Validation of longitudinal dynamics of Gatimaan Express model in Matlab/Simulink®

2018 ◽  
Vol 19 (3) ◽  
pp. 307
Author(s):  
Prabin Kumar Jha ◽  
Sadanand Sadashiv Gokhale
Keyword(s):  
Mathematical Model ◽  
Field Data ◽  
Longitudinal Velocity ◽  
Matlab Simulink ◽  
Longitudinal Dynamics ◽  
Research Designs ◽  
Measured Field

This paper presents a mathematical model of longitudinal dynamics of Gatimaan Express. It has one locomotive class WAP5, two generator vans, eight second class chair cars and two executive chair cars respectively. Forces associated with longitudinal dynamics of model are developed in Matlab/Simulink. Longitudinal and coupler forces as well longitudinal velocities are studied during the failure of coupler of 3rd (coach of middle train) second class chair. Validation of longitudinal velocity of the model is done by comparing simulated results with measured field data provided by Research Designs Standards Organization (RDSO), Lucknow, India.

Network analysis models – the secret for success

2004 ◽  
Vol 4 (5-6) ◽  
pp. 383-388
Author(s):  
D.M. Rogers
Keyword(s):  
Mathematical Model ◽  
Field Data ◽  
Essential Element ◽  
Distribution Networks ◽  
Automatic Calibration ◽  
Supply And Distribution ◽  
The World ◽  
Optimum Approach ◽  
Analysis Models

Water is a fundamental necessity of life. Yet water supply and distribution networks the world over are old and lacking in adequate maintenance. Consequently they often leak as much water as they deliver and provide an unacceptable quality of service to the customer. In certain parts of the world, water is available only for a few hours of the day. The solution is to build a mathematical model to simulate the operation of the real network in all of its key elements and apply it to optimise its operation. To be of value, the results of the model must be compared with field data. This process is known as calibration and is an essential element in the construction of an accurate model. This paper outlines the optimum approach to building and calibrating a mathematical model and how it can be applied to automatic calibration systems.

scholarly journals Design of PLC Integrated Process Simulation Software for Steam Generator Using Matlab Simulink

2018 ◽  
Vol 43 ◽  
pp. 01012
Author(s):  
Ikhtiander ◽  
Soekirno Santoso
Keyword(s):  
Steam Generator ◽  
Flow Rate ◽  
Field Data ◽  
Volume Flow ◽  
Differential Pressure ◽  
Steam Quality ◽  
Fuel Gas ◽  
Matlab Simulink ◽  
Simulator Program ◽  
Error Percentage

This paper describes the work done in order to make Matlab Simulink based steam generator simulator in the simulation of a steam generator. The steam generator under this research is operated with the steam quality of 72%, O2 content is 1.2%, designed steam volume flow is 3600 barrel per day at a maximum and designed fuel gas volume flow is 1300 Thousand Standard Cubic Feet (MSCF) per day at a maximum. The simulator program of the steam generator is separated into individual components consisting of Burner, Radiant, Convection, Exhaust Stack, Feedwater Pump Discharge and Steam Discharge. Within the components, thermodynamics and heat transfer principles such as conduction, convection, radiation and also conservation of mass, momentum, and energy were applied to compute the pressure values, temperature values, and flow rate values of simulated field device based on the command and setpoint from PLC. The validation process has been done with the steam generator is operating in a steady state to the 10 important process parameters of the steam generator. The error percentage calculated from a difference between the simulation result value and the actual value from field data reference divide by actual value from field data reference. The error percentage results are as following : Fuel Gas Orifice Differential Pressure : 2.39%, Fuel Gas Pressure : 1.37%, Fuel Gas Temperature : 5.95%, Fuel Gas Flow Rate : 1.25%, Feedwater Orifice Differential Pressure : 1.94%, Feedwater Pressure : 1.54%, Feedwater Flow Rate : 0.92%, Steam Orifice Differential Pressure 3.26%, Steam Discharge Pressure 1.93% and Steam Quality : 0.05%.

