scholarly journals Morphology Effect of Ceria Supports on Gold Nanocluster Catalyzed CO Oxidation

2021 ◽  
Author(s):  
Zhiming Li ◽  
Xinyu Zhang ◽  
Quanquan Shi ◽  
Xia Gong ◽  
Hui Xu ◽  
...  
Keyword(s):  
Co Oxidation ◽  
Chemical Reactions ◽  
Active Sites ◽  
Gold Nanocluster ◽  
Catalytically Active ◽  
Morphology Effect

Interfacial perimeter is generally viewed as the catalytically active sites for a number of chemical reactions over the oxide-supported nanogold catalysts. Here, the well-defined CeO2 of nanocube, nanorod and nanopolyhedra...

scholarly journals Effect of Li2O Doping on the Surface and Catalytic Properties of the Cr2O/Al2O3 System

1998 ◽  
Vol 16 (6) ◽  
pp. 415-429 ◽  
Author(s):  
G.A. El-Shobaky ◽  
A.M. Ghozza ◽  
H.G. El-Shobaky
Keyword(s):  
Co Oxidation ◽  
Catalytic Reaction ◽  
Active Sites ◽  
Catalytic Properties ◽  
Nitrogen Adsorption ◽  
Maximum Increase ◽  
Exponential Factor ◽  
Catalytic Activities ◽  
Catalytically Active ◽  
Maximum Decrease

Two Cr2O3/Al2O3 samples with the nominal compositions 0.06Cr2O2/Al2O3 and 0.125Cr2O3/Al2O3 (AlCr-I and AlCr-II, respectively) were prepared by mixing a known amount of finely powdered Al(OH)3 with calculated amounts of CrO3, followed by drying at 120°C and calcination at 700°C and 800°C. Doped solid specimens were prepared by treating Al(OH)3 samples with known amounts of LiNO3 dissolved in the minimum amount of distilled water prior to mixing with CrO3. Dopant concentrations of 0.75, 1.50, 3.00 and 6.00 mol% Li2O were employed. The surface and catalytic properties of the pure and doped solids thus prepared were investigated using nitrogen adsorption at −196°C and studies of the catalysis of CO oxidation by O2 over the solid specimens at 300–400°C. The results of such studies showed that Li2O doping followed by calcination at 700°C led to a maximum increase in the specific surface area, SBET, of 26% for AlCr-I and of 55% for AlCr-II when these samples were doped with 3.00 mol% Li2O. The reverse effect was found when the calcination temperature was increased to 800°C, where a decrease of 34% in the SBET value of the AlCr-II sample doped with 3.00 mol% Li2O was detected. The catalytic activities measured at 350°C over the pure and doped solids decreased on increasing the dopant concentration, the maximum decrease in such activity being ca. 33% and 50%, respectively, for the AlCr-I and AlCr-II samples calcined at 700°C. Doping led to noticable changes in the magnitude of the activation energy for the catalytic reaction. Such changes were accompanied by parallel changes in the value of the pre-exponential factor in the Arrhenius equation. These results may indicate that Li2O doping has no effect on the mechanism of the catalytic reaction but modifies (decreases) the concentration of catalytically active sites taking part in chemisorption during the catalysis of CO oxidation by O2.

Catalytic Resonance Theory: Parallel Reaction Pathway Control

2019 ◽  
Author(s):  
M. Alexander Ardagh ◽  
Manish Shetty ◽  
Anatoliy Kuznetsov ◽  
Qi Zhang ◽  
Phillip Christopher ◽  
...  
Keyword(s):  
Chemical Reactions ◽  
Active Site ◽  
Active Sites ◽  
Reaction Pathway ◽  
Control Strategies ◽  
Oscillation Amplitude ◽  
Catalytic Performance ◽  
Parallel Reaction ◽  
Resonance Theory ◽  
Static Conditions

Catalytic enhancement of chemical reactions via heterogeneous materials occurs through stabilization of transition states at designed active sites, but dramatically greater rate acceleration on that same active site is achieved when the surface intermediates oscillate in binding energy. The applied oscillation amplitude and frequency can accelerate reactions orders of magnitude above the catalytic rates of static systems, provided the active site dynamics are tuned to the natural frequencies of the surface chemistry. In this work, differences in the characteristics of parallel reactions are exploited via selective application of active site dynamics (0 < ΔU < 1.0 eV amplitude, 10<sup>-6</sup> < f < 10<sup>4</sup> Hz frequency) to control the extent of competing reactions occurring on the shared catalytic surface. Simulation of multiple parallel reaction systems with broad range of variation in chemical parameters revealed that parallel chemistries are highly tunable in selectivity between either pure product, even when specific products are not selectively produced under static conditions. Two mechanisms leading to dynamic selectivity control were identified: (i) surface thermodynamic control of one product species under strong binding conditions, or (ii) catalytic resonance of the kinetics of one reaction over the other. These dynamic parallel pathway control strategies applied to a host of chemical conditions indicate significant potential for improving the catalytic performance of many important industrial chemical reactions beyond their existing static performance.

