Tailored polymer nanocomposite membranes based on carbon, metal oxide and silicon nanomaterials: a review

2019 ◽  
Vol 7 (15) ◽  
pp. 8723-8745 ◽  
Author(s):  
Meenakshi Sundaram Sri Abirami Saraswathi ◽  
Alagumalai Nagendran ◽  
Dipak Rana
Keyword(s):  
Water Treatment ◽  
Metal Oxide ◽  
Polymer Nanocomposite ◽  
Nanoscale Materials ◽  
Nanocomposite Membranes ◽  
Separation Processes ◽  
The Past ◽  
Structure Synthesis

Research into the structure, synthesis and properties of nanoscale materials has increased at an enormous pace over the past decades since they have a wide variety of applications ranging from adsorption to separation processes in water treatment.

scholarly journals Robust Polymer Nanocomposite Membranes Incorporating Discrete TiO2 Nanotubes for Water Treatment

Nanomaterials ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 1186 ◽  
Author(s):  
Mahdi ◽  
Kumar ◽  
Goswami ◽  
Perdicakis ◽  
Shankar ◽  
...  
Keyword(s):  
Organic Matter ◽  
Water Treatment ◽  
Oil Sands ◽  
Tio2 Nanotubes ◽  
Water Flux ◽  
Polymer Nanocomposite ◽  
Nanocomposite Membranes ◽  
Practical Applications ◽  
Modified Polymer ◽  
Pes Membrane

Polyethersulfone (PES) is a polymeric permeable material used in ultrafiltration (UF) membranes due to its high thermomechanical and chemical stability. The hydrophobic nature of PES membranes renders them prone to fouling and restricts the practical applications of PES in the fabrication of water treatment membranes. The present study demonstrates a non-solvent-induced phase separation (NIPS) approach to modifying PES membranes with different concentrations of discrete TiO2 nanotubes (TNTs). Zeta potential and contact angle measurements showed enhanced hydrophilicity and surface negative charge in TNTs/PES nanocomposite membranes compared to unmodified PES membranes. To discern the antifouling and permeation properties of the TNTs/PES membranes, steam assisted gravity drainage (SAGD) wastewater obtained from the Athabasca oil sands of Alberta was used. The TiO2 modified polymer nanocomposite membranes resulted in a higher organic matter rejection and water flux than the unmodified PES membrane. The addition of discrete TNTs at 1 wt% afforded maximum water flux (82 L/m2 h at 40 psi), organic matter rejection (53.9%), and antifouling properties (29% improvement in comparison to pristine PES membrane). An enhancement in fouling resistance of TNTs/PES nanocomposite membranes was observed in flux recovery ratio experiments.

Nanometal and metal oxide-based polymer nanocomposite membranes for pervaporation

2020 ◽  
pp. 231-262
Author(s):  
Samit Kumar Ray ◽  
Amritanshu Banerjee ◽  
Swastika Choudhury ◽  
Debapriya Pyne
Keyword(s):  
Metal Oxide ◽  
Polymer Nanocomposite ◽  
Nanocomposite Membranes

New series of organic–inorganic polymer nanocomposite membranes for fuel cell applications

2019 ◽  
Vol 32 (3) ◽  
pp. 296-305 ◽  
Author(s):  
Sivasubramanian Gandhimathi ◽  
Hariharasubramanian Krishnan ◽  
Deivanayagam Paradesi
Keyword(s):  
Fuel Cell ◽  
Metal Oxide ◽  
Base Material ◽  
Polymer Nanocomposite ◽  
Inorganic Polymer ◽  
Proton Nuclear Magnetic Resonance ◽  
Membrane Electrode ◽  
X Ray Diffraction ◽  
Nanocomposite Membranes ◽  
X Ray

Flexible organic–inorganic polymer nanocomposite membranes with uniformly distributed metal oxide nanoparticles were prepared using sulfonated poly(ether ether ketone) (SPEEK) as a base material and praseodymium oxide (PSO) as an inorganic additive. The degree of sulfonation of SPEEK was determined by proton nuclear magnetic resonance (NMR) analysis and found to be 60%. The characteristic properties of the polymer nanocomposite membranes were examined by thermogravimetric analysis, X-ray diffraction, ion exchange capacity, water uptake ability, and proton conductivity. The incorporation of metal oxide into the polymer matrix was confirmed by scanning electron microscope with energy dispersive X-ray spectroscopy and X-ray diffraction analyses. The nanocomposite membrane exhibits good thermal stability when compared to that of the pristine membrane and SPEEK with 10 wt% of PSO loading was found to be stable up to 450°C. The assessment of polymer electrolyte membrane is accomplished by fabricating membrane electrode assemblies of pure SPEEK and SP-PSO-10 membranes and the latter produced maximum peak power density of 622 mW cm−2. The constructed SPEEK/PSO nanocomposite membranes offered superior physicochemical properties while applying these materials in an H2-O2 fuel cell.