Soil Persistence of Dinitramine

Weed Science ◽  
1980 ◽  
Vol 28 (6) ◽  
pp. 650-654 ◽  
Author(s):  
J. A. Poku ◽  
R. L. Zimdahl
Keyword(s):  
Mathematical Model ◽  
Soil Moisture ◽  
Field Data ◽  
Soil Moisture Content ◽  
Sandy Loam ◽  
Clay Loam ◽  
First Order ◽  
Soil Persistence ◽  
Herbicide Concentration ◽  
Increasing Temperature

The effects of soil temperature, moisture, and herbicide concentration on the rate of degradation of dinitramine (N4,N4-diethyl-α,α,α-trifluoro-3,5-dinitrotoluene-2,4-diamine) were measured in clay loam and sandy loam in the laboratory. In sandy loam, the rate of degradation increased with increasing temperature. In clay loam, the rate of degradation increased from 10 to 30 C and decreased at 40 C. Soil moisture content influenced the rate of degradation in the following order: 22>11>>2.2% (air-dry) for clay loam and 12.0 = 6.0>>0.5% (air-dry) for sandy loam. First-order half-lives ranged from 3.2 at 30 C to 47 weeks at 10 C in clay loam, and 2.3 at 40 C to 31 weeks at 10 C in sandy loam. Applications in 2 yr did not cause buildup of dinitramine in the field. A mathematical model was used in an attempt to correlate laboratory and field data.

scholarly journals New “Full-Bridge Buck Inverter–DC Motor” System: Steady-State and Dynamic Analysis and Experimental Validation

Electronics ◽  
2019 ◽  
Vol 8 (11) ◽  
pp. 1216 ◽  
Author(s):  
Eduardo Hernández-Márquez ◽  
Carlos Alejandro Avila-Rea ◽  
José Rafael García-Sánchez ◽  
Ramón Silva-Ortigoza ◽  
Magdalena Marciano-Melchor ◽  
...  
Keyword(s):  
Mathematical Model ◽  
Steady State ◽  
Motor System ◽  
Circuit Simulation ◽  
Dc Motor ◽  
Matlab Simulink ◽  
Duty Cycles ◽  
System Variables ◽  
The Mathematical Model ◽  
Steady State Stability

A mathematical model of a new “full-bridge Buck inverter–DC motor” system is developed and experimentally validated. First, using circuit theory and the mathematical model of a DC motor, the dynamic behavior of the system under study is deduced. Later, the steady-state, stability, controllability, and flatness properties of the deduced model are described. The flatness property, associated with the mathematical model, is then exploited so that all system variables and the input can be differentially parameterized in terms of the flat output, which is determined by the angular velocity. Then, when a desired trajectory is proposed for the flat output, the input signal is calculated offline and is introduced into the system. In consequence, the validation of the mathematical model for constant and time-varying duty cycles is possible. Such a validation of this mathematical model is tackled from two directions: (1) by circuit simulation through the SimPowerSystems toolbox of Matlab-Simulink and (2) via a prototype of the system built by using Matlab-Simulink and a DS1104 board. The good similarities between the circuit simulation and the experimental results allow satisfactorily validating the mathematical model.

Simulation Research of Hydraulic Powerplant Mount Based on Matlab/Simulink

2014 ◽  
Vol 494-495 ◽  
pp. 180-183
Author(s):  
Min Yuan ◽  
Chong Chen ◽  
Pin Gan Cui
Keyword(s):  
Mathematical Model ◽  
Simulation Model ◽  
Mechanical Model ◽  
Simulation Research ◽  
Matlab Simulink

Firstly mechanical model of hydraulic powerplant is established. Then mathematical model of hydraulic powerplant mount is established based on the analysis of mechanical model. And the simulation model is established in Matlab/Simulink. The results of simulation are attained by calculation. On the basis of aforementioned results, the analysis is made. Finally, this paper makes a summary and outlook.

