Radiation-induced redox reactions of iodine species in aqueous solution. Formation and characterisation of III, IIV, IVI and IVIII, the stability of hypoiodous acid and the chemistry of the interconversion of iodide and iodate

1985 ◽  
Vol 81 (2) ◽  
pp. 449 ◽  
Author(s):  
George V. Buxton ◽  
Robin M. Sellers
Keyword(s):  
Aqueous Solution ◽  
Redox Reactions ◽  
Iodine Species ◽  
Solution Formation ◽  
Radiation Induced ◽  
The Stability

REMOVAL OF HEAVY METAL Cr (II), Ni (II), Cu (II), Zn (II), Cd (II), Pb (II) IONS FROM AQUEOUS SOLUTION BY MENTHA PIPERITA EXTRACT

2020 ◽  
pp. 15-20
Author(s):  
Ersin Yucel ◽  
Mine Yucel
Keyword(s):  
Aqueous Solution ◽  
Metal Ions ◽  
High Efficiency ◽  
Correlation Coefficients ◽  
Langmuir Model ◽  
Mentha Piperita ◽  
Freundlich Model ◽  
Biosorption Capacity ◽  
Peppermint Extract ◽  
The Stability

In this study, the usage of the peppermint (Mentha piperita) for extracting the metal ions [Mg (II), Cr (II), Ni (II), Cu (II), Zn (II), Cd (II), Pb (II)] that exist at water was investigated. In order to analyze the stability properties, Langmuir, Freundlich, Temkin and Dubinin-Radushkevich isotherms were used at removing the metal ions and the highest correlation coefficients (R2) were obtained at Langmuir isotherm. Therefore, it is seen that the Langmuir model is more proper than the Freundlich model. However, it was found that the correlation coefficients of removing Ni and Cd is higher at Freundlich model than Langmuir and low at Dubinin-Radushkevich isotherm. It is established that the biosorption amount increase depends on the increase of biosorbent and it can be achieved high efficiency (95%) even with small amount (0.6 mg, peppermint extract) at lead ions. It is also determined that the peppermint extracted that is used at this study shows high biosorption capacity for metal ions and can be used for immobilization of metals from polluted areas.

Capillary flows and self-assembly of porous hydrate structures

2012 ◽  
Vol 9 (1) ◽  
pp. 22-25
Author(s):  
S.V. Amel’kin ◽  
D.Ye. Igoshin
Keyword(s):  
Experimental Data ◽  
Aqueous Solution ◽  
Self Assembly ◽  
Capillary Flow ◽  
Secondary Crystallization ◽  
Assembly Model ◽  
Physical Processes ◽  
Good Correspondence ◽  
Solution Formation ◽  
Capillary Flows

A self-assembly model for porous hydrate structures is proposed, which takes into account the sequence of basic physical processes: hydrate growth on the surface of the aqueous solution, formation of islet structure, capillary flow, separation and transfer of secondary crystallization nuclei to the meniscus. The model was studied within the cellular automata method. A good correspondence between the results of the simulation and the experimental data is obtained.

Schiff base equilibria. II. Beryllium complexes of N-n-butylsalicylideneimine and the hydrolysis of the Be2+ ion

1965 ◽  
Vol 18 (5) ◽  
pp. 651 ◽  
Author(s):  
RW Green ◽  
PW Alexander
Keyword(s):  
Aqueous Solution ◽  
Schiff Base ◽  
Complex Formation ◽  
Distribution Coefficient ◽  
Dilute Aqueous Solution ◽  
The Stability ◽  
Ph Range ◽  
Hydrolysis Of ◽  
Beryllium Complexes ◽  
Equilibria In Aqueous Solution

The Schiff base, N-n-butylsalicylideneimine, extracts more than 99.8% beryllium into toluene from dilute aqueous solution. The distribution of beryllium has been studied in the pH range 5-13 and is discussed in terms of the several complex equilibria in aqueous solution. The stability constants of the complexes formed between beryllium and the Schiff base are log β1 11.1 and log β2 20.4, and the distribution coefficient of the bis complex is 550. Over most of the pH range, hydrolysis of the Be2+ ion competes with complex formation and provides a means of measuring the hydrolysis constants. They are for the reactions: Be(H2O)42+ ↔ 2H+ + Be(H2O)2(OH)2, log*β2 - 13.65; Be(H2O)42+ ↔ 3H+ + Be(H2O)(OH)3-, log*β3 -24.11.

Addition of Aliphatic and Aromatic Amines to Catechol in Aqueous Solution Under Oxidizing Conditions

1989 ◽  
Vol 42 (3) ◽  
pp. 365 ◽  
Author(s):  
MK Manthey ◽  
SG Pyne ◽  
RJW Truscott
Keyword(s):  
Aqueous Solution ◽  
Aqueous Solutions ◽  
Aromatic Amines ◽  
Aliphatic Amines ◽  
Substitution Pattern ◽  
Vinylogous Amides ◽  
The Stability

The oxidation of catechol in the presence of two aliphatic and aromatic amines has been investigated. In aqueous solutions of pH 7.0 and 11.7, the substitution pattern of the adduct was dependent on the type of amine used. Aromatic amines produced 4,5-disubstituted o-quinones, whereas aliphatic amines gave either 2,4,5-trisubstituted or 2,4-disubstituted o-quinone adducts. A rationale based upon the stability of vinylogous amides is presented to account for the observed substitution pattern.

scholarly journals An Investigation into the Adsorption of Aniline from Aqueous Solution Using H-Beta Zeolites and Copper-Exchanged Beta Zeolites

2005 ◽  
Vol 23 (3) ◽  
pp. 255-266 ◽  
Author(s):  
J. O'Brien ◽  
T. Curtin ◽  
T.F. O'Dwyer
Keyword(s):  
Aqueous Solution ◽  
Adsorption Process ◽  
Zeolite Beta ◽  
Langmuir Model ◽  
Beta Zeolite ◽  
Copper Leaching ◽  
Beta Zeolites ◽  
The Stability ◽  
Ph Range ◽  
Adsorbent Materials

Zeolite beta, a large-pore zeolite, was investigated in this study with a view to examining it as a potential adsorbent for the removal of aniline from aqueous solutions. Two different metal-loaded zeolites were prepared by exchanging H-beta zeolite (SiO2/Al2O3 = 75:1) with copper. The influence of exchanged copper on the uptake level was assessed. The effect of varying the silica-to-alumina ratio of the H-beta zeolite on the aniline uptake level was also examined, using three different H-beta zeolites with ratios of 25:1, 75:1 and 150:1 as adsorbents. The sorption experiments indicated an uptake level of ca. 110–120 mg/g for each zeolite and this level was also adsorbed by the copper-modified H-beta zeolites (SiO2/Al2O3 = 75:1). In all cases, the adsorption process followed the Langmuir model for adsorption and the level of aniline adsorbed was largely unaffected by a change in temperature or the presence of extra framework copper. The stability of the exchanged copper on these zeolites was then examined by measuring the quantity of copper leached from each zeolite into solution as a function of pH. Minimum copper leaching was observed in the pH range 5–11. This provided a stable pH working range for the adsorbent materials.

Sign in / Sign up

Export Citation Format

Share Document