Enhancing the thermoelectric efficiency in p-type Mg3Sb2 via Mg site co-doping

2021 ◽  
Author(s):  
Minati Tiadi ◽  
Manjusha Battabyal ◽  
P. K. Jain ◽  
Avnee Chauhan ◽  
Dillip Kumar Satapathy ◽  
...  
Keyword(s):  
Thermoelectric Materials ◽  
Full Potential ◽  
Thermoelectric Efficiency ◽  
Co Doping ◽  
P Type

The Mg3Sb2 based Zintl compounds are promising thermoelectric materials due to the abundance of magnesium and antimony in nature. However, the main hindrance in realizing the full potential of Mg3Sb2...

p‐Type Plastic Inorganic Thermoelectric Materials

2021 ◽  
pp. 2100883
Author(s):  
Zhiqiang Gao ◽  
Qingyu Yang ◽  
Pengfei Qiu ◽  
Tian‐Ran Wei ◽  
Shiqi Yang ◽  
...  
Keyword(s):  
Thermoelectric Materials ◽  
P Type

Fabrication of high hole-carrier density p-type ZnO thin films by N–Al co-doping

2007 ◽  
Vol 253 (8) ◽  
pp. 3825-3827 ◽  
Author(s):  
Zhang Xiaodan ◽  
Fan Hongbing ◽  
Zhao Ying ◽  
Sun Jian ◽  
Wei Changchun ◽  
...  
Keyword(s):  
Thin Films ◽  
Carrier Density ◽  
Zno Thin Films ◽  
Co Doping ◽  
P Type

Fabrication of Bi-Te Based Thermoelectric Semiconductors by Using Hybrid Powders

2005 ◽  
Vol 297-300 ◽  
pp. 875-880
Author(s):  
Cheol Ho Lim ◽  
Ki Tae Kim ◽  
Yong Hwan Kim ◽  
Dong Choul Cho ◽  
Young Sup Lee ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Single Crystals ◽  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Bending Strength ◽  
Mixing Ratio ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
P Type

P-type Bi0.5Sb1.5Te3 compounds doped with 3wt% Te were fabricated by spark plasma sintering and their mechanical and thermoelectric properties were investigated. The sintered compounds with the bending strength of more than 50MPa and the figure-of-merit 2.9×10-3/K were obtained by controlling the mixing ratio of large powders (PL) and small powders (PS). Compared with the conventionally prepared single crystal thermoelectric materials, the bending strength was increased up to more than three times and the figure-of-merit Z was similar those of single crystals. It is expected that the mechanical properties could be improved by using hybrid powders without degradation of thermoelectric properties.

scholarly journals Effect of Microwave Processing and Glass Inclusions on Thermoelectric Properties of P-Type Bismuth Antimony Telluride Alloys for Wearable Applications

Energies ◽  
2020 ◽  
Vol 13 (17) ◽  
pp. 4524
Author(s):  
Amin Nozariasbmarz ◽  
Daryoosh Vashaee
Keyword(s):  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Room Temperature ◽  
Electronic Devices ◽  
Microwave Processing ◽  
Glass Inclusion ◽  
Wearable Electronic ◽  
P Type ◽  
Wearable Electronic Devices ◽  
Body Heat

Depending on the application of bismuth telluride thermoelectric materials in cooling, waste heat recovery, or wearable electronics, their material properties, and geometrical dimensions should be designed to optimize their performance. Recently, thermoelectric materials have gained a lot of interest in wearable electronic devices for body heat harvesting and cooling purposes. For efficient wearable electronic devices, thermoelectric materials with optimum properties, i.e., low thermal conductivity, high Seebeck coefficient, and high thermoelectric figure-of-merit (zT) at room temperature, are demanded. In this paper, we investigate the effect of glass inclusion, microwave processing, and annealing on the synthesis of high-performance p-type (BixSb1−x)2Te3 nanocomposites, optimized specially for body heat harvesting and body cooling applications. Our results show that glass inclusion could enhance the room temperature Seebeck coefficient by more than 10% while maintaining zT the same. Moreover, the combination of microwave radiation and post-annealing enables a 25% enhancement of zT at room temperature. A thermoelectric generator wristband, made of the developed materials, generates 300 μW power and 323 mV voltage when connected to the human body. Consequently, MW processing provides a new and effective way of synthesizing p-type (BixSb1−x)2Te3 alloys with optimum transport properties.

scholarly journals Mn charge states in GaMnN as a function of Mn concentration and co-doping

2007 ◽  
Vol 1040 ◽  
Author(s):  
Enno Malguth ◽  
Axel Hoffmann ◽  
Wolfgang Gehlhoff ◽  
Matthew H. Kane ◽  
Ian T. Ferguson
Keyword(s):  
Electron Spin Resonance ◽  
Electron Spin ◽  
Magnetic Semiconductor ◽  
Electron Spin Resonance Spectroscopy ◽  
Resonance Spectroscopy ◽  
Mg Doping ◽  
Co Doping ◽  
Spin Resonance ◽  
P Type ◽  
Mn Concentration

AbstractIn the context of the pursuit of a dilute magnetic semiconductor for spintronic applications, a set of GaMnN samples with varying Mn concentration and Si or Mg co-doping was investigated by optical and electron spin resonance spectroscopy. The results clearly demonstrate how the charge state of Mn is changed between 2+, 3+ and 4+ by Mg and Si co-doping. For p-type GaMnN we show that the introduction of the Mn3+/4+ donor can be compensated by Mg co-doping lowering the Fermi energy below the Mn3+/4+ level. While our results are in agreement with the hypothesis that the infrared photoluminescence appearing in GaMnN upon Mg doping originates from Mn4+, an unambiguous proof is still to be presented. Under this assumption, our measurements show that the Mn4+ center must be excited via an extra-center process at 2.54 eV.

