scholarly journals Parametric scheme for rapid nanopattern replication via electrohydrodynamic instability

RSC Advances ◽  
2021 ◽  
Vol 11 (30) ◽  
pp. 18152-18161
Author(s):  
Jaeseok Hwang ◽  
Hyunje Park ◽  
Jaejong Lee ◽  
Dae Joon Kang
Keyword(s):  
Filling Ratio ◽  
Hole Array ◽  
Electrohydrodynamic Instability ◽  
Hexagonally Ordered

1/τm-dependent electrohydrodynamic replication of a hexagonally ordered hole array nanopattern by adjusting the filling ratio. As the 1/τm increases, the morphology evolves into the perfectly replicated hole features with increasing filling ratio.

The electrohydrodynamic instability in twisted nematic liquid crystals

1994 ◽  
Vol 4 (2) ◽  
pp. 239-252 ◽  
Author(s):  
A. Hertrich ◽  
A. P. Krekhov ◽  
O. A. Scaldin
Keyword(s):  
Liquid Crystals ◽  
Nematic Liquid Crystals ◽  
Electrohydrodynamic Instability ◽  
Twisted Nematic

ELECTROHYDRODYNAMIC INSTABILITY OF LIQUID SHEET SATURATING POROUS MEDIUM WITH INTERFACIAL SURFACE CHARGES

2013 ◽  
Vol 23 (2) ◽  
pp. 165-191
Author(s):  
Mohamed F. El-Sayed ◽  
M. H. M. Moussa ◽  
Ahmed A. A. Hassan ◽  
N. M. Hafez
Keyword(s):  
Porous Medium ◽  
Liquid Sheet ◽  
Surface Charges ◽  
Electrohydrodynamic Instability ◽  
Interfacial Surface

Influence of ultrasonic on filling ratio of Bi in X-ray analyzer gratings

2016 ◽  
Vol 33 (2) ◽  
pp. 138
Author(s):  
Yaohu Lei ◽  
Xin Liu ◽  
Jinchuan Guo ◽  
Ji Li ◽  
Hanben Niu
Keyword(s):  
Filling Ratio ◽  
X Ray

ANALYSIS ON THE EFFECT OF NANO PARTICLES IN WASTE HEAT RECOVERY SYSTEM USING HEAT PIPES BY RSM

2019 ◽  
Vol 14 (1) ◽  
Author(s):  
Gunabal S
Keyword(s):  
Response Surface Methodology ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Heat Pipes ◽  
Filling Ratio ◽  
Nano Particles ◽  
Waste Heat Recovery System ◽  
Recovery System ◽  
Heat Recovery System

Waste heat recovery systems are used to recover the waste heat in all possible ways. It saves the energy and reduces the man power and materials. Heat pipes have the ability to improve the effectiveness of waste heat recovery system. The present investigation focuses to recover the heat from Heating, Ventilation, and Air Condition system (HVAC) with two different working fluids refrigerant(R410a) and nano refrigerant (R410a+Al2O3). Design of experiment was employed, to fix the number of trials. Fresh air temperature, flow rate of air, filling ratio and volume of nano particles are considered as factors. The effectiveness is considered as response. The results were analyzed using Response Surface Methodology

Bound states in the continuum in double-hole array perforated in a layer of photonic crystal slab

2019 ◽  
Vol 12 (12) ◽  
pp. 125002 ◽  
Author(s):  
Suxia Xie ◽  
Changzhong Xie ◽  
Song Xie ◽  
Jie Zhan ◽  
Zhijian Li ◽  
...  
Keyword(s):  
Photonic Crystal ◽  
Bound States ◽  
Hole Array ◽  
Photonic Crystal Slab ◽  
The Continuum

scholarly journals Application of Biofilm Carrier in Aerobic Reactors as a Method to Improve Quality of Wastewater Treatment

Hydrology ◽  
2021 ◽  
Vol 8 (2) ◽  
pp. 77
Author(s):  
Nikolay Makisha
Keyword(s):  
Ammonia Nitrogen ◽  
Filling Ratio ◽  
Treatment Quality ◽  
Secondary Treatment ◽  
Biofilm Carrier ◽  
Aerobic Reactor ◽  
Biofilm Carriers ◽  
Optimal Efficiency ◽  
Positive Results

The research revealed in the paper considers the improvement of secondary treatment of wastewater in the aerobic reactor to provide removal of organics and nutrients. There were five types of polymer biofilm carriers taken into account initially; however, two of them were decided not to apply due to technological reasons. The main part of the research was divided into three substages to investigate each type of biofilm carrier. According to the literature review, the optimal efficiency may be reached if the carrier filling ratio is 10 to 30% of reactor volume. On this basis, there were three benches launched at each sub-stage with a corresponding filling ratio of 10, 20, and 30%. The fourth reactor at each sub-stage had no floating carrier to control the experiment. The research of all three types of carriers showed the effect of BOD removal in the range of 95–96% for benches equipped with a floating carrier, which can be considered similar to the control bench with the efficiency of 92%. In the case of ammonia nitrogen, the removal control bench showed only 55% of efficiency, while floating carriers helped to increase the efficiency up to 70–86%. Despite obtaining relatively positive results, the research has to be continued to achieve regulation requirements in treatment quality.

scholarly journals Tunable Low Frequency Band Gap and Waveguide of Phononic Crystal Plates with Different Filling Ratio

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 828
Author(s):  
Shaobo Zhang ◽  
Jiang Liu ◽  
Hongbo Zhang ◽  
Shuliang Wang
Keyword(s):  
Band Gap ◽  
Composite Structure ◽  
Structural Parameters ◽  
Phononic Crystal ◽  
Low Frequency ◽  
Filling Ratio ◽  
Height Ratio ◽  
Road Vehicles ◽  
Aluminum Base ◽  
Gap Width

Aiming at solving the NVH problem in vehicles, a novel composite structure is proposed. The new structure uses a hollow-stub phononic-crystal with filled cylinders (HPFC) plate. Any unit in the plate consists of a lead head, a silicon rubber body, an aluminum base as outer column and an opposite arranged inner pole. The dispersion curves are investigated by numerical simulations and the influences of structural parameters are discussed, including traditional hollow radius, thickness, height ratio, and the new proposed filling ratio. Three new arrays are created and their spectrum maps are calculated. In the dispersion simulation results, new branches are observed. The new branches would move towards lower frequency zone and the band gap width enlarges as the filling ratio decreases. The transmission spectrum results show that the new design can realize three different multiplexing arrays for waveguides and also extend the locally resonant sonic band gap. In summary, the proposed HPFC structure could meet the requirement for noise guiding and filtering. Compared to a traditional phononic crystal plate, this new composite structure may be more suitable for noise reduction in rail or road vehicles.

Sign in / Sign up

Export Citation Format

Share Document