Piloting carbon-lean nitrogen removal for energy-autonomous sewage treatment

2021 ◽  
Author(s):  
Michiel Van Tendeloo ◽  
Bert Bundervoet ◽  
Nathalie Carlier ◽  
Wannes Van Beeck ◽  
Hans Mollen ◽  
...  
Keyword(s):  
Organic Carbon ◽  
Chemical Oxygen Demand ◽  
Nitrogen Removal ◽  
Sewage Treatment ◽  
Oxygen Demand ◽  
N Removal

Energy-autonomous sewage treatment can be achieved if nitrogen (N) removal does not rely on organic carbon (~chemical oxygen demand, COD), so that a maximum of the COD can be redirected...

Effects of organic carbon source, chemical oxygen demand/N ratio and temperature on autotrophic nitrogen removal

2014 ◽  
Vol 69 (10) ◽  
pp. 2079-2084 ◽  
Author(s):  
J. A. Sánchez Guillén ◽  
Y. Yimman ◽  
C. M. Lopez Vazquez ◽  
D. Brdjanovic ◽  
J. B. van Lier
Keyword(s):  
Carbon Source ◽  
Organic Carbon ◽  
Chemical Oxygen Demand ◽  
Nitrogen Removal ◽  
Oxygen Demand ◽  
Post Treatment ◽  
Operating Conditions ◽  
Organic Carbon Source ◽  
Anammox Process ◽  
Autotrophic Nitrogen Removal

To assess the feasibility of the Anammox process as a cost-effective post-treatment step for anaerobic sewage treatment, the simultaneous effects of organic carbon source, chemical oxygen demand (COD)/N ratio, and temperature on autotrophic nitrogen removal was studied. In batch experiments, three operating conditions were evaluated at 14, 22 and 30 °C, and at COD/N ratios of 2 and 6. For each operating condition, containing 32 ± 2 mg NH4+-N/L and 25 ± 2 mg NO2−-N/L, three different substrate combinations were tested to simulate the presence of readily biodegradable and slowly biodegradable organic matter (RBCOD and SBCOD, respectively): (i) acetate (RBCOD); (ii) starch (SBCOD); and (iii) acetate + starch. The observed stoichiometric NO2−-N/NH4+-N conversion ratios were in the range of 1.19–1.43, and the single or simultaneous presence of acetate and starch did not affect the Anammox metabolism. High Anammox nitrogen removal was observed at 22 °C (77–84%) and 30 °C (73–79%), whereas there was no nitrogen removal at 14 °C; the Anammox activity was strongly influenced by temperature, in spite of the COD source and COD/N ratios applied. These results suggest that the Anammox process could be applied as a nitrogen removal post-treatment for anaerobic sewage systems in warm climates.

scholarly journals Digestate Liquid Fraction Treatment with Filters Filled with Recovery Materials

Water ◽  
2020 ◽  
Vol 13 (1) ◽  
pp. 21
Author(s):  
Ilaria Piccoli ◽  
Giuseppe Virga ◽  
Carmelo Maucieri ◽  
Maurizio Borin
Keyword(s):  
Chemical Oxygen Demand ◽  
Total Nitrogen ◽  
Liquid Fraction ◽  
Oxygen Demand ◽  
Ammonia Nitrogen ◽  
Green Technology ◽  
Filling Material ◽  
Community Interactions ◽  
Material Particle ◽  
N Removal

Constructed wetlands (CWs) represent a green technology for digestate liquid fraction (DLF) treatment. However, previous research has warned about their performance when treating wastewater with high suspended solid and organic loads. In addition, the high NH4-N concentration typical of this wastewater can compromise vegetation establishment and activity. In view of this, a digestate pretreatment is needed. This study aimed to test the performance of filters filled with recovery materials, such as brick and refractory material, for DLF pretreatment. The effect on DLF physical (electrical conductivity, pH, dissolved oxygen, and temperature) and chemical (total nitrogen, ammonia–nitrogen, nitrate–nitrogen, total phosphorus, soluble phosphorus, and chemical oxygen demand) characteristics was monitored during eight weekly cycles. The effect of filtration on total nitrogen and ammonia–nitrogen removal began after about one month of loading, suggesting that an activation period is necessary for bacteria. For effective N removal, the presence of multiple digestate recirculations per day through the filters appears mandatory to guarantee the alternation of nitrification and denitrification conditions. For P removal, filling material particle size appeared to be more important than its composition. Unclear performances were observed considering chemical oxygen demand. Further studies on filling media and microbial community interactions, and the long-term efficiency of filters, are desirable.

