scholarly journals Location for single‐phase grounding fault in distribution network based on equivalent admittance distortion rate

2021 ◽  
Author(s):  
Yougen Chen ◽  
Junbo Yin ◽  
Zhiyong Li ◽  
Renyong Wei
Keyword(s):  
Single Phase ◽  
Distribution Network ◽  
Distortion Rate

scholarly journals A novel fault section locating method based on distance matching degree in distribution network

2021 ◽  
Vol 6 (1) ◽  
Author(s):  
Zhenxing Li ◽  
Jialing Wan ◽  
Pengfei Wang ◽  
Hanli Weng ◽  
Zhenhua Li
Keyword(s):  
Single Phase ◽  
Distribution Network ◽  
Matlab Simulink ◽  
Grounding Resistance ◽  
Blind Zone ◽  
System Transition ◽  
Transition Resistance ◽  
Zero Sequence ◽  
Matching Degree ◽  
Amplitude Characteristics

AbstractFault section location of a single-phase grounding fault is affected by the neutral grounding mode of the system, transition resistance, and the blind zone. A fault section locating method based on an amplitude feature and an intelligent distance algorithm is proposed to eliminate the influence of the above factors. By analyzing and comparing the amplitude characteristics of the zero-sequence current transient components at both ends of the healthy section and the faulty section, a distance algorithm with strong abnormal data immune capability is introduced in this paper. The matching degree of the amplitude characteristics at both ends of the feeder section are used as the criterion and by comparing with the set threshold, the faulty section is effectively determined. Finally, simulations using Matlab/Simulink and PSCAD/EMTDC show that the proposed section locating method can locate the faulty section accurately, and is not affected by grounding mode, grounding resistance, or the blind zone.

MULTI UNITS OF SINGLE PHASE DISTRIBUTED GENERATION COMBINED WITH BATTERY ENERGY STORAGE FOR PHASE POWER BALANCING IN DISTRIBUTION NETWORK

2016 ◽  
Vol 78 (10-4) ◽  
Author(s):  
Amirullah Amirullah ◽  
Mochamad Ashari ◽  
Ontoseno Penangsan ◽  
Adi Soeprijanto
Keyword(s):  
Energy Storage ◽  
Single Phase ◽  
Low Voltage ◽  
Distribution Network ◽  
Battery Energy Storage ◽  
Current Harmonics ◽  
Line Current ◽  
Distributed Generators ◽  
Distribution Line ◽  
Battery Energy

Randomly installed distributed generators (DGs) in households may cause unbalanced line current in a distribution network. This research presents a battery energy system for balancing of line current in a distribution network involving multi units of single phase photovoltaic (PV) distributed generators (DGs). In this paper, the PV generators were simulated consisting of a buck-boost DC/DC converter and single phase DC/AC inverter. It was connected to the distribution line through the low voltage 220 volt 50 Hz. The proposed phase balancing system uses battery energy storage and three single phase bidirectional inverters. The inverter is capable of injecting current or absorbing power from the line to the battery. This inverter operation is arranged to balance each distribution line separately, as well as to improve other power quality parameters, such as voltage and current harmonics. Simulation results show that the system was capable of improving the unbalanced line current from 15.59 % to 11, 48 % and unbalanced line voltage from 1.76 % to 0.58 %. The system was able for increasing current harmonics from 0.98 % to 1.03% and voltage harmonics from 38.96% to 39.08%.

scholarly journals Single-Phase-to-Earth Faulty Feeder Detection in Power Distribution Network Based on Amplitude Ratio of Zero-Mode Transients

IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 117678-117691 ◽  
Author(s):  
Nan Peng ◽  
Kai Ye ◽  
Rui Liang ◽  
Tianyu Hou ◽  
Guanhua Wang ◽  
...  
Keyword(s):  
Power Distribution ◽  
Single Phase ◽  
Zero Mode ◽  
Amplitude Ratio ◽  
Distribution Network ◽  
Power Distribution Network

Research on Single-Phase Grounding Fault in Distribution Networks with a DC Power Positioning Method

2014 ◽  
Vol 530-531 ◽  
pp. 353-356
Author(s):  
Run Sheng Li
Keyword(s):  
Power Distribution ◽  
Single Phase ◽  
Distribution Network ◽  
Distribution Networks ◽  
Power Distribution Network ◽  
Power Outage ◽  
Location Method ◽  
Fault Resistance ◽  
Ground Fault ◽  
Positioning Method

Due to the high ground fault resistance and the complexity of power distribution network structure (such as too many nodes, branches and too long lines), adopting common traveling wave method and ac injection method can not effectively locate the single-phase grounding fault in the distribution network system.To solve above problems and determine the position of the point of failure prisely, this paper adopted the dc location method of injecting the dc signal from the point of failure under the power outage offline. This paper introduces the single phase dc method and the method of three phase dc, and the simulation shows that the dc location method is effective and feasible.

Sign in / Sign up

Export Citation Format

Share Document