The correlation of PD-charge and -energy patterns in the study of partial discharge mechanism in thermosetting insulation

Author(s):  
B. Florkowska
2011 ◽  
Vol 5 (2) ◽  
pp. 59-66 ◽  
Author(s):  
B. Florkowska ◽  
P. Zydron ◽  
M. Florkowski ◽  
J. Roehrich

2013 ◽  
Vol 133 (1) ◽  
pp. 114-120
Author(s):  
Hiroki Kojima ◽  
Takafumi Suzuki ◽  
Naoki Hayakawa ◽  
Masahiro Hanai ◽  
Hitoshi Okubo

Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2518
Author(s):  
Marek Florkowski

This paper describes a novel observation on partial discharges (PDs), which occur despite the absence of an applied voltage, within a chopped sequence. It was found that additional discharge pulses occur when a specimen is subjected to chopped sequences rather than a continuous sinusoid. The discharge pulses, called Partial Discharge Echoes (PDE), appeared in time intervals (where no voltage was being applied), immediately after the specimen had been exposed to a base waveform (e.g., sinusoidal) above a partial discharge inception level. The chopped timing is composed of a multiple series of packets consisting of base waveforms, with each packet being separated in time by a defined delay period. The presented experiments were performed on specimens with an embedded gaseous void, in thermosetting insulation and glass as a non-polar material, for comparison. Acquisition of the echo signal was performed in the phase-resolved mode, modifying the synchronization path and the settings. In contrast to continuous sinusoidal PD measurements, the chopped approach might provide a deeper insight into key PD phenomena, such as inception, propagation, time lag, post-discharge time decay, and effective surface area. Special focus was paid to the transition point between sinusoidal phase and the echo interval. The various scenarios of an echo mechanism, depending on the coincidence of remnant polarization field and the field accumulated on void walls, are discussed.


Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 478
Author(s):  
Tapiwa Venge ◽  
Cuthbert Nyamupangedengu

The supply voltage frequency effect on partial discharge (PD) phenomena has continued to draw research interest. Although most high voltage equipment operates at power frequency (50/60 Hz), testing is often done at different frequencies for various reasons. Despite some agreements and inconsistencies for the research findings of PD activity’s frequency dependence, there has been consensus on the recognition of the discharge mechanism parameters that influence how the supply voltage frequency affects PD activity. These parameters include statistical time lag, discharge area surface conductivity, and the residual charge decay. In this paper, a 3-capacitor model (ABC) is used to simulate how the changes in the discharge mechanism parameters influence PD characteristics as a function of the supply voltage frequency. The findings are that the phase-resolved partial discharge pattern (PRPDP) and PD repetition rate (PDRR) characteristics are more sensitive to variations in the probability of the seed electron availability at higher frequencies of the supply voltage. The opposite trend is observed for the cavity surface resistance. At lower resistance of cavity surface, the PRPDP and PDRR characteristics are more sensitive to changes in the supply voltage frequency than at higher resistances. The paper also confirms that incorporating equivalent resistances in the ABC model makes it more authentic than the model comprising of capacitors only.


Sign in / Sign up

Export Citation Format

Share Document