Comparison of Luffa Cylindrical Sponge and Plastic Sponge as Carriers in Sequencing Batch Biofilm Reactor for Sewage Treatment

2012 ◽  
Vol 518-523 ◽  
pp. 2431-2438
Author(s):  
Ying Zhang Wang ◽  
Shang Hua Zhang ◽  
Chang Qing Pang ◽  
Jie Li
Keyword(s):  
Chemical Oxygen Demand ◽  
Sewage Treatment ◽  
Oxygen Demand ◽  
Suspended Solid ◽  
Biofilm Reactor ◽  
Environment Friendly ◽  
Sequencing Batch Biofilm Reactor ◽  
Removal Efficiencies

Luffa cylindrical sponge and plastic sponge were used as carriers in sequencing batch biofilm reactor (SBBR) for sewage treatment in this paper. The removals of suspended solid (SS), chemical oxygen demand (COD) and NH3-N in sewage were studied. The average removal efficiencies of SS, COD and NH3-N with luffa cylindrical sponge were 96%, 89% and 90%, respectively, while these with plastic sponge were 94%, 83% and 80%, respectively. As a natural, cheap and environment friendly biocarrier, luffa cylindrical sponge was easy to get a biofilm with enriched microbes during the first few days of sewage treatment. It was much more suitable as a carrier than the plastic sponge for SBBR.

scholarly journals Treatment of real paracetamol wastewater by fenton process

2017 ◽  
Vol 23 (2) ◽  
pp. 177-186 ◽  
Author(s):  
Gamze Dalgic ◽  
Ilter Turkdogan ◽  
Kaan Yetilmezsoy ◽  
Emel Kocak
Keyword(s):  
Pharmaceutical Industry ◽  
Organic Carbon ◽  
Chemical Oxygen Demand ◽  
Treatment Plant ◽  
Oxygen Demand ◽  
Biological Oxygen Demand ◽  
Fenton Process ◽  
Experimental Conditions ◽  
Mass Distributions ◽  
Amino Phenol

The study investigated the pretreatment of real paracetamol (PCT) wastewater of a pharmaceutical industry by Fenton process. At the best experimental conditions (COD/H2O2 = 1/1, Fe+2/H2O2 = 1/70, settling method:centrifuging, pH 6 at settling step), 92.7, 92.7, 95.5, 99.1, 99.9 and 99.4% of chemical oxygen demand (COD), total organic carbon (TOC), 5-day biological oxygen demand (BOD5), PCT, para-amino phenol (PAP) and aniline were removed, respectively. Changes in the concentrations of these parameters were also investigated for both oxidation and settling steps of Fenton process. It was found that COD and TOC were removed at the settling step (precipitation) whereas PCT, PAP and aniline were removed at the oxidation step. Mass balance calculations were also studied to show the mass distributions of COD in different phases (gas + foam, effluent and sludge). Fenton process was found as an effective method for the pretreatment of real PCT wastewater for discharging in a determined collective treatment plant.

scholarly journals Taguchi Method and Response Surface Methodology in the Treatment of Highly Contaminated Tannery Wastewater Using Commercial Potassium Ferrate

Materials ◽  
2019 ◽  
Vol 12 (22) ◽  
pp. 3784 ◽  
Author(s):  
Violetta Kozik ◽  
Krzysztof Barbusinski ◽  
Maciej Thomas ◽  
Agnieszka Sroda ◽  
Josef Jampilek ◽  
...  
Keyword(s):  
Response Surface Methodology ◽  
Organic Carbon ◽  
Taguchi Method ◽  
Chemical Oxygen Demand ◽  
Total Organic Carbon ◽  
Response Surface ◽  
Suspended Solids ◽  
Oxygen Demand ◽  
Tannery Wastewater ◽  
Potassium Ferrate

