scholarly journals A comparison of the activity of phosphatidylinositol phosphodiesterase against substrate in dispersions and as monolayers at the air-water interface

1975 ◽  
Vol 149 (1) ◽  
pp. 199-208 ◽  
Author(s):  
P J Quinn ◽  
Y Barenholz
Keyword(s):  
Reaction Rate ◽  
Substrate Surface ◽  
Phospholipid Bilayers ◽  
Initial Surface ◽  
Water Interface ◽  
Ph Optimum ◽  
Bivalent Ions ◽  
Rate Of Reaction ◽  
Air Water Interface ◽  
Zero Order Reaction

The activity of phosphatidylinositol phosphodiesterase, purified from rat brain, against substrate in three forms, (a) multibilayer liposomes, (b) single bilayer vesicles of phosphatidylinositol and (c) phosphatidylinositol oriented as monolayers at the air-water interface, was examined. The reaction rate was similar against the two substrate dispersions prepared with the same phospholipid concentration, although there was a large difference in substrate surface area available to the enzyme, and this similarity could not be accounted for by any differences in the microviscosity of the hydrocarbon region of the phospholipid bilayers. The reaction showed apparent zero-order reaction kinetics until about 10% of the substrate had been degraded, whereupon the rate decreased. The reaction against monolayers of phosphatidylinositol was linear throughout the entire digestion of the film, provided that more than 0.25 mg of enzyme was present in the subphase. The pH optimum was 6.6. Bivalent ions)Ca2+, Mg2+, Co2+, Ni2+ and Mn2+) facilitated enzyme penetration into substrate monolayers, but the enzyme was only activated by Ca2+ (optimal concentration, 1mM) and to a lesser extent by Mg2+. The reaction rate was independent of initial surface pressures of less than about 22mN·m-1 but at higher pressures the rate decreased. This decrease could be prevented by the addition of 10mol of octadecylamine/90mol of phosphatidylinositol to the substrate monolayer; the amine did not increase the rate of reaction in films of less than 22mN·m-1.

scholarly journals Synthesis and monolayer film of a series of new twin-tailed gemini cationic surfactants at the air/water interface

2008 ◽  
Vol 6 (3) ◽  
pp. 477-481 ◽  
Author(s):  
Zhi Chen ◽  
Yujun Feng ◽  
Dongliang Zhou ◽  
Puxin Zhu ◽  
Dacheng Wu
Keyword(s):  
Surface Pressure ◽  
Gemini Surfactants ◽  
Limited Area ◽  
Initial Surface ◽  
Water Interface ◽  
Spacer Length ◽  
Collapse Pressure ◽  
Initial Area ◽  
Air Water Interface ◽  
Pressure Area

AbstractA series of new dimeric surfactants, twin-tailed gemini surfactants, 2(12)-s-2(12), were successfully prepared and characterized, and their monolayer films investigated by the measurement of surface pressure-area (π-A) and surface pressure-time (π-t) isotherms at the air/water interface by a Langmuir film balance. Compared to their monomeric counterparts, their collapse pressure (γcollapse) is smaller, whilst all the molecular area parameters are larger. The limited area (Alimited) and the initial area (Ainitial) of these twin-tailed gemini surfactants change with increasing spacer length s, and the surface pressure decreases with increasing time. It was also found that the higher the initial surface pressure, the larger the attenuation.

scholarly journals Kinetics of Thermal Degradation of Recycled Polyvinyl Chloride Resin

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
I. M. Alwaan
Keyword(s):  
Thermal Degradation ◽  
Polyvinyl Chloride ◽  
Reaction Rate ◽  
Reaction Rate Constant ◽  
Rate Of Reaction ◽  
Different Temperatures ◽  
Zero Order Reaction ◽  
Enthalpy And Entropy ◽  
Kinetics Of ◽  
Entropy Of Reaction

The goal of this study is to find the effect of time and temperature on the thermal degradation of recycled polyvinyl chloride (PVC) resin. The isothermal rate of reaction(r)of recycled PVC resin was investigated at the following temperatures to: 100, 110, 120, 130, and 140°C at period of times ranging from 10 to 50 min. The result shows that the rate of reaction(r)of recycled PVC increases with increasing temperatures. The reaction rate constant(K)for temperatures ranging from 100 to 140°C was doubled from 0.028–0.056 mol·L−1·S−1. The process was found to be zero order reaction at all range of temperatures 100–140°C. The activation energy of the thermal weight loss was calculated at different temperatures(E/R = 2739.5°K). The average enthalpy and entropy of reaction at temperature of 298°K were determined.

scholarly journals Characterization of the lipid-binding domain of the Plasmodium falciparum CTP:phosphocholine cytidylyltransferase through synthetic-peptide studies

2003 ◽  
Vol 375 (3) ◽  
pp. 653-661 ◽  
Author(s):  
Marie-Pierre LARVOR ◽  
Rachel CERDAN ◽  
Catherine GUMILA ◽  
Luc MAURIN ◽  
Patrick SETA ◽  
...  
Keyword(s):  
Plasmodium Falciparum ◽  
Surface Pressure ◽  
Hydrophobic Interactions ◽  
Lipid Binding ◽  
Binding Domain ◽  
Helical Conformation ◽  
Initial Surface ◽  
Water Interface ◽  
Ctp:Phosphocholine Cytidylyltransferase ◽  
Air Water Interface