The Properties of Two-Way Cartridge Valve in Water Hydraulic through Matlab/Simulink

2012 ◽  
Vol 271-272 ◽  
pp. 1073-1076
Author(s):  
Zhen Hua Duan ◽  
Zhang Yong Wu ◽  
Qing Hui Wang ◽  
Xi Wu ◽  
Cheng Zhuo Wen
Keyword(s):  
Mathematical Model ◽  
Simulation Analysis ◽  
Point Of View ◽  
Matlab Simulink ◽  
Practical Point ◽  
Structure Characteristics ◽  
Water Hydraulic ◽  
The Mathematical Model

According to the requirements of hydraulic transmission to two-way cartridge valve, and from the practical point of view a water hydraulic two-way cartridge valve was designed. Then its structure characteristics was introduced and the mathematical model was established. The simulation analysis of the water hydraulic two-way cartridge valve has been carried out through Matlab/Simulink proving that its structure was reasonable and it had good performances.

Modelling of Virtual Synchronous Converter for Grid-Inverter Synchronization in Microgrids Applications

2016 ◽  
Vol 7 (4) ◽  
pp. 1377
Author(s):  
Md. Ruhul Amin ◽  
Shamsul Aizam Zulkifli
Keyword(s):  
Mathematical Model ◽  
Real Time ◽  
Phase Angle ◽  
Synchronous Generator ◽  
Energy Resources ◽  
Next Generation ◽  
Matlab Simulink ◽  
Voltage Frequency ◽  
Simulation Results

<span lang="EN-US">In this paper, virtual synchronous converter (VSCon) is modelled which behaves as synchronous generator including its all real-time characteristics in operating inverter. This VSCon is used to synchronize grid and inverter while integrating distributed generated power to microgrids. The frequency and voltage synchronization can be controlled by using synchronous generator mathematical model is installed into the inverter. The whole unit of VSCon operated is simulated in Matlab/Simulink for observing all consequences for synchronizing voltage, frequency and phase-angle. It is verified that the next generation energy resources can be integrated into microgrid making synchronization grid-inverter using VSCon. The simulation results are given to verify the concept of modelling VSCon functioning inverter as a synchronous generator. </span>

Post-processing of measured field data using equivalent source technique

2011 ◽  
Author(s):  
L. J. Foged ◽  
L. Scialacqua ◽  
F. Saccardi ◽  
J. L. Araque Quijano ◽  
G. Vecchi ◽  
...  
Keyword(s):  
Field Data ◽  
Post Processing ◽  
Equivalent Source ◽  
Measured Field

A practical technique for estimating service life of MSW leachate collection systems

2013 ◽  
Vol 50 (2) ◽  
pp. 165-178 ◽  
Author(s):  
R. Kerry Rowe ◽  
Yan Yu
Keyword(s):  
Numerical Model ◽  
Service Life ◽  
Field Data ◽  
Oxygen Demand ◽  
Collection System ◽  
Leachate Collection ◽  
Design Charts ◽  
Leachate Characteristics ◽  
Practical Model ◽  
Measured Field

The leachate characteristics and clogging of the leachate collection system at the Keele Valley Landfill is examined using the numerical model “BioClog”. The calculated effluent leachate concentrations (e.g., the chemical oxygen demand and calcium concentrations) and calculated calcium fraction in the clog material are in encouraging agreement with measured field data. A new practical model is developed and calibrated against the data from the sophisticated numerical model to estimate the service life of leachate collection systems in typical municipal solid waste (MSW) landfills. The procedures for using the new practical model are provided and illustrated by examples. Design charts are presented that may aid the design of leachate collection systems for typical MSW landfills.

Study on the Vector Control of PMSM Based on a New Controller

2011 ◽  
Vol 403-408 ◽  
pp. 3170-3173
Author(s):  
Wen Ying Xiao ◽  
Qing Yun Pu
Keyword(s):  
Mathematical Model ◽  
Vector Control ◽  
Permanent Magnet ◽  
Control Strategy ◽  
Permanent Magnet Synchronous Motor ◽  
Matlab Simulink ◽  
Static Responses ◽  
Rotor Flux ◽  
Pr Controller ◽  
Vector Control Strategy

Based on anglicizing characteristics of the proportional resonance controller (resonant, PR), against the defects of the PR controller, combined with permanent magnet synchronous motor mathematical model, a rotor flux oriented vector control strategy based on a novel improve the PR controller is introduced. Finally, MATLAB /simulink was used to simulate the model above. The system got good dynamic and static responses, verifying the correctness and feasibility of the proposed method.

Sign in / Sign up

Export Citation Format

Share Document