BER measurements in frequency-division-multiplexed optical loop buffer at data rate of 2.5 Gbit/s

1994 ◽  
Vol 30 (22) ◽  
pp. 1869-1871 ◽  
Author(s):  
Y. Yamada ◽  
K. Sasayama ◽  
K. Habara
Author(s):  
HARSHA PRAKASH ◽  
C.D. SURIYAKALA

To meet the requirements of high data rate, third generation partnership project (3GPP) has come across the development of long term evolution (LTE). High data rate can be achieved with the help of an advanced modulation method. Orthogonal Frequency Division Multiple Access (OFDMA) was considered as a modulation method especially in the downlink of the communication systems. It gives many advantages like frequency diversity, increased capacity and robustness against impulse noise. Besides these advantages, a major drawback of OFDMA is its high peak-to-average power ratio (PAPR). High PAPR affects the system by lowering the power amplifier efficiency, increased complexity as well as shorter battery life. In case of uplink communication, where better peak power characteristics benefit the mobile terminals with respect to power efficiency, OFDMA is not a possible solution. To handle such situations, 3GPP has introduced a modified form of OFDMA which is known as Single-Carrier Frequency Division Multiple Access (SC-FDMA). It provides same advantages as OFDMA along with low PAPR. To further improve the bit error rate (BER) performance of the system and power amplifier efficiency Multiple-Input Multiple-Output (MIMO) can be extended to SC-FDMA system. This paper surveys causes, effects and possible solutions of high PAPR in a communication system.


2017 ◽  
Vol 2017 ◽  
pp. 1-9
Author(s):  
Xuanxuan Tian ◽  
Tingting Zhang ◽  
Qinyu Zhang ◽  
Zhaohui Song

In order to improve both the transmission data rate and the range resolution simultaneously in integrated radar-communication (RadCom) systems, orthogonal frequency-division multiplexing with phase-coded and stepped-frequency (OFDM-PCSF) waveform is proposed. A corresponding high resolution range (HRR) profile generation method is also presented. We first perform OFDM-PCSF waveform design by combining the intrapulse phase coding with the interpulse stepped-frequency modulation. We then give the ambiguity function (AF) based on the presented waveforms. Then, the synthetic range profile (SRP) processing to achieve HRR performance is analyzed. Theoretical analysis and simulation results show that the proposed methods can achieve HRR profiles of the targets and high data rate transmissions, while a relative low computational complexity can be achieved.


2019 ◽  
Vol 4 (1) ◽  
pp. 64-69
Author(s):  
BB Harianto

Salah satu permasalahan dalam perkembangan teknologi telekomunikasi yaitu bagaimana mencapai data rate yang besar namun dengan bandwidth yang tidak lebih besar dari bandwidth koheren kanal untuk menghindari terjadinya Inter-Symbol Interference (ISI). Salah satu solusi yang ditawarkan yaitu transmisi multi-carrier. Cara kerja transmisi multi-carrier yaitu membagi total bandwidth signal yang tersedia menjadi beberapa subcarrier-subcarrier dengan bandwidth yang sempit. Sehingga bandwith masingmasing subcarrier yang dihasilkan tersebut menjadi lebih kecil jika dibandingkan dengan bandwidth koheren kanal. Salah satu transmisi multicarrier yang terbaru yaitu Orthogonal Frequency Division Multiplexing (OFDM) dimana subcarrier-subcarrier dapat saling tegak lurus satu sama lain sehingga bendwidth yang dibutuhkan menjadi lebih efisien jika dibandingkan dengan multicarrier konvensional seperti FDM. Sistem OFDM dapat diimplementasikan pada USRP yang merupakan salah satu jenis SDR (Software Defined Radio). SDR merupakan sistem pemancar dan penerima yang menggunakan pemrosesan sinyal digital untuk coding, decoding, modulasi dan demodulasi data. USRP tersebut digunakan sebagai model pemancar dan penerima pada pengukuran kualitas unjuk kerja sistem OFDM dengan barbagai kondisi. Pengukuran ini akan membandingkan hasil performansi parameter – parameter pada frekwensi 910 MHz dan 2.4 GHz. Spesifikasi sistem OFDM yang digunakan pada penelitian ini menggunakan software Labview dan dilakukan pada lingkungan indoor pada jarak 3m dan bandwidth 1 MHz. Hasil dari implementasi dan pengukuran menunjukkan bahwa parameter yang ditunjukkan oleh frekwensi 910 MHz lebih baik dari pada nilai parameter yang ditunjukkan oleh frekwensi 2.4


2016 ◽  
Vol 15 (2) ◽  
pp. 60 ◽  
Author(s):  
Chaeriah Bin Ali Wael ◽  
Winy Desvasari ◽  
R. Priyo Hartono Adji

Orthogonal Frequency Division Multiplexing (OFDM) merupakan teknik modulasi multicarrier yang banyak diadopsi oleh berbagai teknologi komunikasi nirkabel untuk memenuhi kebutuhan akses broadband yang kian meningkat karena menyediakan transmisi dengan data rate tinggi. Selain itu, OFDM juga tahan terhadap efek multipath fading. Salah satu permasalahan utama pada sistem ini adalah tingginya nilai PAPR yang menyebabkan penggunaan power amplifier menjadi tidak efisien. Sebagai solusi permasalahan ini, teknik Selected Mapping (SLM) dan Partial Transmit Sequence (PTS) digunakan untuk mereduksi nilai PAPR. Kedua teknik ini dipilih karena efisien dalam mereduksi nilai PAPR. Dari hasil simulasi yang dilakukan terhadap 1000 simbol OFDM, kedua teknik ini memberikan reduksi PAPR yang semakin besar untuk jumlah subblok yang semakin banyak. Selanjutnya, kinerja kedua teknik ini dibandingkan. Dengan jumlah subblok yang sama, SLM memiliki performansi yang lebih baik dalam mereduksi PAPR dibandingkan dengan PTS.


2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Heena Arora ◽  
Vishal Sharma

Abstract Free space optics (FSO) systems have gained considerable attention because of their numerous features and services. It has evolved into a promising technology for high data rate transmission in wireless communication systems. However, there are some atmospheric effects which inhibit its performance. In this paper, performance of code division multiple access–free space optics (CDMA–FSO) by combining multidiagonal (MD) codes and orthogonal frequency division multiplexing–free space optics (OFDM-FSO) systems over using advance line coding formats under the sway of turbulence conditions are investigated and compared. A comparative study has shown that CDMA–FSO offers better SNR with both CSRZ and AMI coding format under diverse conditions at data rate 15 and 20 Gbps.


Sign in / Sign up

Export Citation Format

Share Document