The potential implementation of Envifer®, a commercial product containing potassium ferrate (40.1% K2FeO4), for the purification of highly contaminated tannery wastewater from leather dyeing processes was proposed. The employment of the Taguchi method for optimization of experiments allowed the discoloration (98.4%), chemical oxygen demand (77.2%), total organic carbon (75.7%), and suspended solids (96.9%) values to be lowered using 1.200 g/L K2FeO4 at pH 3 within 9 min. The application of the central composite design (CCD) and the response surface methodology (RSM) with the use of 1.400 g/L K2FeO4 at pH 4.5 diminished the discoloration, the chemical oxygen demand, the total organic carbon, and suspended solids within 9 min. The Taguchi method is suitable for the initial implementation, while the RSM is superior for the extended optimization of wastewater treatment processes.

scholarly journals Occurrence and Succession of Bacterial Community in O3/BAC Process of Drinking Water Treatment

2019 ◽  
Vol 16 (17) ◽  
pp. 3112 ◽  
Author(s):  
Sheng Dong ◽  
Lijun Liu ◽  
Yuxiu Zhang ◽  
Fajun Jiang
Keyword(s):  
Drinking Water ◽  
Activated Carbon ◽  
Bacterial Community ◽  
Dissolved Oxygen ◽  
Chemical Oxygen Demand ◽  
Bacterial Communities ◽  
Oxygen Demand ◽  
Drinking Water Treatment ◽  
Turbidity Removal ◽  
N Removal

In the drinking water industry, a common advanced treatment process is comprised of treatment with ozone, followed by biological-activated carbon (O3/BAC). However, the bacterial community formation and succession procedures associated with activated carbon have rarely been reported. In this study, the dynamics of bacterial communities at three different depths were investigated using a pilot-scale O3/BAC filter. The average chemical oxygen demand (CODMn), turbidity removal and dissolved oxygen (DO) consumption rate of the filter were 26.43%, 16.57% and 16.4% during the operation period, respectively. Bacterial communities dominated by proteobacteria and Bacteroidetes attached on activated carbon were determined by polymerase chain reaction-density gradient gel electrophoresis (PCR-DGGE). Principal component analysis (PCA) revealed that the compositions and structures of bacterial communities in different layers clustered after fluctuation. A redundancy analysis (RDA) indicated that Ramlibacter henchirensis was positively correlated to chemical oxygen demand (CODMn) removal and nitrate-N removal, and Georgfuchsia toluolica also showed a positive correlation with CODMn removal. Aquabacterium parvum and Phaeobacterium nitratireducens were positively-correlated with turbidity removal. Pedobacter glucosidilyticus and Pseudomonas sp. were associated with high dissolved oxygen (DO) consumption. These results provide insight into the succession characteristics of the bacterial community of O3/BAC treatment and the interactions of the bacterial community with filter operation performance.

Treatment of slaughterhouse plant wastewater by using a membrane bioreactor

2011 ◽  
Vol 64 (1) ◽  
pp. 214-219 ◽  
Author(s):  
Levent Gürel ◽  
Hanife Büyükgüngör
Keyword(s):  
Organic Carbon ◽  
Chemical Oxygen Demand ◽  
Membrane Bioreactor ◽  
Nitrate Nitrogen ◽  
Oxygen Demand ◽  
Organic Substances ◽  
Slaughterhouse Wastewater ◽  
Treated Effluent ◽  
Nitrogen Concentrations ◽  
Removal Efficiencies

The use of a membrane bioreactor (MBR) for removal of organic substances and nutrients from slaughterhouse plant wastewater was investigated. The chemical oxygen demand (COD), total nitrogen (TN), and total phosphorus (TP) concentrations of slaughterhouse wastewater were found to be approximately 571 mg O2/L, 102.5 mg/L, and 16.25 mg PO4-P/L, respectively. A submerged type membrane was used in the bioreactor. The removal efficiencies for COD, total organic carbon (TOC), TP and TN were found to be 97, 96, 65, 44% respectively. The COD value of wastewater was decreased to 16 mg/L (COD discharge standard for slaughterhouse plant wastewaters is 160 mg/L). TOC was decreased to 9 mg/L (TOC discharge standard for slaughterhouse plant wastewaters is 20 mg/L). Ammonium, and nitrate nitrogen concentrations of treated effluent were 0.100 mg NH4-N/L, and 80.521 mg NO3-N/L, respectively. Slaughterhouse wastewater was successfully treated with the MBR process.

Sign in / Sign up

Export Citation Format

Share Document