A review of aerosol chemistry in Asia: insights from aerosol mass spectrometer measurements

2020 ◽  
Vol 22 (8) ◽  
pp. 1616-1653 ◽  
Author(s):  
Wei Zhou ◽  
Weiqi Xu ◽  
Hwajin Kim ◽  
Qi Zhang ◽  
Pingqing Fu ◽  
...  
Keyword(s):  
Real Time ◽  
Mass Spectrometer ◽  
Formation Processes ◽  
Complex Environment ◽  
Aerosol Chemistry ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass

Aerosol mass spectrometer has been widely deployed in Asia for real-time characterization of aerosol chemistry, and has significantly improved our understanding of the sources, properties, and formation processes of aerosols in a complex environment.

scholarly journals Real-Time Measurements of Engine-Out Trace Elements: Application of a Novel Soot Particle Aerosol Mass Spectrometer for Emissions Characterization

2011 ◽  
Author(s):  
E. S. Cross ◽  
A. Sappok ◽  
E. C. Fortner ◽  
J. F. Hunter ◽  
J. T. Jayne ◽  
...  
Keyword(s):  
Trace Elements ◽  
Trace Element ◽  
Real Time ◽  
Mass Spectrometer ◽  
Soot Particle ◽  
Engine Fuel ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass ◽  
Measurement Validation

Lubricant-derived trace element emissions are the largest contributors to the accumulation of incombustible ash in diesel particulate filters (DPF), eventually leading to filter plugging and an increase in engine fuel consumption. Particulate trace element emissions also pose adverse health effects and are the focus of increasingly stringent air quality regulations. To date, the rates and physical and chemical properties of lubricant-derived additive emissions are not well characterized, largely due to the difficulties associated with conducting the measurements. This work investigated the potential for conducting real-time measurements of lubricant-derived particle emissions. The experiment used the Soot Particle Aerosol Mass Spectrometer (SP-AMS) developed by Aerodyne Research to measure the size, mass and composition of submicron particles in the exhaust. Results confirm the ability of the SP-AMS to measure engine-out emissions of calcium, zinc, magnesium, phosphorous, and sulfur. Further, emissions of previously difficult to detect elements, such as boron, and low-level engine wear metals, such as lead, were also measured. This paper provides an overview of the results obtained with the SP-AMS, and demonstrates the utility of applying real-time techniques to engine-out and tailpipe-out trace element emissions. The SP-AMS used in this study was developed for real-time characterization of refractory particles (i.e. black carbon or soot) in the ambient atmosphere. The instrument consists of an intra-cavity laser (1064 nm) for particle vaporization followed by electron impact ionization and ion detection via a time-of-flight mass spectrometer. Application of the SP-AMS for engine exhaust characterization followed a two-part approach: (1) measurement validation, and (2) measurement of engine-out exhaust. Measurement validation utilized a diesel burner with precise control of lubricant consumption. Results showed a good correlation between CJ-4 oil consumption and measured levels of lubricant-derived trace elements in the particle phase. Following measurement validation, the SP-AMS measured engine-out emissions from a medium-duty diesel engine, operated over a standard speed/load matrix. This work demonstrates the utility of state-of-the-art online techniques (such as the SP-AMS) to measure engine-out emissions, including trace species derived from lubricant additives. Results help optimize the combined engine-lubricant-aftertreatment system and provide a real-time characterization of emissions. As regulations become more stringent and emission controls more complex, advanced measurement techniques with high sensitivity and fast time response will become an increasingly important part of engine characterization studies.

scholarly journals Characterization of a real-time tracer for isoprene epoxydiols-derived secondary organic aerosol (IEPOX-SOA) from aerosol mass spectrometer measurements

2015 ◽  
Vol 15 (20) ◽  
pp. 11807-11833 ◽  
Author(s):  
W. W. Hu ◽  
P. Campuzano-Jost ◽  
B. B. Palm ◽  
D. A. Day ◽  
A. M. Ortega ◽  
...  
Keyword(s):  
Mass Spectrometer ◽  
Secondary Organic Aerosol ◽  
Transport Model ◽  
Organic Aerosol ◽  
Oxidation Products ◽  
Chemical Transport Model ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass ◽  
Multiple Field

