From powders to plating[ellipsis (horizontal)]. Surface coating by ionic bombardment!

1981 ◽  
Vol 60 (7-8) ◽  
pp. 37
Keyword(s):  
Surface Coating ◽  
Horizontal Surface ◽  
Ionic Bombardment

Antithrombin III Binding to Surface Immobilized Heparin and Its Relation to F Xa Inhibition

1987 ◽  
Vol 58 (04) ◽  
pp. 1064-1067 ◽  
Author(s):  
K Kodama ◽  
B Pasche ◽  
P Olsson ◽  
J Swedenborg ◽  
L Adolfsson ◽  
...  
Keyword(s):  
Molecular Weight ◽  
Ionic Strength ◽  
Surface Coating ◽  
Antithrombin Iii ◽  
Lower Class ◽  
Biologically Active ◽  
High Affinity ◽  
Heparin Coating ◽  
Continuous Surface ◽  
Approximate Molecular Weight

SummaryThe mode of F Xa inhibition was investigated on a thromboresistant surface with end-point attached partially depoly-merized heparin of an approximate molecular weight of 8000. Affinity chromatography revealed that one fourth of the heparin used in surface coating had high affinity for antithrombin III (AT). The heparin surface adsorbed AT from both human plasma and solutions of purified AT. By increasing the ionic strength in the AT solution the existence of high and low affinity sites could be shown. The uptake of AT was measured and the density of available high and low affinity sites was found to be in the range of 5 HTid 11 pic.omoles/cmf, respectively Thus the estimated density of biologically active high and low ailmity heparm respectively would be 40 and 90 ng/cm2 The heparin coating did not take up or exert F Xa inhibition by itself. With AT adsorbed on both high and low affinity heparin the surface had the capacity to inhibit several consecutive aliquots of F Xa exposed to the surface. When mainly high affinity sites were saturated with AT the inhibition capacity was considerably lower. Tt was demonstrated that the density of AT on both high and low affinity heparin determines the F Xa inhibition capacity whereas the amount of AT on high affinity sites limits the rate of the reaction. This implies that during the inhibition of F Xa there is a continuous surface-diffusion of AT from sites of a lower class to the high affinity sites where the F Xa/AT complex is formed and leaves the surface. The ability of the immobilized heparin to catalyze inhibition of F Xa is likely to be an important component for the thromboresistant properties of a heparin coating with non-compromized AT binding sequences.

Effects of Surface Coating on the Critical Heat Flux for Pool Boiling from a Downward Facing Surface

2004 ◽  
Vol 11 (2) ◽  
pp. 133-150 ◽  
Author(s):  
M. B. Dizon ◽  
J. Yang ◽  
F. B. Cheung ◽  
J. L. Rempe ◽  
K. Y. Suh ◽  
...  
Keyword(s):  
Heat Flux ◽  
Critical Heat Flux ◽  
Surface Coating ◽  
Pool Boiling

Cyclic fatigue comparison among endodontic instruments with similar cross section and different surface coating

2019 ◽  
Vol 68 (2) ◽  
Author(s):  
Eugenio Pedullà ◽  
Gianluca Plotino ◽  
Mauro Scibilia ◽  
Nicola M. Grande ◽  
Daniele De Santis ◽  
...  
Keyword(s):  
Cross Section ◽  
Surface Coating ◽  
Cyclic Fatigue
Sign in / Sign up

Export Citation Format

Share Document