This study is based on the film growth by non-classical crystallization, where charged nanoparticles (NPs) are the building block of film deposition. Extensive studies about the generation of charged NPs and their contribution to film deposition have been made in the chemical vapor deposition (CVD) process. However, only a few studies have been made in the physical vapor deposition (PVD) process. Here, the possibility for Ti films to grow by charged Ti NPs was studied during radio frequency (RF) sputtering using Ti target. After the generation of charged Ti NPs was confirmed, their influence on the film quality was investigated. Charged Ti NPs were captured on amorphous carbon membranes with the electric bias of −70 V, 0 V, +5 V, +15 V and +30 V and examined by transmission electron microscopy (TEM). The number density of the Ti NPs decreased with increasing positive bias, which showed that some of Ti NPs were positively charged and repelled by the positively biased TEM membrane. Ti films were deposited on Si substrates with the bias of −70 V, 0 V and +30 V and analyzed by TEM, field-emission scanning electron microscopy (FESEM), X-ray diffraction (XRD) and X-ray reflectivity (XRR). The film deposited at −70 V had the highest thickness of 180 nm, calculated density of 4.974 g/cm3 and crystallinity, whereas the film deposited at +30 V had the lowest thickness of 92 nm, calculated density of 3.499 g/cm3 and crystallinity. This was attributed to the attraction of positively charged Ti NPs to the substrate at −70 V and to the landing of only small-sized neutral Ti NPs on the substrate at +30 V. These results indicate that the control of charged NPs is necessary to obtain a high quality thin film at room temperature.
Generation of Charged Ti Nanoparticles and Their Deposition Behavior with a Substrate Bias during RF Magnetron Sputtering