Low frequency sound sources: statement of problem and some possible solutions

1967 ◽  
Vol 33 (4) ◽  
pp. 263
Author(s):  
B.S. McCartney
Keyword(s):  
Low Frequency ◽  
Sound Sources ◽  
Frequency Sound

Ground Attenuation Factor Based on Measurements

2021 ◽  
Vol 263 (3) ◽  
pp. 3436-3447
Author(s):  
Dan Lin ◽  
Andrew Eng
Keyword(s):  
Near Field ◽  
Attenuation Factor ◽  
Measurement Data ◽  
Low Frequency ◽  
Sound Sources ◽  
Frequency Sound ◽  
Sound Levels ◽  
Different Types ◽  
Noise Measurements ◽  
Field Sound

Assumptions made on the ground types between sound sources and receivers can significantly impact the accuracy of environmental outdoor noise prediction. A guideline is provided in ISO 9613-2 and the value of ground factor ranges from 0 to 1, depending on the coverage of porous ground. For example, a ground absorption factor of 1 is suggested for grass ground covers. However, it is unclear if the suggested values are validated. The purpose of this study is to determine the sound absorption of different types of ground by measurements. Field noise measurements were made using an omnidirectional loudspeaker and two microphones on three different types of ground in a quiet neighborhood. One microphone was located 3ft from the loudspeaker to record near field sound levels in 1/3 and 1 octave bands every second. The other microphone was located a few hundred feet away to record far field sound in the same fashion as the near field microphone. The types of ground tested were concrete, grass, and grass with trees. Based on the measurement data, it was found that grass and trees absorb high frequency sound well and a ground factor of 1 may be used for 500Hz and up when using ISO 9613-2 methodology. However, at lower frequencies (125 Hz octave band and below), grassy ground reflects sound the same as concrete surfaces. Trees absorb more low frequency sound than grass, but less than ISO 9613-2 suggested.

SOFTWARE DEVELOPMENT FOR ESTIMATION OF LOW FREQUENCY SOUND PROPAGATION IN GAS GUIDES OF POWER PLANTS TAKING TO ACCOUNT ACTIVE SOUND SOURCES

2020 ◽  
Vol 5 (4) ◽  
pp. 36-44
Author(s):  
A V Vasilyev
Keyword(s):  
Sound Source ◽  
Power Plants ◽  
Sound Propagation ◽  
Combustion Engine ◽  
Source Parameters ◽  
Low Frequency ◽  
Sound Sources ◽  
Software Application ◽  
Frequency Sound ◽  
Exhaust Noise

This paper is devoted to the problems of modelling and calculation of propagation of low frequency sound in gas guides of power plants taking to account active sound sources. The structure of software for prediction and calculation of low-frequency sound propagation in gas guides have described. Software uses four-pole method and takes to account radiation from additional (active) sound course. By using software it is possible to estimate sound source parameters to provide efficient sound attenuation. Examples of software application to calculation of intake and exhaust noise of internal combustion engine are described. The results of calculations show the possibilities of four-pole method software using to design acoustically the parameters of gas guides and mufflers for the different fields of applications.

Active Control of Low-Frequency Sound Radiation From Vibrating Panel Using Planar Sound Sources

2001 ◽  
Vol 124 (1) ◽  
pp. 2-9 ◽  
Author(s):  
Kean Chen ◽  
Gary H. Koopmann
Keyword(s):  
Active Control ◽  
Near Field ◽  
Low Frequency ◽  
Sound Radiation ◽  
Sound Field ◽  
Sound Power ◽  
Frequency Range ◽  
Sound Sources ◽  
Frequency Sound ◽  
Secondary Sources

Active control of low frequency sound radiation using planar secondary sources is theoretically investigated in this paper. The primary sound field originates from a vibrating panel and the planar sources are modeled as simply supported rectangular panels in an infinite baffle. The sound power of the primary and secondary panels are calculated using a near field approach, and then a series of formulas are derived to obtain the optimum reduction in sound power based on minimization of the total radiate sound power. Finally, active reduction for a number of secondary panel arrangements is examined and it is concluded that when the modal distribution of the secondary panel does not coincide with that of the primary panel, one secondary panel is sufficient. Otherwise four secondary panels can guarantee considerable reduction in sound power over entire frequency range of interest.

An adaptive model for the location of low-frequency sound sources in shallow sea environments

2021 ◽  
Vol 171 ◽  
pp. 107569
Author(s):  
Xianbin Sun ◽  
Xinming Jia ◽  
Yi Zheng ◽  
Zhen Wang
Keyword(s):  
Low Frequency ◽  
Adaptive Model ◽  
Shallow Sea ◽  
Sound Sources ◽  
Frequency Sound
Sign in / Sign up

Export Citation Format

Share Document