CaY2Al4SiO12:Ce3+, Mn2+: A single component phosphor to produce high color rendering WLEDs with blue chip

2021 ◽  
Author(s):  
Qiuhong Zhang ◽  
Junhao Li ◽  
Wei Jiang ◽  
Litian Lin ◽  
Jianhong Ding ◽  
...  
Keyword(s):  
White Light ◽  
Light Emitting Diode ◽  
Single Component ◽  
Light Emitting ◽  
Mixed Phosphors ◽  
Color Rendering ◽  
Blue Chip

A high color rendering white light emitting diode (WLED) is generally produced by combining yellow and red mixed phosphors on a blue chip. Herein we report a single component phosphor...

scholarly journals Chromaticity Study of Curcumin Dye Extracted from Curcuma longa L. Using for UV Light down Conversion for White Light Emitting Diode

2019 ◽  
Vol 290 ◽  
pp. 183-189
Author(s):  
Mahmood Al Shafouri ◽  
Naser Mahmoud Ahmed ◽  
Zainuriah Hassan ◽  
Munirah Abdullah Almessiere
Keyword(s):  
White Light ◽  
Uv Light ◽  
Light Emitting Diode ◽  
Curcuma Longa ◽  
Color Temperature ◽  
Light Emitting ◽  
Chromaticity Coordinates ◽  
Major Factors ◽  
Color Rendering ◽  
Down Conversion

In thus study, Turmeric phosphor dye was extracted from Curcuma Longa L. via a simple technique using silica gel. The phosphor was used for light down-conversion of UV light for the manufacture white light emitting diode (WLED). The UV-LED was analyzed over 395nm wavelengths. The characteristics of the white light chromaticity were controlled by tuning the current and phosphor concentration. An optimum color rendering index (CRI) value of 63.4 was obtained. The chromaticity coordinates (CIE) and correlated color temperature (CCT) were measured for various currents and phosphor concentrations. The white phosphor exhibited CIE value of 0.355,0.338 and CCT of 4567 K. The concentration of phosphor and amount of applied current were confirmed to be major factors that control the intensity of white light emitted from the sample, where CIE and CRI of the emitted light steadily increased with the concentration of phosphor and current. Thus, phosphor concentration has a critical effect on conversion efficiency. Key words: Turmeric, phosphor, WLED, curcumin

Utilization of LiSrPO4:Eu phosphor and CuInS quantum dot for fabrication of high color rendering white light-emitting diode

2013 ◽  
Vol 92 ◽  
pp. 325-329 ◽  
Author(s):  
Woo-Seuk Song ◽  
Jong-Hoon Kim ◽  
Jeong-Hoon Lee ◽  
Hye-Seung Lee ◽  
Ho Seong Jang ◽  
...  
Keyword(s):  
Quantum Dot ◽  
White Light ◽  
Light Emitting Diode ◽  
Light Emitting ◽  
Color Rendering

scholarly journals High Efficiency and Color Rendering Quantum Dots White Light Emitting Diodes Optimized by Luminescent Microspheres Incorporating

Nanophotonics ◽  
2016 ◽  
Vol 5 (4) ◽  
pp. 565-572 ◽  
Author(s):  
Wei Chen ◽  
Kai Wang ◽  
Junjie Hao ◽  
Dan Wu ◽  
Jing Qin ◽  
...  
Keyword(s):  
Quantum Dots ◽  
White Light ◽  
High Efficiency ◽  
Lattice Structure ◽  
Light Emitting Diode ◽  
Luminescent Properties ◽  
Color Temperature ◽  
High Quantum Efficiency ◽  
Light Emitting ◽  
Color Rendering

AbstractIn this research, we have developed an approach by incorporating quantum dots (QDs) with red emission into mesoporous silica microspheres through a non-chemical process and obtained luminescent microspheres (LMS). Owing to the lattice structure of LMS, QDs were effectively protected from intrinsic aggregation in matrix and surface deterioration by encapsulant, oxygen and moisture. The LMS composite has therefore maintained large extent luminescent properties of QDs, espe-cially for the high quantum efficiency. Moreover, the fabricated white light emitting diode (WLED) utilizing LMS and YAG:Ce yellow phosphor has demonstrated excellent light performance with color coordinates around (x = 0.33, y = 0.33), correlated color temperature between 5100 and 5500 K and color rendering index of Ra = 90, R9 = 95. The luminous efficiency of the WLED has reached up to a new record of 142.5 lm/W at 20 mA. LMS provide a promising way to practically apply QDs in lightings and displays with high efficiency as well as high stability.