scholarly journals CO Oxidation Efficiency and Hysteresis Behavior over Mesoporous Pd/SiO2 Catalyst

Catalysts ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 131 ◽  
Author(s):  
Rola Mohammad Al Soubaihi ◽  
Khaled Mohammad Saoud ◽  
Myo Tay Zar Myint ◽  
Mats A. Göthelid ◽  
Joydeep Dutta
Keyword(s):  
Carbon Monoxide ◽  
Catalytic Activity ◽  
Co Oxidation ◽  
Active Sites ◽  
Bond Activation ◽  
Dissociative Adsorption ◽  
High Catalytic Activity ◽  
Good Catalytic Activity ◽  
Pretreatment Conditions ◽  
Oxidation Efficiency

Carbon monoxide (CO) oxidation is considered an important reaction in heterogeneous industrial catalysis and has been extensively studied. Pd supported on SiO2 aerogel catalysts exhibit good catalytic activity toward this reaction owing to their CO bond activation capability and thermal stability. Pd/SiO2 catalysts were investigated using carbon monoxide (CO) oxidation as a model reaction. The catalyst becomes active, and the conversion increases after the temperature reaches the ignition temperature (Tig). A normal hysteresis in carbon monoxide (CO) oxidation has been observed, where the catalysts continue to exhibit high catalytic activity (CO conversion remains at 100%) during the extinction even at temperatures lower than Tig. The catalyst was characterized using BET, TEM, XPS, TGA-DSC, and FTIR. In this work, the influence of pretreatment conditions and stability of the active sites on the catalytic activity and hysteresis is presented. The CO oxidation on the Pd/SiO2 catalyst has been attributed to the dissociative adsorption of molecular oxygen and the activation of the C-O bond, followed by diffusion of adsorbates at Tig to form CO2. Whereas, the hysteresis has been explained by the enhanced stability of the active site caused by thermal effects, pretreatment conditions, Pd-SiO2 support interaction, and PdO formation and decomposition.

scholarly journals Manganese vacancy-confined single-atom Ag in cryptomelane nanorods for efficient Wacker oxidation of styrene derivatives

2021 ◽  
Author(s):  
Hongling Yang ◽  
Xun Zhang ◽  
Yi Yu ◽  
Zheng Chen ◽  
Qinggang Liu ◽  
...  
Keyword(s):  
Molecular Sieve ◽  
Active Sites ◽  
Single Atom ◽  
Wacker Oxidation ◽  
Catalytically Active ◽  
Styrene Derivatives

Single-atom catalysts provide a pathway to elucidate the nature of catalytically active sites. However, keeping them stabilized during operation proves to be challenging. Herein, we employ cryptomelane-type octahedral molecular sieve...

Catalytically Active Rh Sub-Nanoclusters on TiO2 for CO Oxidation at Cryogenic Temperatures

2016 ◽  
Vol 128 (8) ◽  
pp. 2870-2874 ◽  
Author(s):  
Hongling Guan ◽  
Jian Lin ◽  
Botao Qiao ◽  
Xiaofeng Yang ◽  
Lin Li ◽  
...  
Keyword(s):  
Co Oxidation ◽  
Cryogenic Temperatures ◽  
Catalytically Active

Tuning electronic states of catalytic sites enhances SCR activity of hexagonal WO3by Mo framework substitution

2017 ◽  
Vol 7 (12) ◽  
pp. 2467-2473 ◽  
Author(s):  
Yaxin Chen ◽  
Zichenxi Dong ◽  
Zhiwei Huang ◽  
Meijuan Zhou ◽  
Jiayi Gao ◽  
...  
Keyword(s):  
Active Sites ◽  
Electronic States ◽  
Catalytic Sites ◽  
Catalytically Active

The electronic states of the catalytically active sites of HWO were tuned by Mo framework substitution.

ChemInform Abstract: Catalytically Active Sites and Their Complexity: A Micro-review.

ChemInform ◽  
2014 ◽  
Vol 45 (11) ◽  
pp. no-no ◽  
Author(s):  
Marco Piumetti ◽  
Francesca Stefania Freyria ◽  
Barbara Bonelli
Keyword(s):  
Active Sites ◽  
Catalytically Active

Optimization of Catalytically Active Sites Positioning in Porous Cathodes of Lithium/Air Batteries Filled with Different Electrolytes

2015 ◽  
Vol 162 (14) ◽  
pp. A2796-A2804 ◽  
Author(s):  
Tatjana Dabrowski ◽  
Alexander Struck ◽  
Daniela Fenske ◽  
Peter Maaß ◽  
Lucio Colombi Ciacchi
Keyword(s):  
Active Sites ◽  
Catalytically Active ◽  
Porous Cathodes ◽  
Lithium Air Batteries
Sign in / Sign up

Export Citation Format

Share Document