Abstract. Substantial amounts of secondary organic aerosol (SOA) can be formed from isoprene epoxydiols (IEPOX), which are oxidation products of isoprene mainly under low-NO conditions. Total IEPOX-SOA, which may include SOA formed from other parallel isoprene oxidation pathways, was quantified by applying positive matrix factorization (PMF) to aerosol mass spectrometer (AMS) measurements. The IEPOX-SOA fractions of organic aerosol (OA) in multiple field studies across several continents are summarized here and show consistent patterns with the concentration of gas-phase IEPOX simulated by the GEOS-Chem chemical transport model. During the Southern Oxidant and Aerosol Study (SOAS), 78 % of PMF-resolved IEPOX-SOA is accounted by the measured IEPOX-SOA molecular tracers (2-methyltetrols, C5-Triols, and IEPOX-derived organosulfate and its dimers), making it the highest level of molecular identification of an ambient SOA component to our knowledge. An enhanced signal at C5H6O+ (m/z 82) is found in PMF-resolved IEPOX-SOA spectra. To investigate the suitability of this ion as a tracer for IEPOX-SOA, we examine fC5H6O (fC5H6O= C5H6O+/OA) across multiple field, chamber, and source data sets. A background of ~ 1.7 ± 0.1 ‰ (‰ = parts per thousand) is observed in studies strongly influenced by urban, biomass-burning, and other anthropogenic primary organic aerosol (POA). Higher background values of 3.1 ± 0.6 ‰ are found in studies strongly influenced by monoterpene emissions. The average laboratory monoterpene SOA value (5.5 ± 2.0 ‰) is 4 times lower than the average for IEPOX-SOA (22 ± 7 ‰), which leaves some room to separate both contributions to OA. Locations strongly influenced by isoprene emissions under low-NO levels had higher fC5H6O (~ 6.5 ± 2.2 ‰ on average) than other sites, consistent with the expected IEPOX-SOA formation in those studies. fC5H6O in IEPOX-SOA is always elevated (12–40 ‰) but varies substantially between locations, which is shown to reflect large variations in its detailed molecular composition. The low fC5H6O (< 3 ‰) reported in non-IEPOX-derived isoprene-SOA from chamber studies indicates that this tracer ion is specifically enhanced from IEPOX-SOA, and is not a tracer for all SOA from isoprene. We introduce a graphical diagnostic to study the presence and aging of IEPOX-SOA as a triangle plot of fCO2 vs. fC5H6O. Finally, we develop a simplified method to estimate ambient IEPOX-SOA mass concentrations, which is shown to perform well compared to the full PMF method. The uncertainty of the tracer method is up to a factor of ~ 2, if the fC5H6O of the local IEPOX-SOA is not available. When only unit mass-resolution data are available, as with the aerosol chemical speciation monitor (ACSM), all methods may perform less well because of increased interferences from other ions at m/z 82. This study clarifies the strengths and limitations of the different AMS methods for detection of IEPOX-SOA and will enable improved characterization of this OA component.

scholarly journals Characterization of an aerodynamic lens for transmitting particles greater than 1 micrometer in diameter into the Aerodyne aerosol mass spectrometer

2013 ◽  
Vol 6 (11) ◽  
pp. 3271-3280 ◽  
Author(s):  
L. R. Williams ◽  
L. A. Gonzalez ◽  
J. Peck ◽  
D. Trimborn ◽  
J. McInnis ◽  
...  
Keyword(s):  
Mass Spectrometer ◽  
Transmission Efficiency ◽  
Cfd Modeling ◽  
Operating Pressure ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass ◽  
Valve Assembly ◽  
Computational Fluid Dynamics Cfd ◽  
Good Agreement

Abstract. We have designed and characterized a new inlet and aerodynamic lens for the Aerodyne aerosol mass spectrometer (AMS) that transmits particles between 80 nm and more than 3 μm in vacuum aerodynamic diameter. The design of the inlet and lens was optimized with computational fluid dynamics (CFD) modeling of particle trajectories. Major changes include a redesigned critical orifice holder and valve assembly, addition of a relaxation chamber behind the critical orifice, and a higher lens operating pressure. The transmission efficiency of the new inlet and lens was characterized experimentally with size-selected particles. Experimental measurements are in good agreement with the calculated transmission efficiency.

