Compatibility between rolling stock and train detection systems

Author(s):  
M. Petkova
Author(s):  
Monique Stewart ◽  
Edward Flynn ◽  
Hamed Pouryousef ◽  
Som P. Singh ◽  
Anand Prabhakaran

The Federal Railroad Administration (FRA) has partnered with Metro-North Railroad (MNR), Long Island Rail Road (LIRR) and New York & Atlantic Railway (NYA) to promote operations safety through implementation of wayside detection systems and technologies. Under this partnership, opportunities were identified to enhance safety operations through the analysis of existing and planned wheel impact load detector (WILD) installations and operational procedures, including recommendations for future wayside detection systems implementations on these networks. Currently, MNR has a four-detector system operating near the Grand Central Terminal, since 2010. This paper includes an analysis of this WILD system and its impact on rolling stock maintenance. The analysis shows that the WILD system has gradually reduced the annual average number of high impact load wheels from 0.32/car in 2010 to 0.27/car in 2015. Review of data from the detectors on four tracks at the WILD site shows that train operations below a certain speed has a significant effect on the detection rate and should be a major consideration in selecting a location for WILD installation. The data show that the highest number of high impact wheels is detected in the month of November, potentially due to leaves on the rails during fall season. Our analysis shows that the currently used trigger threshold of dynamic ratio (DR)≥3 at MNR provides well-reasoned balance between the available fleet, maintenance demand and the maintenance shop capacity. At this threshold setting, the number of wheels detected per million wheel passages is quite small indicating a well maintained fleet.


2019 ◽  
Vol 294 ◽  
pp. 03016
Author(s):  
Dominik Adamski ◽  
Krzysztof Ortel ◽  
Juliusz Furman

Axle counters are more and more often applied in train detection systems. The wheel sensor is a main part of each axle counter system. In parallel, more and more complex railway vehicles, especially traction ones, are a potential source of interferences influencing the operation of these train detection systems. It is the reason to verify the electromagnetic compatibility (EMC) between the signalling equipment, particularly train detection systems and new vehicles in the process of obtaining the permission for their exploitation. The measurement of interfering magnetic fields generated by vehicles is one of tests to be carried out. For the simplification and unification purpose of the applied interference test methods the EN 50238 standard and TS 50238-3 technical specification were developed. The specification defines unified testing procedures. However, it is necessary to verify if it may replace different testing methods used in particular European states. It is the goal of the European research project financed from the TEN-T network resources.


Sign in / Sign up

Export Citation Format

Share Document