scholarly journals Quantitative manganese dissolution investigation in lithium-ion batteries by means of X-ray spectrometry techniques

2021 ◽  
Author(s):  
Claudia Zech ◽  
Marco Evertz ◽  
Markus Börner ◽  
Yves Kayser ◽  
Philipp Hönicke ◽  
...  
Keyword(s):  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Fluorescence Analysis ◽  
Absolute Amount ◽  
X Ray ◽  
Manganese Deposition ◽  
The Absolute ◽  
Manganese Species

The manganese deposition of an aged anode has been investigated with K-edge and L-edge NEXAFS to determine the manganese species. In addition, the absolute amount of manganese could be revealed with reference-free X-ray fluorescence analysis.

scholarly journals Electrochemical study on nickel aluminum layered double hydroxides as high-performance electrode material for lithium-ion batteries based on sodium alginate binder

2021 ◽  
Author(s):  
Xinyue Li ◽  
Marco Fortunato ◽  
Anna Maria Cardinale ◽  
Angelina Sarapulova ◽  
Christian Njel ◽  
...  
Keyword(s):  
Lithium Ion Batteries ◽  
Electrode Material ◽  
Photoelectron Spectroscopy ◽  
Negative Electrode ◽  
Lithium Ion ◽  
Electrochemical Study ◽  
Ex Situ ◽  
Potential Range ◽  
X Ray ◽  
Storage Mechanism

AbstractNickel aluminum layered double hydroxide (NiAl LDH) with nitrate in its interlayer is investigated as a negative electrode material for lithium-ion batteries (LIBs). The effect of the potential range (i.e., 0.01–3.0 V and 0.4–3.0 V vs. Li+/Li) and of the binder on the performance of the material is investigated in 1 M LiPF6 in EC/DMC vs. Li. The NiAl LDH electrode based on sodium alginate (SA) binder shows a high initial discharge specific capacity of 2586 mAh g−1 at 0.05 A g−1 and good stability in the potential range of 0.01–3.0 V vs. Li+/Li, which is better than what obtained with a polyvinylidene difluoride (PVDF)-based electrode. The NiAl LDH electrode with SA binder shows, after 400 cycles at 0.5 A g−1, a cycling retention of 42.2% with a capacity of 697 mAh g−1 and at a high current density of 1.0 A g−1 shows a retention of 27.6% with a capacity of 388 mAh g−1 over 1400 cycles. In the same conditions, the PVDF-based electrode retains only 15.6% with a capacity of 182 mAh g−1 and 8.5% with a capacity of 121 mAh g−1, respectively. Ex situ X-ray photoelectron spectroscopy (XPS) and ex situ X-ray absorption spectroscopy (XAS) reveal a conversion reaction mechanism during Li+ insertion into the NiAl LDH material. X-ray diffraction (XRD) and XPS have been combined with the electrochemical study to understand the effect of different cutoff potentials on the Li-ion storage mechanism. Graphical abstract The as-prepared NiAl-NO3−-LDH with the rhombohedral R-3 m space group is investigated as a negative electrode material for lithium-ion batteries (LIBs). The effect of the potential range (i.e., 0.01–3.0 V and 0.4–3.0 V vs. Li+/Li) and of the binder on the material’s performance is investigated in 1 M LiPF6 in EC/DMC vs. Li. Ex situ X-ray photoelectron spectroscopy (XPS) and ex situ X-ray absorption spectroscopy (XAS) reveal a conversion reaction mechanism during Li+ insertion into the NiAl LDH material. X-ray diffraction (XRD) and XPS have been combined with the electrochemical study to understand the effect of different cutoff potentials on the Li-ion storage mechanism. This work highlights the possibility of the direct application of NiAl LDH materials as negative electrodes for LIBs.

scholarly journals In‐situ/operando (soft) X‐ray spectroscopy study of beyond lithium‐ion batteries

2021 ◽  
Author(s):  
Feipeng Yang ◽  
Xuefei Feng ◽  
Yi‐Sheng Liu ◽  
Li Cheng Kao ◽  
Per‐Anders Glans ◽  
...  
Keyword(s):  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Spectroscopy Study ◽  
X Ray

scholarly journals Ex-situ Li plating detection on graphite anodes in extremely fast-charged lithium-ion batteries using simultaneous neutron and X-ray tomography

2021 ◽  
Vol 27 (S1) ◽  
pp. 2732-2735
Author(s):  
Maha Yusuf ◽  
Jacob LaManna ◽  
Partha Paul ◽  
David Agyeman-Budu ◽  
Michael Toney ◽  
...  
Keyword(s):  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Ex Situ ◽  
X Ray ◽  
Graphite Anodes

scholarly journals Dielectric and impedance analysis of Li0.5La0.5Ti1-xZrxO3(x = 0.05 and 0.1) ceramics as improved electrolyte material for lithium-ion batteries

2016 ◽  
Vol 34 (3) ◽  
pp. 605-616 ◽  
Author(s):  
K. Vijaya Babu ◽  
V. Veeraiah
Keyword(s):  
Ionic Conductivity ◽  
Lithium Ion Batteries ◽  
Electric Modulus ◽  
Lithium Ion ◽  
Impedance Analysis ◽  
Solid State Reaction Method ◽  
High Ionic Conductivity ◽  
Conductivity Relaxation ◽  
Reaction Method ◽  
X Ray

