Detection of Changes in Intrathoracic Fluid in Man Using Electrical Impedance Tomography

1994 ◽  
Vol 87 (1) ◽  
pp. 97-101 ◽  
Author(s):  
J. H. Campbell ◽  
N. D. Harris ◽  
F. Zhang ◽  
A. H. Morice ◽  
B. H. Brown

1. The Sheffield electrical impedance tomography system produces information on changes in the distribution of resistivity within tissue. We report on the assessment of electrical impedance tomography in monitoring changes in lung resistivity during a fluid challenge in normal man. 2. Eight normal subjects were studied. Electrical impedance tomography recordings were made at three different lung volumes before, during and after the intravenous infusion of 1 litre of 0.9% NaCl (saline). 3. The mean fall in lung resistivity during the infusion was −22% at total lung capacity (range −10% to −28%), −24% at tidal breathing (−15% to −37%) and −11% at residual volume (-5% to −19%) (P < 0.05 mean pre-infusion resistivity compared with the nadir value after infusion, Wilcoxon). 4. These changes in lung resistivity were probably due to a combination of a fall in haematocrit and an expansion of pulmonary blood volume.

Author(s):  
Bruno Furtado de Moura ◽  
francisco sepulveda ◽  
Jorge Luis Jorge Acevedo ◽  
Wellington Betencurte da Silva ◽  
Rogerio Ramos ◽  
...  

IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 61570-61580 ◽  
Author(s):  
Weichen Li ◽  
Junying Xia ◽  
Ge Zhang ◽  
Hang Ma ◽  
Benyuan Liu ◽  
...  

2019 ◽  
Vol 20 (7) ◽  
pp. 707 ◽  
Author(s):  
Michal Malík ◽  
Jiří Primas ◽  
Michal Kotek ◽  
Darina Jašíková ◽  
Václav Kopecký

The mixing of two immiscible phases is a process commonly seen in many industrial applications. Whether it is desirable (e.g. mixing of ingredients in chemical or food industry) or undesirable (e.g. sediments or contaminants in water purification) process, it has to be taken into consideration and a detailed description would be beneficial to any end product. This paper deals with a method for observing the volume ratio of two immiscible phases from the state of total separation to the state of a homogenous mixture using industrial Electrical Impedance Tomography (EIT) system ITS p2+. This paper also shows a great advantage in combining the EIT measuring method with a theoretically derived formula. It is used to calculate the concentration of a non-conductive phase in the final mixture using the initial and final conductivity values. The authors were also able to show a possibility to successfully use the formula in situations, where the initial conditions for it are not fully met.


Sign in / Sign up

Export Citation Format

Share Document