Kinetics of the reactions of phenacyl bromide and of pare-substituted phenacyl bromides with benzoate and substituted trans-cinnamate ions

1985 ◽  
pp. 17 ◽  
Author(s):  
Chockalingam Srinivasan ◽  
Arunachalam Shunmugasundaram ◽  
Natasan Arumugam
Keyword(s):  
Phenacyl Bromide ◽  
Phenacyl Bromides ◽  
Kinetics Of

ChemInform Abstract: KINETICS OF THE REACTION OF PHENACYL BROMIDE WITH NAPHTHOATE ION

1976 ◽  
Vol 7 (6) ◽  
pp. no-no
Author(s):  
P. ANANTHAKRISHNA NADAR ◽  
C. GNANASEKARAN
Keyword(s):  
Phenacyl Bromide ◽  
Kinetics Of

scholarly journals A Three Component Protocol for the Synthesis of Aziridines using BF3·(OEt)2

2020 ◽  
Vol 32 (5) ◽  
pp. 1001-1006
Author(s):  
Shaik Firoj Basha ◽  
Shaik Anwar
Keyword(s):  
Lewis Acid ◽  
Phenacyl Bromide ◽  
Three Component Reaction ◽  
Phenacyl Bromides ◽  
Synthetic Utility

Synthesis of N-(1R,2S)-2-(bromo-3-oxo-1,3-diphenylpropyl)-4-methylbenzene sulfonamide and N-(1R,2S)-(2-bromo-3-oxo-1,3-diphenylpropyl)-4-methylbenzene sulfonamide was carried out by a three component reaction using phenacyl bromide, p-toluenesulfonamide and carboxyaldehyde in presence of mild Lewis acid such as BF3·(OEt)2 in dichloromethane. The synthetic utility of this protocol was carried out with syn-isomer to yield corresponding cis-aziridines. This protocol was operationally simple for a wide variety of substituted carboxaldehydes and substituted phenacyl bromides.

scholarly journals α-Bromo-4-amino-3-nitroacetophenone, a new reagent for protein modification. Modification of the methionine-290 residue of porcine pepsin

1980 ◽  
Vol 187 (2) ◽  
pp. 345-352 ◽  
Author(s):  
N I Tarasova ◽  
G I Lavrenova ◽  
V M Stepanov
Keyword(s):  
Enzyme Activity ◽  
Carboxy Group ◽  
Active Site ◽  
Protein Modification ◽  
Phenacyl Bromide ◽  
Enzyme Molecule ◽  
Noticeable Effect ◽  
Porcine Pepsin ◽  
Enzyme Active Site ◽  
Phenacyl Bromides

A new coloured reagent for protein modification, alpha-bromo-4-amino-3-nitroacetophenone (NH2BrNphAc), was synthesized. The reagent was found to alkylate specifically the methionine-290 residue of porcine pepsin below pH 3 at 37 degrees C, which lead to a 45% decrease of enzyme's activity towards haemoglobin. The effect of this reagent as well as that of other phenacyl bromides on the activity of pepsin appeared to be a result of steric hindrance caused by the attachment of bulky reagent residue to the edge of the cleft harbouring the enzyme active site. Only marginal reaction with the co-carboxy group of aspartic acid-315 was found under the above conditions. More pronounced esterification of carboxy groups (up to one residue per enzyme molecule) occurred when the pH was shifted to 5.2. The latter modification had no noticeable effect on enzyme activity, thus disproving a previously held assumption that pepsin inactivation by phenacyl bromide is due to the carboxy-group esterification. alpha-Bromo-4-amino-3-nitroacetophenone forms derivatives with characteristic u.v. spectra when it reacts with methionine, histidine, aspartic and glutamic acid residues, and may be recommended as a reagent for protein modification.

Electronic Effects of Aryl and Heteroaryl Groups on the Rate of Quaternization of 5-Aryl(or Heteroaryl)pyrimidines

1980 ◽  
Vol 35 (4) ◽  
pp. 468-470 ◽  
Author(s):  
David W. Allen ◽  
David J. Buckland ◽  
Barrie G. Hutley
Keyword(s):  
Substituent Effects ◽  
Phenacyl Bromide ◽  
Rate Data ◽  
Electronic Effects ◽  
Kinetics Of

The kinetics of quaternization of a series of 5-aryl- and 5-heteroarylpyrimidines with phenacyl bromide in acetonitrile have been studied in order to assess the electronic effects of the 5-substituent. The observed order of reactivity is 5-(1-methylpyrrol-2-yl) > 5-panisyl >5-(2-furyl) >5-p-tolyl > 5-(2-thienyl) >phenyl > 5-(m-chlorophenyl). The reactions are enthalpy controlled and the rate data can be accounted for in terms of the electronwithdrawing or donating ability of the 5-substituent. The substituent effects of the 2-fury 1- and 2-thienyl groups in the above reaction are significantly different from those observed in the piperidinolysis of 2-chloro-5(2-heteroaryl)pyrimidines.