The Color Mixing White-Light LEDs

2013 ◽  
Vol 378 ◽  
pp. 440-443
Author(s):  
Chiu Jung Yang ◽  
Chien Sheng Huang ◽  
Chih Wei Chen ◽  
Po Wen Chen
Keyword(s):  
White Light ◽  
Light Emitting Diode ◽  
Optical Power ◽  
Integrating Sphere ◽  
Light Spectrum ◽  
Light Emitting ◽  
Driver Circuit ◽  
Color Mixing ◽  
Color Rendering

Thepaperis discussedin coloruniformity study.The experiment divided into two steps in this study,first is modules design and simulation. Second is fabrication and measurement.After measure the LEDs property, calculating the ratio of each colored LEDs by using Grassmanns Law,modeling by Solidworks, and simulating the front study by optical software TracePro.Using four-color mixing with self-developed formula to avoid the present white light emitting diode patent, and the four-color grains are Red, Green, Blue and adding Y to modify the overall quality of the mixed light.The phosphorproduceSteabler-Wronsk hardly in the high temperatureas compared tofour-color mixing.Using four-color mixing to producehigher color rendering index than yellow phosphor.Series-parallel array of grain arrangement adopted to achieve the high demand for uniformity, while simplifying the design conditions by a certain current instead of the general mixed light-driven complex driver circuit,the completion of the mixing module using integrating sphere, light spectrum on the spectrophotometer, optical power, color coordinates values, such as mixing uniformity measurements.The chromaticity coordinates errors after complete results of the mixing module measurement and simulation can be controlled under (0.01x, 0.01y).

scholarly journals Single-component white polymer light-emitting diode (WPLED) based on a binary tris-pyrazolonate-Sm-complex

2020 ◽  
Author(s):  
Jiaxiang Liu
Keyword(s):  
White Light ◽  
Light Emitting Diode ◽  
Single Component ◽  
Color Tuning ◽  
Solution Processed ◽  
Light Emitting ◽  
Component Solution ◽  
Full Color ◽  
Polymer Light Emitting Diode

Based on the doping of the binary tris-pyrazolate-Sm3þ complex [Sm(tba-PMP)3(5-Br-2,20-bpy)] (1; 5-Br-2,2′bpy ¼ 5-bromo2,20-bipyridine and Htba-PMP ¼ 1-phenyl-3-methyl-4-(tert-butylacetyl)-5-pyrazolone)) with an efficient orange-light into the PVK (poly(N-vinylcarbazole) host, the obtained PVK@1 films exhibit the dichromatic color-tuning (white-light to purplish-pink and to pink) characters strictly relative to the Sm3þdoping content and the λex wavelength. Further using the PVK@1 film (10:1; wt/wt) with the straightforward white-light (ΦPL ¼ 5.8%) as the emitting layer, its single-component solution-processed WPLED gives the electroluminescent performance (LMax of 157 cd/m2, ηMax c of 0.65 cd/A and the white-light-emitting stability) satisfactory enough for portable full-color flat displays.

scholarly journals Chromaticity Properties of Curcuminoids Dye Nanofibers Prepared by Electrospinning for White Light Down-Conversion

2020 ◽  
Vol 301 ◽  
pp. 77-84
Author(s):  
M. Al Shafouri ◽  
Naser Mahmoud Ahmed ◽  
Zainuriah Hassan ◽  
Munirah Abdullah Almessiere
Keyword(s):  
Methyl Methacrylate ◽  
White Light ◽  
Light Emitting Diode ◽  
Curcuma Longa ◽  
Average Diameter ◽  
Color Temperature ◽  
Light Emitting ◽  
Poly Methyl Methacrylate ◽  
Color Rendering ◽  
Down Conversion

In this study, the chromaticity properties of curcuminoids nanofibers were studied. Recent studies revealed that the nature of emitted light from curcuminoids and the poor stability which limits their illumination applications can be further improved using nanofibers and nanoparticles of curcuminoids. Motivated by this idea, we prepared some Poly(methyl methacrylate) (PMMA) integrated curcuminoids nanofibers via electrospinning. Poly(methyl methacrylate) (PMMA) were used in three types of concentration (5,10 and15wt%) which were mixed with (curcuma longa L.) powder to produce curcuminoids solution by using the centrifuge to separate the curcuminoids solution from the impurities. Different amounts of polymer solution mixed with curcuminoids (1 to 5ml) were spun by electrospinning to study its properties. The effect of annealing on samples was studied. The chromatic study of the samples and the effect of the amount and concentration of the solution were studied by pumping the samples in three different light emitting diode (LED) wavelengths (365, 390 and 445nm). The white light chromaticity coordinates (CIE), correlated color temperature (CCT) and color rendering index (CRI) were measured. The optimum CIE, CRI and CCT values of (X= 0.3051; Y= 0.3370), 64 and 6809K, respectively were obtained. By using field emission scanning electron microscope (FESEM) device, the curcuminoids nanofibers diameter was measured, where the values obtained ranged between 191 to 234nm. After the annealing process, curcuminoids nanoparticles average diameter 13-19 nm were obtained.

Sign in / Sign up

Export Citation Format

Share Document