Automatic fault location on distribution network using voltage sags measurements

2005 ◽  
Author(s):  
Haiyu Li ◽  
A.S. Mokhar ◽  
N. Jenkins
Keyword(s):  
Fault Location ◽  
Distribution Network ◽  
Voltage Sags

A generalized fault location method based on voltage sags for distribution network

2013 ◽  
Vol 8 (S1) ◽  
pp. S38-S46 ◽  
Author(s):  
Lilik Jamilatul Awalin ◽  
Hazlie Mokhlis ◽  
AbHalim Abu Bakar ◽  
Hasmaini Mohamad ◽  
Hazlee A. Illias
Keyword(s):  
Fault Location ◽  
Distribution Network ◽  
Voltage Sags ◽  
Location Method

scholarly journals Real Fault Location in a Distribution Network Using Smart Feeder Meter Data

Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3242
Author(s):  
Hamid Mirshekali ◽  
Rahman Dashti ◽  
Karsten Handrup ◽  
Hamid Reza Shaker
Keyword(s):  
Fault Location ◽  
Network Reliability ◽  
Distribution Network ◽  
Estimation Method ◽  
Electrical Energy ◽  
Distribution Networks ◽  
Active Power ◽  
Financial Loss ◽  
Smart Meters ◽  
The Real

Distribution networks transmit electrical energy from an upstream network to customers. Undesirable circumstances such as faults in the distribution networks can cause hazardous conditions, equipment failure, and power outages. Therefore, to avoid financial loss, to maintain customer satisfaction, and network reliability, it is vital to restore the network as fast as possible. In this paper, a new fault location (FL) algorithm that uses the recorded data of smart meters (SMs) and smart feeder meters (SFMs) to locate the actual point of fault, is introduced. The method does not require high-resolution measurements, which is among the main advantages of the method. An impedance-based technique is utilized to detect all possible FL candidates in the distribution network. After the fault occurrence, the protection relay sends a signal to all SFMs, to collect the recorded active power of all connected lines after the fault. The higher value of active power represents the real faulty section due to the high-fault current. The effectiveness of the proposed method was investigated on an IEEE 11-node test feeder in MATLAB SIMULINK 2020b, under several situations, such as different fault resistances, distances, inception angles, and types. In some cases, the algorithm found two or three candidates for FL. In these cases, the section estimation helped to identify the real fault among all candidates. Section estimation method performs well for all simulated cases. The results showed that the proposed method was accurate and was able to precisely detect the real faulty section. To experimentally evaluate the proposed method’s powerfulness, a laboratory test and its simulation were carried out. The algorithm was precisely able to distinguish the real faulty section among all candidates in the experiment. The results revealed the robustness and effectiveness of the proposed method.

scholarly journals Research on Fault Location in Distribution Network Based on Fast Fault Transfer Arc Extinguishing Device

2020 ◽  
Vol 605 ◽  
pp. 012001
Author(s):  
Zhang Xinyu ◽  
Nie Yu ◽  
Wang Yanan ◽  
Zhao Dan ◽  
Du Wei ◽  
...  
Keyword(s):  
Fault Location ◽  
Distribution Network
Sign in / Sign up

Export Citation Format

Share Document