Direct observations of radiation-enhanced transformations in glass

1983 ◽  
Vol 41 ◽  
pp. 354-355
Author(s):  
J. F. DeNatale ◽  
D. G. Howitt
Keyword(s):  
Glass Matrix ◽  
Diffusion Mechanism ◽  
Bubble Formation ◽  
Silicate Glasses ◽  
Phase Decomposition ◽  
Direct Observations ◽  
Thin Foils ◽  
Oxygen Bubble ◽  
Electron Energy Loss ◽  
Kinetics Of

The electron irradiation of silicate glasses containing metal cations produces various types of phase separation and decomposition which includes oxygen bubble formation at intermediate temperatures figure I. The kinetics of bubble formation are too rapid to be accounted for by oxygen diffusion but the behavior is consistent with a cation diffusion mechanism if the amount of oxygen in the bubble is not significantly different from that in the same volume of silicate glass. The formation of oxygen bubbles is often accompanied by precipitation of crystalline phases and/or amorphous phase decomposition in the regions between the bubbles and the detection of differences in oxygen concentration between the bubble and matrix by electron energy loss spectroscopy cannot be discerned (figure 2) even when the bubble occupies the majority of the foil depth.The oxygen bubbles are stable, even in the thin foils, months after irradiation and if van der Waals behavior of the interior gas is assumed an oxygen pressure of about 4000 atmospheres must be sustained for a 100 bubble if the surface tension with the glass matrix is to balance against it at intermediate temperatures.

Irradiation behavior of pyrolytic silicon carbide

1983 ◽  
Vol 41 ◽  
pp. 72-73
Author(s):  
R. J. Lauf
Keyword(s):  
Silicon Carbide ◽  
Fission Products ◽  
Thermodynamics And Kinetics ◽  
Neutron Fluences ◽  
Fuel Particles ◽  
Sic Coatings ◽  
Irradiation Behavior ◽  
Kinetics Of ◽  
Htgr Fuel

Fuel particles for the High-Temperature Gas-Cooled Reactor (HTGR) contain a layer of pyrolytic silicon carbide to act as a miniature pressure vessel and primary fission product barrier. Optimization of the SiC with respect to fuel performance involves four areas of study: (a) characterization of as-deposited SiC coatings; (b) thermodynamics and kinetics of chemical reactions between SiC and fission products; (c) irradiation behavior of SiC in the absence of fission products; and (d) combined effects of irradiation and fission products. This paper reports the behavior of SiC deposited on inert microspheres and irradiated to fast neutron fluences typical of HTGR fuel at end-of-life.

The Ordered Phase Formation in Ti-Al-Ga Alloys

1970 ◽  
Vol 28 ◽  
pp. 440-441
Author(s):  
Shiro Fujishiro ◽  
Harold L. Gegel
Keyword(s):  
Thermal Stability ◽  
High Temperature ◽  
Titanium Alloys ◽  
Growth Kinetics ◽  
Stoichiometric Composition ◽  
Good Potential ◽  
Alpha Titanium ◽  
Cold Rolled ◽  
Kinetics Of ◽  
Thermal Stability Of

Ordered-alpha titanium alloys having a DO19 type structure have good potential for high temperature (600°C) applications, due to the thermal stability of the ordered phase and the inherent resistance to recrystallization of these alloys. Five different Ti-Al-Ga alloys consisting of equal atomic percents of aluminum and gallium solute additions up to the stoichiometric composition, Ti3(Al, Ga), were used to study the growth kinetics of the ordered phase and the nature of its interface.The alloys were homogenized in the beta region in a vacuum of about 5×10-7 torr, furnace cooled; reheated in air to 50°C below the alpha transus for hot working. The alloys were subsequently acid cleaned, annealed in vacuo, and cold rolled to about. 050 inch prior to additional homogenization

Ion Beam Induced Interfacial Reactions in Molybdenum Thin Films on Silicon

1981 ◽  
Vol 39 ◽  
pp. 162-163
Author(s):  
L. J. Chen ◽  
L. S. Hung ◽  
J. W. Mayer
Keyword(s):  
Ion Beam ◽  
Chemical Vapor ◽  
Interfacial Reactions ◽  
Practical Applications ◽  
Microelectronic Devices ◽  
Recent Emergence ◽  
Chemical Vapor Deposited ◽  
Atomic Mixing ◽  
Silicon Interface ◽  
Kinetics Of

When an energetic ion penetrates through an interface between a thin film (of species A) and a substrate (of species B), ion induced atomic mixing may result in an intermixed region (which contains A and B) near the interface. Most ion beam mixing experiments have been directed toward metal-silicon systems, silicide phases are generally obtained, and they are the same as those formed by thermal treatment.Recent emergence of silicide compound as contact material in silicon microelectronic devices is mainly due to the superiority of the silicide-silicon interface in terms of uniformity and thermal stability. It is of great interest to understand the kinetics of the interfacial reactions to provide insights into the nature of ion beam-solid interactions as well as to explore its practical applications in device technology.About 500 Å thick molybdenum was chemical vapor deposited in hydrogen ambient on (001) n-type silicon wafer with substrate temperature maintained at 650-700°C. Samples were supplied by D. M. Brown of General Electric Research & Development Laboratory, Schenectady, NY.

Sign in / Sign up

Export Citation Format

Share Document