scholarly journals FPGA SerDes Capability as Switch mode PA Modulator

2014 ◽  
Author(s):  
K. Finnerty ◽  
J. Dooley ◽  
R. Farrell
Keyword(s):  
Switch Mode

Integrated Current Sensing Technique Suitable for Step-Down Switch-Mode Power Converters

2009 ◽  
Vol E92-C (10) ◽  
pp. 1299-1303
Author(s):  
Xiaojuan XIA ◽  
Liang XIE ◽  
Weifeng SUN ◽  
Longxing SHI
Keyword(s):  
Power Converters ◽  
Current Sensing ◽  
Switch Mode ◽  
Step Down

scholarly journals Evaluation of VTH and RON Drifts during Switch-Mode Operation in Packaged SiC MOSFETs

Electronics ◽  
2021 ◽  
Vol 10 (4) ◽  
pp. 441
Author(s):  
Marcello Cioni ◽  
Alessandro Bertacchini ◽  
Alessandro Mucci ◽  
Nicolò Zagni ◽  
Giovanni Verzellesi ◽  
...  
Keyword(s):  
Field Effect Transistors ◽  
Oxide Semiconductor ◽  
Driving Voltage ◽  
Drain Voltage ◽  
Current Increase ◽  
Mode Operation ◽  
Switch Mode ◽  
Gate Signal ◽  
A Current ◽  
Parameter Monitoring

In this paper, we investigate the evolution of threshold voltage (VTH) and on-resistance (RON) drifts in the silicon carbide (SiC) power metal-oxide-semiconductor field-effect transistors (MOSFETs) during the switch-mode operation. A novel measurement setup for performing the required on-the-fly characterization is presented and the experimental results, obtained on commercially available TO-247 packaged SiC devices, are reported. Measurements were performed for 1000 s, during which negative VTH shifts (i.e., VTH decrease) and negative RON drifts (i.e., RON decrease) were observed. To better understand the origin of these parameter drifts and their possible correlation, measurements were performed for different (i) gate-driving voltage (VGH) and (ii) off-state drain voltage (VPH). We found that VTH reduction leads to a current increase, thus yielding RON to decrease. This correlation was explained by the RON dependence on the overdrive voltage (VGS–VTH). We also found that gate-related effects dominate the parameter drifts at low VPH with no observable recovery, due to the repeated switching of the gate signal required for the parameter monitoring. Conversely, the drain-induced instabilities caused by high VPH are completely recoverable within 1000 s from the VPH removal. These results show that the measurement setup is able to discern the gate/drain contributions, clarifying the origin of the observed VTH and RON drifts.

Sign in / Sign up

Export Citation Format

Share Document