Comment on “Low lattice thermal conductivity and promising thermoelectric figure of merit of Zintl type TlInTe2” by G. Ding et al., J. Mater. Chem. C, 2018, 6, 13269.

2020 ◽  
Vol 8 (21) ◽  
pp. 7253-7254
Author(s):  
A. M. Panich
Keyword(s):  
Thermal Conductivity ◽  
Electronic Structure ◽  
Figure Of Merit ◽  
Lattice Thermal Conductivity ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Low Thermal Conductivity

We add several details concerning the electronic structure and mechanisms of low thermal conductivity of TlInTe2 calculated by Ding et al.

Effects of Ce filling fraction and Fe content on the thermoelectric properties of Co-rich CeyFexCo4−xSb12

2001 ◽  
Vol 16 (3) ◽  
pp. 837-843 ◽  
Author(s):  
Xinfeng Tang ◽  
Lidong Chen ◽  
Takashi Goto ◽  
Toshio Hirai
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Single Phase ◽  
Lattice Thermal Conductivity ◽  
Hole Concentration ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Filling Fraction ◽  
Fe Content

Single-phase filled skutterudite compounds, CeyFexCo4−xSb12 (x = 0 to 3.0, y = 0 to 0.74), were synthesized by a melting method. The effects of Fe content and Ce filling fraction on the thermoelectric properties of CeyFexCo4−xSb12 were investigated. The lattice thermal conductivity of Ce-saturated CeyFexCo4−xSb12, y being at the maximum corresponding to x, decreased with increasing Fe content (x) and reached its minimum at about x = 1.5. When x was 1.5, lattice thermal conductivity decreased with increasing Ce filling fraction till y = 0.3 and then began to increase after reaching the minimum at y = 0.3. Hole concentration and electrical conductivity of Cey Fe1.5Co2.5Sb12 decreased with increasing Ce filling fraction. The Seebeck coefficient increased with increasing Ce filling fraction. The greatest dimensionless thermoelectric figure of merit T value of 1.1 was obtained at 750 K for the composition of Ce0.28Fe1.52Co2.48Sb12.

Thermoelectric Properties of CoSb3-based Skutterudite Compounds

2010 ◽  
Vol 1267 ◽  
Author(s):  
Adul Harnwunggmoung ◽  
Ken Kurosaki ◽  
Hiroaki Muta ◽  
Shinsuke Yamanaka
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Room Temperature ◽  
Lattice Thermal Conductivity ◽  
Filling Ratio ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Alloy Scattering ◽  
Skutterudite Compound

AbstractCoSb3 is known as a skutterudite compound that could exhibit high thermoelectric figure of merit. However, the thermal conductivity of CoSb3 is relatively high. In order to enhance the thermoelectric performance of this compound, we tried to reduce the thermal conductivity of CoSb3 by substitution of Rh for Co and by Tl-filling into the voids. The polycrystalline samples of (Co,Rh)Sb3 and Tl-filled CoSb3 were prepared and the thermoelectric properties such as the Seebeck coefficient, electrical resistivity, and thermal conductivity were measured in the temperature range from room temperature to 750 K. The Rh substitution for Co reduced the lattice thermal conductivity, due to the alloy scattering effect. The minimum value of the lattice thermal conductivity was 4 Wm-1K-1 at 750 K obtained for (Co0.7Rh0.3)Sb3. Also the lattice thermal conductivity rapidly decreased with increasing the Tl-filling ratio. T10.25Co4Sb12 exhibited the best ZT values; the maximum ZT was 0.9 obtained at 600 K.

