scholarly journals Revisiting the active power direction method

Author(s):  
Polina Shcherbakova ◽  
Gennady Senderovych ◽  
Alexander Abramovitz
Keyword(s):  
2020 ◽  
Vol 42 (13) ◽  
pp. 2569-2577
Author(s):  
Pragya Joshi ◽  
Sachin K Jain

Due to significant increment in harmonic polluting loads in the power system, there has been enhanced attention of the power professionals towards the estimation of harmonic signals and identification of their sources in the system. Harmonic source identification is an important step for proper accountability, monitoring, and mitigation of any harmonic pollution. The active power direction (APD) method is one of the conventional approaches for harmonic source detection in the distribution system. Although it is simple and easy to implement, serious concerns were raised on its validity, as the direction of active power is dependent on the phase angle. In this paper, APD is augmented with distorting and non-distorting power to improve its accuracy and reliability for harmonic source identification. The distorting and non-distorting portions of the loads are separated, and the distorting and non-distorting powers are calculated at each node. These calculated powers, in addition to the direction of the harmonic active power, are used to formulate the logic required for deciding the severity index at each node. The validity of the method has been tested on a single-phase network, an IEEE-5 bus system, and an IEEE-14 bus system. It has been observed that the proposed method provides good results than conventional APD with the same measurement requirement.


Author(s):  
Fangwei Xu ◽  
Honggeng Yang ◽  
Jinshuai Zhao ◽  
Zhiqi Wang ◽  
Yamei Liu

2018 ◽  
Vol 1 (1) ◽  
pp. 54-66
Author(s):  
Rakan Khalil Antar ◽  
Basil Mohammed Saied ◽  
Rafid Ahmed Khalil

A new control strategy for active power filters is proposed, modeled and implemented in order to improve the power quality of a line commutated converter High voltage DC link. The ability of reactive power and harmonics reductions are generally met by using passive and active power filters. In this paper, modified active power filter with a modified harmonics pulse width modulation algorithm is used to minimize the source harmonics and force the AC supply current to be in the same phase with AC voltage source at both sending and receiving sides of a line commutated converter high voltage DC link. Therefore, it is considered as power factor corrector and harmonics eliminator with random variations in the load current. The modified harmonics pulse width modulation algorithm is applicable for active power filter based on a three-phase five-level and seven-level cascaded H-bridge voltage source inverter. Simulation results show that the suggested modified multilevel active power filters improve total harmonics distortion of both voltage and current with almost unity effective power factor at both AC sides of high voltage DC link. Therefore, modified active power filter is an effective tool for power quality improvement and preferable for line commutated converter high voltage DC link at different load conditions.


2017 ◽  
Vol 2017 (3) ◽  
pp. 65-70
Author(s):  
A.F. Zharkin ◽  
◽  
V.A. Novskyi ◽  
N.N. Kaplychnyi ◽  
A.V. Kozlov ◽  
...  

2016 ◽  
Vol 2016 (4) ◽  
pp. 23-25
Author(s):  
A.V. Krasnozhon ◽  
◽  
R.O. Buinyi ◽  
I.V. Pentegov ◽  
◽  
...  

Sign in / Sign up

Export Citation Format

Share Document