An all solid‐state magnetic pulse compressor with amorphous metals for pumping a repetition‐rated KrF excimer laser

1990 ◽  
Vol 61 (4) ◽  
pp. 1196-1199 ◽  
Author(s):  
Hiroshi Tanaka ◽  
Minoru Obara
Keyword(s):  
Solid State ◽  
Excimer Laser ◽  
Amorphous Metals ◽  
Magnetic Pulse ◽  
Pulse Compressor ◽  
Krf Excimer Laser ◽  
Magnetic Pulse Compressor

A 1‐kpps transversely excited atmospheric CO2laser excited by an all‐solid‐state exciter with a magnetic pulse compressor

1990 ◽  
Vol 68 (4) ◽  
pp. 1456-1459 ◽  
Author(s):  
Hidekazu Hatanaka ◽  
Hiroshi Tanaka ◽  
Minoru Obara ◽  
Katsumi Midorikawa ◽  
Hideo Tashiro
Keyword(s):  
Solid State ◽  
Magnetic Pulse ◽  
Pulse Compressor ◽  
Magnetic Pulse Compressor

scholarly journals A high-voltage, long-pulse generator based on magnetic pulse compressor and Blumlein-type rolled strip pulse forming line

2015 ◽  
Vol 33 (3) ◽  
pp. 511-518 ◽  
Author(s):  
Song Li ◽  
Jing-Ming Gao ◽  
Han-Wu Yang ◽  
Bao-Liang Qian
Keyword(s):  
Solid State ◽  
High Voltage ◽  
Pulse Generator ◽  
Average Power ◽  
Rate Capability ◽  
Rolled Strip ◽  
Magnetic Pulse ◽  
Pulse Compressor ◽  
Magnetic Pulse Compressor ◽  
Long Pulse

AbstractIn this paper, a new technical scheme of high-voltage, long-pulse generator, mostly based on solid-state power devices, including magnetic pulse compressor, Blumlein-type rolled strip pulse-forming line (RSPFL) and inductive voltage adder (IVA), is proposed and investigated numerically and experimentally. The generator has potential advantages of high average power level, high repetitive rate capability, long lifetime, and long pulse achievability, which meet the requirements of military and industrial application of the pulsed power technology. Specifically, a two-stage magnetic pulse compressor was set up with iron-based amorphous cores. Total compression ratio of the device is approximately 12 and the achieved voltage efficiency is up to 92%. Low impedance, long-duration Blumlein-type RSPFL was established with characteristic impendence and electrical length of 3 Ω and 100 ns, respectively. Mylar film was selected as the solid-state dielectric. Increased by a four-stage IVA, typical quasi-square pulse was obtained with peak current of 2.3 kA and duration over 200 ns. As the resistance of the dummy load was measured to be 60 Ω, the peak voltage was approximately 138 kV. Experiments show reasonable agreement with numerical analysis.

Optimal Matching of Magnetic Pulse Compressor

2006 ◽  
Vol 8 (2) ◽  
pp. 229-233
Author(s):  
Su Jiancang ◽  
Sun Jian ◽  
Liu Guozhi ◽  
Liu Chunliang ◽  
Ding Zhenjie
Keyword(s):  
Magnetic Pulse ◽  
Optimal Matching ◽  
Pulse Compressor ◽  
Magnetic Pulse Compressor

Investigation on Adjustable Magnetic Pulse Compressor in Power Supply System

2019 ◽  
Vol 34 (2) ◽  
pp. 1540-1547 ◽  
Author(s):  
Song Li ◽  
Jingming Gao ◽  
Hanwu Yang ◽  
Danni Zhu ◽  
Baoliang Qian ◽  
...  
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Supply System ◽  
Magnetic Pulse ◽  
Pulse Compressor ◽  
Magnetic Pulse Compressor

Jitter characteristic of series magnetic pulse compressor employed in ns trigger generator

2014 ◽  
Vol 85 (5) ◽  
pp. 053302 ◽  
Author(s):  
Jiajin Lin ◽  
Jiande Zhang ◽  
Jianhua Yang ◽  
Huibo Zhang ◽  
Yongfeng Qiu ◽  
...  
Keyword(s):  
Magnetic Pulse ◽  
Pulse Compressor ◽  
Magnetic Pulse Compressor

Design of a Low-Stray Inductance Magnetic Switch for High Compression of the Pulse Width in a Magnetic Pulse Compressor

2018 ◽  
Vol 46 (7) ◽  
pp. 2599-2604
Author(s):  
Jae-Ho Rhee ◽  
Young-Maan Cho ◽  
Ji-Eun Baek ◽  
Se-Hoon Kim ◽  
Chang-Jin Lee ◽  
...  
Keyword(s):  
Pulse Width ◽  
Magnetic Pulse ◽  
Magnetic Switch ◽  
Pulse Compressor ◽  
High Compression ◽  
Magnetic Pulse Compressor
Sign in / Sign up

Export Citation Format

Share Document