AbstractThe most attractive property of Li0.5La0.5TiO3 (LLTO) electrolytes is their high ionic conductivity. Studies have shown that LLTO is capable of existing in a state with an ionic conductivity of 10-3 S/cm, which is comparable to liquid electrolytes. In addition to the high ionic conductivity of the material, LLTO is electrochemically stable and able to withstand hundreds of cycles. So, the studies of the solid electrolyte material are very important for the development of lithium-ion batteries. In the present paper, Li0.5La0.5Ti1-xZrxO3 (x = 0.05 and 0.1) have been prepared by a solid-state reaction method at 1300 °C for 6 hours to improve electrolyte materials for lithium-ion batteries. The phase identified by X-ray diffractometry and crystal structure corresponds to pm3m (2 2 1) space group (Z = 1). The frequency and temperature dependence of impedance, dielectric permittivity, dielectric loss and electric modulus of the Li0.5La0.5Ti1-xZrxO3 (x = 0.05 and 0.1) have been investigated. The dielectric and impedance properties have been studied over a range of frequency (42 Hz to 5 MHz) and temperatures (30 °C to 100 °C). The frequency dependent plot of modulus shows that the conductivity relaxation is of non-Debye type.

scholarly journals Superionic Solid Electrolyte Li7La3Zr2O12 Synthesis and Thermodynamics for Application in All-Solid-State Lithium-Ion Batteries

Materials ◽  
2021 ◽  
Vol 15 (1) ◽  
pp. 281
Author(s):  
Daniil Aleksandrov ◽  
Pavel Novikov ◽  
Anatoliy Popovich ◽  
Qingsheng Wang
Keyword(s):  
Free Energy ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
Gibbs Free Energy ◽  
Thermodynamic Characteristics ◽  
Lithium Ion ◽  
Standard Enthalpy Of Formation ◽  
X Ray Diffraction ◽  
X Ray ◽  
Binary Compounds

Solid-state reaction was used for Li7La3Zr2O12 material synthesis from Li2CO3, La2O3 and ZrO2 powders. Phase investigation of Li7La3Zr2O12 was carried out by x-ray diffraction (XRD), scanning electron microscopy (SEM) and energy-dispersive x-ray spectroscopy (EDS) methods. The thermodynamic characteristics were investigated by calorimetry measurements. The molar heat capacity (Cp,m), the standard enthalpy of formation from binary compounds (ΔoxHLLZO) and from elements (ΔfHLLZO), entropy (S0298), the Gibbs free energy of the Li7La3Zr2O12 formation (∆f G0298) and the Gibbs free energy of the LLZO reaction with metallic Li (∆rGLLZO/Li) were determined. The corresponding values are Cp,m = 518.135 + 0.599 × T − 8.339 × T−2, (temperature range is 298–800 K), ΔoxHLLZO = −186.4 kJ·mol−1, ΔfHLLZO = −9327.65 ± 7.9 kJ·mol−1, S0298 = 362.3 J·mol−1·K−1, ∆f G0298 = −9435.6 kJ·mol−1, and ∆rGLLZO/Li = 8.2 kJ·mol−1, respectively. Thermodynamic performance shows the possibility of Li7La3Zr2O12 usage in lithium-ion batteries.

scholarly journals Atomic Layer Deposition of Lithium–Nickel–Silicon Oxide Cathode Material for Thin-Film Lithium-Ion Batteries

Energies ◽  
2020 ◽  
Vol 13 (9) ◽  
pp. 2345
Author(s):  
Maxim Maximov ◽  
Denis Nazarov ◽  
Aleksander Rumyantsev ◽  
Yury Koshtyal ◽  
Ilya Ezhov ◽  
...  
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Atomic Layer Deposition ◽  
Lithium Ion Batteries ◽  
Silicon Oxide ◽  
Lithium Ion ◽  
Atomic Layer ◽  
X Ray ◽  
Layer Deposition ◽  
Nickel Silicon

Lithium nickelate (LiNiO2) and materials based on it are attractive positive electrode materials for lithium-ion batteries, owing to their large capacity. In this paper, the results of atomic layer deposition (ALD) of lithium–nickel–silicon oxide thin films using lithium hexamethyldisilazide (LiHMDS) and bis(cyclopentadienyl) nickel (II) (NiCp2) as precursors and remote oxygen plasma as a counter-reagent are reported. Two approaches were studied: ALD using supercycles and ALD of the multilayered structure of lithium oxide, lithium nickel oxide, and nickel oxides followed by annealing. The prepared films were studied by scanning electron microscopy, spectral ellipsometry, X-ray diffraction, X-ray reflectivity, X-ray photoelectron spectroscopy, time-of-flight secondary ion mass spectrometry, energy-dispersive X-ray spectroscopy, transmission electron microscopy, and selected-area electron diffraction. The pulse ratio of LiHMDS/Ni(Cp)2 precursors in one supercycle ranged from 1/1 to 1/10. Silicon was observed in the deposited films, and after annealing, crystalline Li2SiO3 and Li2Si2O5 were formed at 800 °C. Annealing of the multilayered sample caused the partial formation of LiNiO2. The obtained cathode materials possessed electrochemical activity comparable with the results for other thin-film cathodes.

Sign in / Sign up

Export Citation Format

Share Document