scholarly journals Particle Image Velocimetry (PIV) measurements in a water film, application to a tire rolling through a puddle

2019 ◽  
Vol 20 (8) ◽  
pp. 811 ◽  
Author(s):  
Damien Cabut ◽  
Marc Michard ◽  
Serge Simoens ◽  
Violaine Todoroff ◽  
Jean Lemaître ◽  
...  
Keyword(s):  
Particle Image Velocimetry ◽  
Measurement Method ◽  
Particle Image ◽  
Optical Measurement ◽  
Laser Sheet ◽  
Water Film ◽  
Main Flow ◽  
Piv Measurements ◽  
Image Velocimetry

A measurement method based on Particle Image Velocimetry (PIV) with refraction of the laser sheet at a window/water interface is proposed for the measurement of the velocity field of a flow, inside a water puddle, due to a tire rolling on. This study focuses on the feasibility and repeatability of this optical measurement method. The characterization of the optical properties of this measurement technique defines its accuracy. The analysis of the overall features of the flow is focused on two main flow zones in front of and around the tire. The flow inside the first zone is characterized by a global velocity of the water displaced in an area located in front of the tire. In the second zone a velocity representative of the flow in the vicinity of the tire shoulder is also defined. Correlations of both characteristic velocities with the car speed and water film height are established. New and the corresponding worn tires were tested in this work.

scholarly journals Particle Image Velocimetry for in vitro characterization of Paravalvular Leakage of TAVR-sealing concepts

2021 ◽  
Vol 7 (2) ◽  
pp. 668-671
Author(s):  
Samuel Höing ◽  
Finja Borowski ◽  
Jan Oldenburg ◽  
Sabine Illner ◽  
Alper Öner ◽  
...  
Keyword(s):  
Particle Image Velocimetry ◽  
Flow Field ◽  
Particle Image ◽  
Aortic Annulus ◽  
Piv Measurements ◽  
Paravalvular Leakage ◽  
Transcatheter Aortic Valve ◽  
Image Velocimetry

Abstract Paravalvular leakage (PVL), defined as the leakage between the aortic annulus and a transcatheter aortic valve replacement (TAVR), is verifiably associated with short- and long-term clinical outcome, especially with increased mortality. Therefore, with the ambition to reduce or even prevent PVL of next generation TAVR, it is necessary to extend the hemodynamic understanding of PVL. This study presents an in vitro flow measurement method to localize PVL during hydrodynamic characterization of TAVR and furthermore presents different design features, socalled outer skirt, to reduce PVL. Particle image velocimetry (PIV) measurements were performed for flow field assessment during hydrodynamic characterization of TAVR. Additionally, two different sealing concepts were developed to reduce PVL. The skirts were manufactured from polymeric-nonwoven and sued to pericardium-based TAVR-prototype. The prepared TAVR-prototypes were then deployed in a pathophysiological model of the aortic root with a calcification nodule of 2 mm according to ISO 5840:2021. To assess PVL, the flow field and the regurgitation volume was measured. The PIV measurements showed a clearly visible leakage jet between the TAVR-prototypes without skirt and the pathophysiological aortic annulus model. Jet velocities of up to 0.5 m/s were measured depending on presence or configuration of a PVL-preventing skirt. When implanted in the physiological annulus model without calcification nodule, PVL was hardly recognizable. The regurgitation volume of a TAVR-prototype without skirt at 5 l/min was 36.26±1.89 ml (n = 10). The developed and manufactured polymeric-nonwoven skirts reduced PVL from 37.67±1.17 ml to 18.36±1.8 ml (n = 10, TAVR-skirt-design1) and from 46.97±1.07 ml to 17.85±1.29 ml (n = 10, TAVR-skirt-design2) at 5 l/min. The localization of PVL during hydrodynamic characterization by means of PIV was successful. The sealing concepts developed in this work were very effective and led to a PVL-reduction of the tested TAVR prototypes of about 50% to 70%.

Out-of-Plane Motion Effects in Microscopic Particle Image Velocimetry

2003 ◽  
Vol 125 (5) ◽  
pp. 895-901 ◽  
Author(s):  
Michael G. Olsen ◽  
Chris J. Bourdon
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Laser Sheet ◽  
Plane Motion ◽  
Entire Volume ◽  
Measurement Volume ◽  
Microscopic Particle ◽  
Image Velocimetry ◽  
Out Of Plane ◽  
Signal Peak

