Analysis of simple electrical systems using complex impedance differential and difference equations

2011 ◽  
pp. 117-152
Keyword(s):  
Difference Equations ◽  
Complex Impedance ◽  
Electrical Systems

Effect of MCl (M = Na, K) addition on microstructure and electrical conductivity of forsterite

2020 ◽  
Vol 92 (1) ◽  
pp. 10901
Author(s):  
Saloua El Asri ◽  
Hamid Ahamdane ◽  
Lahoucine Hajji ◽  
Mohamed El Hadri ◽  
Moulay Ahmed El Idrissi Raghni ◽  
...  
Keyword(s):  
Heat Treatment ◽  
Electrical Conductivity ◽  
Single Phase ◽  
Sol Gel ◽  
Complex Impedance ◽  
Transmission Spectra ◽  
Electrical Measurements ◽  
Cation Type ◽  
Edx Analyses ◽  
The Fourier Transform

Forsterite single phase powder Mg2SiO4 was synthesized by sol–gel method alongside with heat treatment, using two different cation alkaline salts MCl as mineralizers (M = Na, K) with various mass percentages (2.5, 5, 7.5, and 10 wt.%). In this work, we report on the effect of the cation type and the added amount of used mineralizer on microstructure and electrical conductivity of Mg2SiO4. The formation of forsterite started at 680–740  °C and at 630–700  °C with KCl and NaCl respectively, as shown by TG-DTA and confirmed by XRD. Furthermore, the Fourier transform infrared (FTIR) transmission spectra indicated bands corresponding to vibrations of forsterite structure. The morphology and elemental composition of sintered ceramics were examined by SEM-EDX analyses, while their densities, which were measured by Archimedes method, increased with addition of both alkaline salts. The electrical measurements were performed by Complex Impedance Spectroscopy. The results showed that electrical conductivity increased with the addition of both mineralizers, which was higher for samples prepared with NaCl than those prepared with KCl.

Modeling of electrical systems powered by generator sets for long railway tunnels

2020 ◽  
Author(s):  
Regina Lamedica ◽  
Fabio Massimo Gatta ◽  
Alessandro Ruvio ◽  
Francesco Olevano ◽  
Guido Guidi Buffarini ◽  
...  
Keyword(s):  
Electrical Systems ◽  
Generator Sets

An Analysis of On-Bord High-Voltage Converters of Single-Phase Alternating Current with Increased Miroelectric Power Factor

2020 ◽  
Vol 10 (10) ◽  
pp. 44-51
Author(s):  
Yury Yu. SKOROKHOD ◽  
◽  
Sehgey I. VOL’SKIY ◽  
Keyword(s):  
High Voltage ◽  
Single Phase ◽  
Input Current ◽  
Voltage Converter ◽  
Input Unit ◽  
Power Circuit ◽  
Electrical Systems ◽  
Static Converters ◽  
Technical Requirements

The power circuit arrangements of on-board high-voltage static converters fed from a 3000 V AC single-phase network that in the general case produce multi-channel AC and DC output voltages are considered. The basic technical requirements posed to such converters are formulated. The general structural diagram of high-voltage converters with improved electric power consumption quality is given. Possible power circuit arrangements for the high-voltage converter input unit based on single-phase input current correction devices are considered. A classification and criteria for comparative evaluation of the possible power circuit arrangements of these devices are proposed. The information presented in the article will be of interest for specialists engaged in designing on-board electrical systems involving high-voltage converters that must comply with strict requirements for the quality of consumed single-phase input current.

Sign in / Sign up

Export Citation Format

Share Document