Thermal Conductivity of Zn4−xCdxSb3 Solid Solutions

1997 ◽  
Vol 478 ◽  
Author(s):  
T. Caillat ◽  
A. Borshchevsky ◽  
J. -P. Fleurial
Keyword(s):  
Thermal Conductivity ◽  
High Performance ◽  
Figure Of Merit ◽  
Lattice Thermal Conductivity ◽  
State Of The Art ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Jet Propulsion ◽  
P Type ◽  
Electrical Conductors

Abstractβ-Zn4Sb3 was recently identified at the Jet Propulsion Laboratory as a new high performance p-type thermoelectric material with a maximum dimensionless thermoelectric figure of merit ZT of 1.4 at a temperature of 673K. A usual approach, used for many state-of-the-art thermoelectric materials, to further improve ZT values is to alloy β-Zn4Sb3 with isostructural compounds because of the expected decrease in lattice thermal conductivity. We have grown Zn4−xCdxSb3 crystals with 0.2≤x<1.2 and measured their thermal conductivity from 10 to 500K. The thermal conductivity values of Zn4−xCdxSb3 alloys are significantly lower than those measured for β-Zn4Sb3 and are comparable to its calculated minimum thermal conductivity. A strong atomic disorder is believed to be primarily at the origin of the very low thermal conductivity of these materials which are also fairly good electrical conductors and are therefore excellent candidates for thermoelectric applications.

Atomic-Scale Three-Dimensional Phononic Crystals With a Large Thermoelectric Figure of Merit

2008 ◽  
Author(s):  
Jean-Numa Gillet ◽  
Sebastian Volz
Keyword(s):  
Thermal Conductivity ◽  
Figure Of Merit ◽  
Phononic Crystal ◽  
Three Dimensional ◽  
Phononic Crystals ◽  
Atomic Scale ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Low Thermal Conductivity ◽  
Cmos Compatible

The design of thermoelectric materials led to extensive research on superlattices with a low thermal conductivity. Indeed, the thermoelectric figure of merit ZT varies with the inverse of the thermal conductivity but is directly proportional to the power factor. Unfortunately, as nanowires, superlattices cancel heat conduction in only one main direction. Moreover they often show dislocations owing to lattice mismatches, which reduces their electrical conductivity and avoids a ZT larger than unity. Self-assembly is a major epitaxial technology to design ultradense arrays of germanium quantum dots (QDs) in silicon for many promising electronic and photonic applications as quantum computing. Accurate positioning of the self-assembled QD can now be achieved with few dislocations. We theoretically demonstrate that high-density three-dimensional (3-D) arrays of self-assembled Ge QDs, with a size of only some nanometers, in a Si matrix can also show an ultra-low thermal conductivity in the three spatial directions. This property can be considered to design new CMOS-compatible thermoelectric devices. To obtain a realistic and computationally-manageable model of these nanomaterials, we simulate their thermal behavior with atomic-scale 3-D phononic crystals. A phononic-crystal period (supercell) consists of diamond-like Si cells. At each supercell center, we substitute Si atoms by Ge atoms to form a box-like nanoparticle. Since this phononic crystal is periodic, we compute its phonon dispersion curves by classical lattice dynamics. Non-periodicities can be introduced with statistical distributions. From the flat dispersion curves, we obtain very small group velocities; this reduces the thermal conductivity in our phononic crystal compared to bulk Si. However, owing to the wave-particle duality at very small scales in quantum mechanics, another reduction arises from multiple scattering of the particle-like phonons in nanoparticle clusters. At room temperature, the thermal conductivity in an example phononic crystal can be reduced by a factor of at least 165 compared to bulk Si or below 0.95 W/mK. This value, which is lower than the classical Einstein limit of single crystalline Si, is an upper limit of the thermal conductivity since we use an incoherent-scattering approach for the nanoparticles. Because of its very low thermal conductivity, we hope to obtain a much larger ZT than unity in our atomic-scale 3-D phononic crystal. Indeed, this silicon-based nanomaterial is crystalline with a power factor that can be optimized by doping using CMOS-compatible processes. Future research on the phononic-crystal electrical conductivity has to be performed in order to compute the full ZT with a good accuracy.

Sign in / Sign up

Export Citation Format

Share Document