scholarly journals Термоэлектрические свойства нанокомпозитного Bi-=SUB=-0.45-=/SUB=-Sb-=SUB=-1.55-=/SUB=-Te-=SUB=-2.985-=/SUB=- с микрочастицами SiO-=SUB=-2-=/SUB=-

2019 ◽  
Vol 53 (6) ◽  
pp. 751
Author(s):  
А.А. Шабалдин ◽  
П.П. Константинов ◽  
Д.А. Курдюков ◽  
Л.Н. Лукьянова ◽  
А.Ю. Самунин ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Solid Solution ◽  
Electrical Conductivity ◽  
Wide Temperature Range ◽  
Figure Of Merit ◽  
Nanostructured Material ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Efficiency ◽  
Thermoelectric Figure ◽  
P Type

AbstractNanocomposite thermoelectrics based on Bi_0.45Sb_1.55Te_2.985 solid solution of p -type conductivity are fabricated by the hot pressing of nanopowders of this solid solution with the addition of SiO_2 microparticles. Investigations of the thermoelectric properties show that the thermoelectric power of the nanocomposites increases in a wide temperature range of 80–420 K, while the thermal conductivity considerably decreases at 80–320 K, which, despite a decrease in the electrical conductivity, leads to an increase in the thermoelectric efficiency in the nanostructured material without the SiO_2 addition by almost 50% (at 300 K). When adding SiO_2, the efficiency decreases. The initial thermoelectric fabricated without nanostructuring, in which the maximal thermoelectric figure of merit ZT = 1 at 390 K, is most efficient at temperatures above 350 K.

High thermoelectric efficiency in co-doped degenerate p-type PbTe

2010 ◽  
Vol 1267 ◽  
Author(s):  
Ioannis Androulakis ◽  
Ilyia Todorov ◽  
Duck Young Chung ◽  
Sedat Ballikaya ◽  
Guoyu Wang ◽  
...  
Keyword(s):  
Heavy Hole ◽  
Elevated Temperatures ◽  
Resonant State ◽  
Band Model ◽  
Hole Density ◽  
Thermoelectric Efficiency ◽  
Na Substitution ◽  
Valence Bands ◽  
P Type ◽  
Two Band Model

AbstractWe explored the effect of K and K-Na substitution for Pb atoms in the lattice of PbTe, in an effort to test a hypothesis for the development of a resonant state that may enhance the thermoelectric power. At 300K the data can adequately be explained by a combination of a single and two-band model for the valence band of PbTe depending on hole density that varies in the range 1-15 × 1019 cm-3. A change in scattering mechanism was observed in the temperature dependence of the electrical conductivity, σ, for samples concurrently doped with K and Na which results in significantly enhanced σ at elevated temperatures and hence power factors. Thermal conductivity data provide evidence of a strong interaction between the light- and the heavy-hole valence bands at least up to 500K. Figure of merits as high as 1.3 at 700K were measured as a result of the enhanced power factors.

Structure Design for High Performance n-Type Polymer Thermoelectric Materials

2021 ◽  
Author(s):  
Qi Zhang ◽  
Hengda Sun ◽  
Meifang Zhu
Keyword(s):  
Conjugated Polymers ◽  
Thermoelectric Materials ◽  
High Performance ◽  
Waste Heat ◽  
Building Blocks ◽  
Structure Design ◽  
Potential Candidate ◽  
Polymer Backbone ◽  
P Type ◽  
Polymer Thermoelectric

Abstract Organic thermoelectric (OTE) materials have been regarded as a potential candidate to harvest waste heat from complex, low temperature surfaces of objects and convert it into electricity. Recently, n-type conjugated polymers as organic thermoelectric materials have aroused intensive research in order to improve their performance to match up with their p-type counterpart. In this review, we discuss aspects that affect the performance of n-type OTEs, and further focus on the effect of planarity of backbone on doping efficiency and eventually the TE performance. We then summarize strategies such as implementing rigid n-type polymer backbone or modifying conventional polymer building blocks for more planar conformation. In the outlook part, we conclude forementioned devotions and point out new possibility that may promote the future development of this field.

scholarly journals Substitution Versus Full-Heusler Segregation in TiCoSb

Metals ◽  
2018 ◽  
Vol 8 (11) ◽  
pp. 935 ◽  
Author(s):  
Maryana Asaad ◽  
Jim Buckman ◽  
Jan-Willem Bos
Keyword(s):  
Powder Metallurgy ◽  
Power Factor ◽  
Thermoelectric Materials ◽  
Room Temperature ◽  
The Difference ◽  
P Type ◽  
Full Heusler ◽  
Thermal Conductivities

Half-Heuslers (HHs) are promising thermoelectric materials with great compositional flexibility. Here, we extend work on the p-type doping of TiCoSb using abundant elements. Ti0.7V0.3Co0.85Fe0.15Sb0.7Sn0.3 samples with nominal 17.85 p-type electron count were investigated. Samples prepared using powder metallurgy have negative Seebeck values, S ≤ −120 µV K−1, while arc-melted compositions are compensated semiconductors with S = −45 to +30 µV K−1. The difference in thermoelectric response is caused by variations in the degree of segregation of V(Co0.6Fe0.4)2Sn full-Heusler and Sn phases, which selectively absorb V, Fe, and Sn. The segregated microstructure leads to reduced lattice thermal conductivities, κlat = 4.5−7 W m−1 K−1 near room temperature. The largest power factor, S2/ρ = 0.4 mW m−1 K−2 and ZT = 0.06, is observed for the n-type samples at 800 K. This works extends knowledge regarding suitable p-type dopants for TiCoSb.

Sign in / Sign up

Export Citation Format

Share Document