Characterization of an Aerodyne Aerosol Mass Spectrometer (AMS): Intercomparison with Other Aerosol Instruments

2005 ◽  
Vol 39 (8) ◽  
pp. 760-770 ◽  
Author(s):  
N. Takegawa ◽  
Y. Miyazaki ◽  
Y. Kondo ◽  
Y. Komazaki ◽  
T. Miyakawa ◽  
...  
Keyword(s):  
Mass Spectrometer ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass

Characterization of organic aerosols in Beijing using an aerodyne high-resolution aerosol mass spectrometer

2015 ◽  
Vol 32 (6) ◽  
pp. 877-888 ◽  
Author(s):  
Junke Zhang ◽  
Yuesi Wang ◽  
Xiaojuan Huang ◽  
Zirui Liu ◽  
Dongsheng Ji ◽  
...  
Keyword(s):  
High Resolution ◽  
Mass Spectrometer ◽  
Organic Aerosols ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass

Using Raman-lidar-based regularized microphysical retrievals and Aerosol Mass Spectrometer measurements for the characterization of biomass burning aerosols

2015 ◽  
Vol 299 ◽  
pp. 156-174 ◽  
Author(s):  
Stefanos Samaras ◽  
Doina Nicolae ◽  
Christine Böckmann ◽  
Jeni Vasilescu ◽  
Ioannis Binietoglou ◽  
...  
Keyword(s):  
Mass Spectrometer ◽  
Biomass Burning ◽  
Raman Lidar ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass

scholarly journals Application of time-of-flight aerosol mass spectrometry for the real-time measurement of particle-phase organic peroxides: an online redox derivatization–aerosol mass spectrometer (ORD-AMS)

2020 ◽  
Vol 13 (10) ◽  
pp. 5725-5738
Author(s):  
Marcel Weloe ◽  
Thorsten Hoffmann
Keyword(s):  
Real Time ◽  
Mass Spectrometer ◽  
Atmospheric Aerosol ◽  
Condensation Reaction ◽  
High Mass ◽  
Organic Peroxides ◽  
Particle Phase ◽  
Aerosol Mass Spectrometer ◽  
Aerosol Mass ◽  
Health Related

Abstract. Aerosol mass spectrometers (AMS) are frequently applied in atmospheric aerosol research in connection with climate, environmental or health-related projects. This is also true for the measurement of the organic fraction of particulate matter, still the least understood group of components contributing to atmospheric aerosols. While quantification of the organic and/or inorganic aerosol fractions is feasible, more detailed information about individual organic compounds or compound classes can usually not be provided by AMS measurements. In this study, we present a new method to detect organic peroxides in the particle phase in real-time using an AMS. Peroxides (ROOR') are of high interest to the atmospheric aerosol community due to their potentially high mass contribution to SOA, their important role in new particle formation and their function as “reactive oxygen species” in aerosol–health-related topics. To do so, supersaturated gaseous triphenylphosphine (TPP) was continuously mixed with the aerosol flow of interest in a condensation/reaction volume in front of the AMS inlet. The formed triphenylphosphine oxide (TPPO) from the peroxide–TPP reaction was then detected by an aerosol mass spectrometer (AMS), enabling the semiquantitative determination of peroxide with a time resolution of 2 min. The method was tested with freshly formed and aged biogenic VOC and ozone SOA as well as in a short proof-of-principle study with ambient aerosol.

Sign in / Sign up

Export Citation Format

Share Document