scholarly journals Area‐detection fibre‐optic system for spatially offset Raman spectroscopy and Raman tomography in reflection mode

2015 ◽  
Vol 51 (21) ◽  
pp. 1684-1686 ◽  
Author(s):  
Zhiyong Wang ◽  
Hao Yang ◽  
Hao Ding ◽  
Guijin Lu ◽  
Huabei Jiang ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Fibre Optic ◽  
Optic System ◽  
Reflection Mode ◽  
Fibre Optic System

scholarly journals Fibre Optic System for Monitoring Rotational Seismic Phenomena

Sensors ◽  
2014 ◽  
Vol 14 (3) ◽  
pp. 5459-5469 ◽  
Author(s):  
Anna Kurzych ◽  
Leszek Jaroszewicz ◽  
Zbigniew Krajewski ◽  
Krzysztof Teisseyre ◽  
Jerzy Kowalski
Keyword(s):  
Fibre Optic ◽  
Optic System ◽  
Fibre Optic System

Clock recovery for a 5 Gbit/s fibre-optic system

1982 ◽  
Vol 18 (13) ◽  
pp. 547 ◽  
Author(s):  
B. Bentland ◽  
L.A. Bergman ◽  
R. Tell ◽  
S.T. Eng
Keyword(s):  
Clock Recovery ◽  
Fibre Optic ◽  
Optic System ◽  
Fibre Optic System

scholarly journals Photon Force MEMS cantilever combined with fibre optic system as a measurement technique for optomechanical studies

2021 ◽  
Author(s):  
Karolina Anna Orłowska ◽  
Bartosz Michał Świadkowski ◽  
Andrzej Sierakowski ◽  
Teodor Gotszalk
Keyword(s):  
Measurement Technique ◽  
Mass Force ◽  
Fibre Optic ◽  
Optic System ◽  
Resolution Limit ◽  
Microelectromechanical System ◽  
Adjustment Procedure ◽  
Balance System ◽  
Mems Sensor ◽  
Fibre Optic System

Abstract In this paper we present a metrological measurement technique that is a combination of fibre optic interferometry and a microelectromechanical system (MEMS) sensor for photon force (PF) measurement with traceability via an electromagnetic way. The main advantage of the presented method is the reference to the current balance, which is the primary mass/force metrological standard. The MEMS cantilever is a transducer of the photon force to the deflection that can be compensated with the use of the Lorentz force. This movement is measured with the use of the interferometer and does not require any mechanical calibration. Combining the MEMS current balance system with the interferometry is then the unique and fully metrological solution. The resolution of the proposed measurement technique is calculated to be 4 pN//Hz^(0.5) (2% uncertainty). The PF–MEMS used for the investigation is the cantilever with the resolution of 46 fN/Hz0.5, which was calculated from the thermomechanical noise, and is far below the whole system resolution limit. As far as the whole construction is based on the fibre optic system, it does not require any complex adjustment procedure and may work as an optomechanical reference in any metrological laboratory.

Sign in / Sign up

Export Citation Format

Share Document