Phospholipid biosynthesis plays a key role in malarial infection and is regulated by CCT (CTP:phosphocholine cytidylyltransferase). This enzyme belongs to the group of amphitropic proteins which are regulated by reversible membrane interaction. To assess the role of the putative membrane-binding domain of Plasmodium falciparum CCT (PfCCT), we synthesized three peptides, K21, V20 and K54 corresponding to residues 274–294, 308–327 and 274–327 of PfCCT respectively. Conformational behaviour of the peptides, their ability to bind to liposomes and to destabilize lipid bilayers, and their insertion properties were investigated by different biophysical techniques. The intercalation mechanisms of the peptides were refined further by using surface-pressure measurements on various monolayers at the air/water interface. In the present study, we show that the three studied peptides are able to bind to anionic and neutral phospholipids, and that they present an α-helical conformation upon lipid binding. Peptides V20 and the full-length K54 intercalate their hydrophobic parts into an anionic bilayer and, to a lesser extent, a neutral one for V20. Peptide K21 interacts only superficially with both types of phospholipid vesicles. Adsorption experiments performed at the air/water interface revealed that peptide K54 is strongly surface-active in the absence of lipid. Peptide V20 presents an atypical behaviour in the presence of phosphatidylserine. Whatever the initial surface pressure of a phosphatidylserine film, peptide V20 and phosphatidylserine entities seem linked together in a special organization involving electrostatic and hydrophobic interactions. We showed that PfCCT presents different lipid-dependence properties from other studied CCTs. Although the lipid-binding domain seems to be located in the C-terminal region of the enzyme, as with the mammalian counterpart, the membrane anchorage, which plays a key role in the enzyme regulation, is driven by two α-helices, which behave differently from one another.

Sampling and analysis of the air-water interface with SEM and EDS of microlayers

1989 ◽  
Vol 47 ◽  
pp. 1004-1005
Author(s):  
Randall W. Smith ◽  
John Dash
Keyword(s):  
Heavy Metals ◽  
Surface Microlayer ◽  
Surface Films ◽  
Water Interface ◽  
Physical Processes ◽  
Infrared Spectroscopic Analysis ◽  
Eds Analysis ◽  
Air Water Interface ◽  
Significant Area ◽  
Bulk Chemical

The structure of the air-water interface forms a boundary layer that involves biological ,chemical geological and physical processes in its formation. Freshwater and sea surface microlayers form at the air-water interface and include a diverse assemblage of organic matter, detritus, microorganisms, plankton and heavy metals. The sampling of microlayers and the examination of components is presently a significant area of study because of the input of anthropogenic materials and their accumulation at the air-water interface. The neustonic organisms present in this environment may be sensitive to the toxic components of these inputs. Hardy reports that over 20 different methods have been developed for sampling of microlayers, primarily for bulk chemical analysis. We report here the examination of microlayer films for the documentation of structure and composition.Baier and Gucinski reported the use of Langmuir-Blogett films obtained on germanium prisms for infrared spectroscopic analysis (IR-ATR) of components. The sampling of microlayers has been done by collecting fi1ms on glass plates and teflon drums, We found that microlayers could be collected on 11 mm glass cover slips by pulling a Langmuir-Blogett film from a surface microlayer. Comparative collections were made on methylcel1ulose filter pads. The films could be air-dried or preserved in Lugol's Iodine Several slicks or surface films were sampled in September, 1987 in Chesapeake Bay, Maryland and in August, 1988 in Sequim Bay, Washington, For glass coverslips the films were air-dried, mounted on SEM pegs, ringed with colloidal silver, and sputter coated with Au-Pd, The Langmuir-Blogett film technique maintained the structure of the microlayer intact for examination, SEM observation and EDS analysis were then used to determine organisms and relative concentrations of heavy metals, using a Link AN 10000 EDS system with an ISI SS40 SEM unit. Typical heavy microlayer films are shown in Figure 3.

Temperature Dependence of the Air/Water Interface Revealed by Polarization Sensitive Sum-Frequency Generation Spectroscopy

2018 ◽  
Author(s):  
Daniel R. Moberg ◽  
Shelby C. Straight ◽  
Francesco Paesani
Keyword(s):  
Temperature Dependence ◽  
Low Frequency ◽  
Potential Energy Function ◽  
Md Simulations ◽  
Sum Frequency Generation ◽  
Water Molecules ◽  
Water Interface ◽  
Sum Frequency ◽  
Air Water Interface ◽  
Frequency Generation

<div> <div> <div> <p>The temperature dependence of the vibrational sum-frequency generation (vSFG) spectra of the the air/water interface is investigated using many-body molecular dynamics (MB-MD) simulations performed with the MB-pol potential energy function. The total vSFG spectra calculated for different polarization combinations are then analyzed in terms of molecular auto-correlation and cross-correlation contributions. To provide molecular-level insights into interfacial hydrogen-bonding topologies, which give rise to specific spectroscopic features, the vSFG spectra are further investigated by separating contributions associated with water molecules donating 0, 1, or 2 hydrogen bonds to neighboring water molecules. This analysis suggests that the low frequency shoulder of the free OH peak which appears at ∼3600 cm−1 is primarily due to intermolecular couplings between both singly and doubly hydrogen-bonded molecules. </p> </div> </div> </div>

Sign in / Sign up

Export Citation Format

Share Document