Tunable large-area phase reversion in chemical vapor deposited few-layer MoTe2 films

2019 ◽  
Vol 7 (34) ◽  
pp. 10598-10604 ◽  
Author(s):  
Xukun Zhu ◽  
Aolin Li ◽  
Di Wu ◽  
Peng Zhu ◽  
Haiyan Xiang ◽  
...  
Keyword(s):  
Phase Transition ◽  
Heat Treatment ◽  
Large Scale ◽  
Chemical Vapor ◽  
Large Area ◽  
Reversible Phase Transition ◽  
Chemical Vapor Deposited ◽  
Reversible Phase

A local large-scale reversible phase transition of MoTe2 film was accomplished through the heat treatment.

Environment-dependent and anion-vacancy-controlled reversible phase transition of MoS 2 synthesized by chemical vapor deposition

2D Materials ◽  
2018 ◽  
Vol 5 (4) ◽  
pp. 041002
Author(s):  
Hyangsook Lee ◽  
Yeonchoo Cho ◽  
Un Jeong Kim ◽  
Jaegwan Chung ◽  
Dongjin Yun ◽  
...  
Keyword(s):  
Phase Transition ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Anion Vacancy ◽  
Reversible Phase Transition ◽  
Reversible Phase

Temperature-Dependent Solid-state Luminescence and Reversible Phase Transition of (n-Bu4N)[Au(SC6H3-3,5-Me2)2]

2003 ◽  
Vol 32 (11) ◽  
pp. 1002-1003 ◽  
Author(s):  
Seiji Watase ◽  
Takayuki Kitamura ◽  
Nobuko Kanehisa ◽  
Masami Nakamoto ◽  
Yasushi Kai ◽  
...  
Keyword(s):  
Phase Transition ◽  
Solid State ◽  
Temperature Dependent ◽  
Reversible Phase Transition ◽  
Reversible Phase ◽  
State Luminescence

Photoinduced reversible phase transition of azobenzene-containing polydiacetylene crystals

2016 ◽  
Vol 52 (97) ◽  
pp. 14059-14062 ◽  
Author(s):  
Woohyun Baek ◽  
Jung-Moo Heo ◽  
Seungwhan Oh ◽  
Sang-hwa Lee ◽  
Jaeyong Kim ◽  
...  
Keyword(s):  
Phase Transition ◽  
Reversible Phase Transition ◽  
Reversible Phase

A photoinduced reversible phase transition with a simultaneous crystal tearing phenomenon was observed in an azobenzene-containing supramolecular polydiacetylene (PDA) crystal.

Preparation of PVA/PEG Phase Change Composite Nanofibers by Electrospinning

2011 ◽  
Vol 306-307 ◽  
pp. 37-40 ◽  
Author(s):  
Da Hui Sun ◽  
Tian Yu Xu ◽  
Yong Jia Liu ◽  
Mei Zhang
Keyword(s):  
Phase Transition ◽  
Phase Change ◽  
Composite Nanofibers ◽  
Diameter Distribution ◽  
Weight Percentage ◽  
Weight Content ◽  
Reversible Phase Transition ◽  
Change Characteristics ◽  
Micro Morphology ◽  
Reversible Phase

Phase change PVA / PEG composite nanofibers were prepared by electrospinning, micro-morphology of PVA / PEG fibers with different weight content were analyzed, the phase change characteristics were also analyzed. The result showed that well distributed composite nanofibers which composed by PVA/PEG blend solution can be obtained by electrospinning.PVA fibreforming were influenced because of the existence of PEG, including bond, irregular block, small rough, uneven diameter distribution in fibers. PVA/PEG blend solution of 4:6 weight content was well fibreforming compared with other different weight content.The continuity of spinneret flow in electrospinning would directly affected by polymer solution consentrition and viscosity. Further research about which and the influence in fibers diameter and morphology will be explored. Composite nanofibers possessed reversible phase transition characteristics,Tm Essentially unchanged ,Tcwere related to the weight percentage of PEG/PVA, at the same time, the enthalpy will increase along with the gradually increase in weight percentage of PEG.

scholarly journals Influence of plasma treatment on SiO2/Si and Si3N4/Si substrates for large-scale transfer of graphene

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
R. Lukose ◽  
M. Lisker ◽  
F. Akhtar ◽  
M. Fraschke ◽  
T. Grabolla ◽  
...  
Keyword(s):  
Large Scale ◽  
Oxygen Plasma ◽  
Chemical Vapor ◽  
Limiting Factors ◽  
Adhesion Properties ◽  
Si Substrates ◽  
Wetting Contact Angle ◽  
Angle Measurements ◽  
Chemical Vapor Deposited ◽  
Contact Angle Measurements

AbstractOne of the limiting factors of graphene integration into electronic, photonic, or sensing devices is the unavailability of large-scale graphene directly grown on the isolators. Therefore, it is necessary to transfer graphene from the donor growth wafers onto the isolating target wafers. In the present research, graphene was transferred from the chemical vapor deposited 200 mm Germanium/Silicon (Ge/Si) wafers onto isolating (SiO2/Si and Si3N4/Si) wafers by electrochemical delamination procedure, employing poly(methylmethacrylate) as an intermediate support layer. In order to influence the adhesion properties of graphene, the wettability properties of the target substrates were investigated in this study. To increase the adhesion of the graphene on the isolating surfaces, they were pre-treated with oxygen plasma prior the transfer process of graphene. The wetting contact angle measurements revealed the increase of the hydrophilicity after surface interaction with oxygen plasma, leading to improved adhesion of the graphene on 200 mm target wafers and possible proof-of-concept development of graphene-based devices in standard Si technologies.

Sign in / Sign up

Export Citation Format

Share Document