEDOT:PSS by blending ferroelectric BaTiO3 nanoparticles

2021 ◽  
Author(s):  
Chang'an Li ◽  
Xin Guan ◽  
Shizhong Yue ◽  
Xi Zu Wang ◽  
Jianmin Li ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Properties ◽  
Low Cost ◽  
Low Thermal Conductivity ◽  
Low Toxicity ◽  
Batio3 Nanoparticles

Thermoelectric polymers have attracted great attention because of their unique merits including low thermal conductivity, low cost, non- or low toxicity and high mechanical flexibility. However, their thermoelectric properties particularly...

Band Structure and Thermoelectric Properties of Ni(x)Zn(1-x)Fe2O4

2021 ◽  
Vol 317 ◽  
pp. 28-34
Author(s):  
Joon Hoong Lim
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Band Structure ◽  
Seebeck Coefficient ◽  
Band Gap ◽  
Thermoelectric Properties ◽  
Xrd Analysis ◽  
Valence Band Maximum ◽  
Solid State Method ◽  
Ni Content

Thermoelectric materials has made a great potential in sustainable energy industries, which enable the energy conversion from heat to electricity. The band structure and thermoelectric properties of Ni(x)Zn(1-x)Fe2O4 have been investigated. The bulk pellets were prepared from analytical grade ZnO, NiO and Fe2O3 powder using solid-state method. It was possible to obtain high thermoelectric properties of Ni(x)Zn(1-x)Fe2O4 by controlling the ratios of dopants and the sintering temperature. XRD analysis showed that the fabricated samples have a single phase formation of cubic spinel structure. The thermoelectric properties of Ni(x)Zn(1-x)Fe2O4 pellets improved with increasing Ni. The electrical conductivity of Ni(x)Zn(1-x)Fe2O4 pellets decreased with increasing Ni content. The electrical conductivity of Ni(x)Zn(1-x)Fe2O4 (x = 0.0) is (0.515 x10-3 Scm-1). The band structure shows that ZnxCu1-xFe2O4 is an indirect band gap material with the valence band maximum (VBM) at M and conduction band minimum (CBM) at A. The band gap of Ni(x)Zn(1-x)Fe2O4 increased with increasing Ni content. The increasing band gap correlated with the lower electrical conductivity. The thermal conductivity of Ni(x)Zn(1-x)Fe2O4 pellets decreased with increasing Ni content. The presence of Ni served to decrease thermal conductivity by 8 Wm-1K-1 over pure samples. The magnitude of the Seebeck coefficient for Ni(x)Zn(1-x)Fe2O4 pellets increased with increasing amounts of Ni. The figure of merit for Ni(x)Zn(1-x)Fe2O4 pellets and thin films was improved by increasing Ni due to its high Seebeck coefficient and low thermal conductivity.

Photothermal Calorimetry: Simultaneous Measurements of Specific Heat and Thermal Conductivity

1992 ◽  
pp. 189-197 ◽  
Author(s):  
M. Marinelli ◽  
U. Zammit ◽  
R. Pizzoferrato ◽  
F. Scudieri ◽  
S. Martellucci ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Specific Heat ◽  
Simultaneous Measurements
Sign in / Sign up

Export Citation Format

Share Document