In microscopic particle image velocimetry (microPIV) experiments, the entire volume of a flowfield is illuminated, resulting in all of the particles in the field of view contributing to the image. Unlike in light-sheet PIV, where the depth of the measurement volume is simply the thickness of the laser sheet, in microPIV, the measurement volume depth is a function of the image forming optics of the microscope. In a flowfield with out-of-plane motion, the measurement volume (called the depth of correlation) is also a function of the magnitude of the out-of-plane motion within the measurement volume. Equations are presented describing the depth of correlation and its dependence on out-of-plane motion. The consequences of this dependence and suggestions for limiting its significance are also presented. Another result of the out-of-plane motion is that the height of the PIV signal peak in the correlation plane will decrease. Because the height of the noise peaks will not be affected by the out-of-plane motion, this could lead to erroneous velocity measurements. An equation is introduced that describes the effect of the out-of-plane motion on the signal peak height, and its implications are discussed. Finally, the derived analytical equations are compared to results calculated using synthetic PIV images, and the agreement between the two is seen to be excellent.

scholarly journals A New Particle Image Velocimetry Technique for Turbomachinery Applications

2016 ◽  
Vol 138 (12) ◽  
Author(s):  
Sayantan Bhattacharya ◽  
Reid A. Berdanier ◽  
Pavlos P. Vlachos ◽  
Nicole L. Key
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Laser Sheet ◽  
Measurement Techniques ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Particle Image Velocimetry Technique ◽  
Optical Access ◽  
Tip Leakage ◽  
Image Velocimetry

Nonintrusive measurement techniques such as particle image velocimetry (PIV) are growing in both capability and utility for turbomachinery applications. However, the restrictive optical access afforded by multistage research compressors typically requires the use of a periscope probe to introduce the laser sheet for measurements in a rotor passage. This paper demonstrates the capability to perform three-dimensional PIV in a multistage compressor without the need for intrusive optical probes and requiring only line-of-sight optical access. The results collected from the embedded second stage of a three-stage axial compressor highlight the rotor tip leakage flow, and PIV measurements are qualitatively compared with high-frequency response piezoresistive pressure measurements to assess the tip leakage flow identification.

Time-Resolved Particle Image Velocimetry (PIV) Measurements in a Radial Diffuser Pump

2009 ◽  
Author(s):  
Jianjun Feng ◽  
Friedrich-Karl Benra ◽  
Hans Josef Dohmen
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Time Resolved ◽  
Piv Measurements ◽  
Part Load ◽  
Channel Characteristic ◽  
Image Velocimetry ◽  
Pump Stage ◽  
Low Specific Speed ◽  
Load Conditions

The truly time-variant unsteady flow in a low specific speed radial diffuser pump stage has been investigated by time-resolved Particle Image Velocimetry (PIV) measurements. The measurements are conducted at the midspan of the blades for the design condition and also for some severe part-load conditions. The instantaneous flow fields among different impeller channels are analyzed and compared in detail, and more attention has been paid to flow separations at part-load conditions. The analysis of the measured results shows that the flow separations at two adjacent impeller channels are quite different at some part-load conditions. The separations generally exhibit a two-channel characteristic.

scholarly journals Simultaneous Measurement of Free Surface Elevation and Three-Component Velocity Field Around a Translating Surface-Piercing Foil

2018 ◽  
Vol 140 (3) ◽  
Author(s):  
James Schock ◽  
Jason Dahl
Keyword(s):  
Particle Image Velocimetry ◽  
Free Surface ◽  
Velocity Field ◽  
Numerical Methods ◽  
Flow Field ◽  
Particle Image ◽  
Laser Sheet ◽  
Three Dimensional ◽  
Dynamic Mode ◽  
Image Velocimetry

Two methods are investigated to simultaneously obtain both three-dimensional (3D) velocity field and free surface elevations (FSEs) measurements near a surface piercing foil, while limiting the equipment. The combined velocity field and FSE measurements are obtained specifically for the validation of numerical methods requiring simultaneous field data and free surface measurements for a slender body shape. Both methods use stereo particle image velocimetry (SPIV) to measure three component velocities in the flow field and both methods use an off the shelf digital camera with a laser intersection line to measure FSEs. The first method is performed using a vertical laser sheet oriented parallel to the foil chord line. Through repetition of experiments with repositioning of the laser, a statistical representation of the three-dimensional flow field and surface elevations is obtained. The second method orients the vertical laser sheet such that the foil chord line is orthogonal to the laser sheet. A single experiment is performed with this method to measure the three-dimensional three component (3D3C) flow field and free surface, assuming steady flow conditions, such that the time dimension is used to expand the flow field in 3D space. The two methods are compared using dynamic mode decomposition and found to be comparable in the primary mode. Utilizing these methods produces results that are acceptable for use in numerical methods verification, at a fraction of the capital and computing cost associated with two plane or tomographic particle image velocimetry (PIV).

Sign in / Sign up

Export Citation Format

Share Document