scholarly journals Model predictive duty cycle control for three‐phase Vienna rectifiers

2022 ◽  
Author(s):  
Bo Xu ◽  
Kaipei Liu ◽  
Xiaohong Ran ◽  
Qing Huai
Keyword(s):  
Duty Cycle ◽  
Three Phase

scholarly journals Low-Complexity Dual-Vector-Based Predictive Control of Three-Phase PWM Rectifiers Without Duty-Cycle Optimization

IEEE Access ◽  
2020 ◽  
Vol 8 ◽  
pp. 77049-77059 ◽  
Author(s):  
Xiaolong Shi ◽  
Jianguo Zhu ◽  
Li Li ◽  
Dylan Dah-Chuan LU
Keyword(s):  
Predictive Control ◽  
Duty Cycle ◽  
Low Complexity ◽  
Dual Vector ◽  
Three Phase ◽  
Pwm Rectifiers

Three-phase Half-controlled Boost PFC Rectifier With New Variable Duty Cycle Control

2018 ◽  
Author(s):  
Douglas C. Morais ◽  
Falcondes J.M. de Seixas ◽  
Lucas C. Souza ◽  
Luciano S.C. e Silva ◽  
Joao C.P. Junior
Keyword(s):  
Duty Cycle ◽  
Three Phase

scholarly journals Model Predictive Voltage Control with Optimal Duty Cycle for Three-Phase Grid-Connected Inverter

2019 ◽  
Vol 2019 ◽  
pp. 1-13
Author(s):  
Shahrouz Ebrahimpanah ◽  
Qihong Chen ◽  
Liyan Zhang ◽  
Misbawu Adam
Keyword(s):  
Steady State ◽  
Duty Cycle ◽  
Tracking Error ◽  
Voltage Control ◽  
Sampling Period ◽  
Sampling Interval ◽  
Nonlinear Load ◽  
Three Phase ◽  
Switching State ◽  
Steady State Performance

This paper proposes a model predictive voltage control (MPVC) strategy with duty cycle control for grid-connected three-phase inverters with output LCL filter. The model of the system is used to predict the capacitor filter voltage according to the future output current for each possible switching state at each sampling period. Then the cost function for each prediction is determined and the switching state is selected. In the proposed method, two voltage vectors are applied during one sampling interval to achieve better steady-state performance. Finally, the optimal duration of the nonzero voltage vector is defined based on the duty cycle optimization, which is vital to the control system. The proposed strategy offers a better reference tracking error with less THD in linear and nonlinear load situations. The effectiveness of the proposed method has been verified by MATLAB/Simulink and experimental results exhibit a better steady-state performance with less sampling frequency.

Model Predictive Direct Power Control of Three-Phase Grid-Connected Converters With Fuzzy-Based Duty Cycle Modulation

2018 ◽  
Vol 54 (5) ◽  
pp. 4875-4885 ◽  
Author(s):  
Amir Masoud Bozorgi ◽  
Hosein Gholami-Khesht ◽  
Mehdi Farasat ◽  
Shahab Mehraeen ◽  
Mohammad Monfared
Keyword(s):  
Power Control ◽  
Duty Cycle ◽  
Direct Power ◽  
Direct Power Control ◽  
Three Phase ◽  
Grid Connected Converters

scholarly journals INVERTER PWM UNTUK MENGGERAKKAN MESIN ARUS SEARAH TANPA SIKAT BERBASIS ARDUINO

2020 ◽  
Vol 7 (4) ◽  
pp. 68
Author(s):  
Sony Prakarsa Putra ◽  
Zulwisli Zulwisli
Keyword(s):  
Electric Vehicles ◽  
Duty Cycle ◽  
Pulse Width ◽  
Pulse Width Modulation ◽  
Voltage Source ◽  
Pwm Inverter ◽  
Dc Voltage ◽  
Unidirectional Flow ◽  
Three Phase ◽  
Frequency Pulse

This study aims to create a PWM inverter that can drive the Brushless Unidirectional Flow Machine (MASTS). PWM inverters are intended to correct deficiencies in six-step inverters. Inverter is a circuit that is used to convert a DC voltage source into an AC voltage with a certain frequency. The use of inverters is found in electric vehicles. The system often used to control an inverter is a Pulse Width Modulation (PWM) based control, where pulse width is used to regulate speed. The inverter is tested using 3 pairs of mosfets as a switch to control the three-phase output of the inverter. In the inverter, PWM is used to adjust the width of the frequency pulse that will be given to the mosfet. This research used 3 variations of duty cycle 30%, 60%, 90% to determine the effect of MASTS speed on PWM by using a PWM inverter. The results of this study the speed of MASTS can be influenced by changes in duty cycle, with increasing value of the duty cycle, the faster the speed of MASTS, and vice versa. Keywords:Mosfet, Sensor Hall, MASTS, PWM, Inverter.

scholarly journals Comparison of Voltage-Vector Control based on Duty Cycle Analysis in Three-Phase Four-Leg System Active Filter

2016 ◽  
Vol 6 (4) ◽  
pp. 1395
Author(s):  
Indriarto Yuniantoro ◽  
Rudy Setiabudy ◽  
Ridwan Gunawan
Keyword(s):  
Vector Control ◽  
Duty Cycle ◽  
Active Filter ◽  
Control Technique ◽  
Boundary Line ◽  
Reference Vector ◽  
Voltage Vector ◽  
Duration Time ◽  
Three Phase

Comparison of voltage vector control in various forms of tetrahedron that result from switching combination on three-phase four-leg system active filter is presented especially asymmetric tetrahedron shape which is a projection pqr-coordinate into αβ0-coordinate. Parameter tetrahedrons such as modulation boundary-line, reference vector, switching duration time and duty cycle are described. Duty cycle analysis conducted on the Shen’s model, the Zhang’s model, the Perales’s model and asymmetric’s model are presented. The characteristics results showed that switching combination of each IGBT conductor especially its reviews on the neutral wire. Asymmetric tetrahedron can be proposed as control technique in three-phase four-leg system active filter.

scholarly journals Performance Analysis of Three Phase Two Quadrant Controlled Converter for DC Load Applications

2019 ◽  
pp. 679-685
Author(s):  
S. T. Siddharthan ◽  
O. R. Sai Ayyappa ◽  
K. Karthik Kumar
Keyword(s):  
Performance Analysis ◽  
Power Factor ◽  
Duty Cycle ◽  
Harmonic Distortion ◽  
Input Current ◽  
Current Waveform ◽  
Harmonic Content ◽  
Low Duty Cycle ◽  
Three Phase ◽  
Fft Analysis

This paper provides the operation and analysis of three phase two quadrant controlled converter. In this paper, the converter is being checked with varying the duty cycle for two different loads R and RL. The Power factor, Total Harmonic Distortion (THD) and efficiency are better for very low duty cycle which is the same for RL load. This analysis estimates THD and power factor at various conditions. The FFT analysis is done to find the harmonic content present in the input current waveform. This analysis is done using MATLAB software.

Sign in / Sign up

Export Citation Format

Share Document