scholarly journals Engineered Zero-Dimensional Fullerene/Carbon Dots-Polymer Based Nanocomposite Membranes for Wastewater Treatment

Molecules ◽  
2020 ◽  
Vol 25 (21) ◽  
pp. 4934
Author(s):  
Mona Jani ◽  
Jose A. Arcos-Pareja ◽  
Ming Ni
Keyword(s):  
Wastewater Treatment ◽  
Water Treatment ◽  
Carbon Dots ◽  
Membrane Filtration ◽  
Antibacterial Activities ◽  
Future Research ◽  
Nanocomposite Membranes ◽  
Separation Processes ◽  
Challenges And Opportunities ◽  
Forms Of Carbon

With the rapid growth of industrialization, diverse pollutants produced as by-products are emitted to the air-water ecosystem, and toxic contamination of water is one of the most hazardous environmental issues. Various forms of carbon have been used for adsorption, electrochemical, and ion-exchange membrane filtration to separation processes for water treatment. The utilization of carbon materials has gained tremendous attention as they have exceptional properties such as chemical, mechanical, thermal, antibacterial activities, along with reinforcement capability and high thermal stability, that helps to maintain the ecological balance. Recently, engineered nano-carbon incorporated with polymer as a composite membrane has been spotlighted as a new and effective mode for water treatment. In particular, the properties of zero-dimensional (0D) carbon forms (fullerenes and carbon dots) have encouraged researchers to explore them in the field of wastewater treatment through membrane technologies as they are biocompatible, which is the ultimate requirement to ensure the safety of drinking water. Thus, the purpose of this review is to highlight and summarize current advances in the field of water purification/treatment using 0D carbon-polymer-based nanocomposite membranes. Particular emphasis is placed on the development of 0D carbon forms embedded into a variety of polymer membranes and their influence on the improved performance of the resulting membranes. Current challenges and opportunities for future research are discussed.

scholarly journals Advanced development of metal oxide nanomaterials for H2 gas sensing applications

2021 ◽  
Author(s):  
Yushu Shi ◽  
Huiyan Xu ◽  
Tongyao Liu ◽  
Shah Zeb ◽  
Yong Nie ◽  
...  
Keyword(s):  
Metal Oxide ◽  
Gas Sensors ◽  
Gas Sensing ◽  
The Past ◽  
Sensing Applications ◽  
The Future ◽  
Metal Oxide Nanomaterials ◽  
Nanomaterials Synthesis ◽  
Advanced Development

The scheme of the structure of this review includes an introduction from the metal oxide nanomaterials’ synthesis to application in H2 gas sensors—a vision from the past to the future.

scholarly journals A Review on Polymer Nanocomposites and Their Effective Applications in Membranes and Adsorbents for Water Treatment and Gas Separation

Membranes ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 139
Author(s):  
Oluranti Agboola ◽  
Ojo Sunday Isaac Fayomi ◽  
Ayoola Ayodeji ◽  
Augustine Omoniyi Ayeni ◽  
Edith E. Alagbe ◽  
...  
Keyword(s):  
Greenhouse Gases ◽  
Polymer Nanocomposites ◽  
Gas Separation ◽  
Rapid Growth ◽  
Dye Removal ◽  
Anthropogenic Activities ◽  
Polymer Nanocomposite ◽  
Population Increase ◽  
Nanocomposite Membranes

Globally, environmental challenges have been recognised as a matter of concern. Among these challenges are the reduced availability and quality of drinking water, and greenhouse gases that give rise to change in climate by entrapping heat, which result in respirational illness from smog and air pollution. Globally, the rate of demand for the use of freshwater has outgrown the rate of population increase; as the rapid growth in town and cities place a huge pressure on neighbouring water resources. Besides, the rapid growth in anthropogenic activities, such as the generation of energy and its conveyance, release carbon dioxide and other greenhouse gases, warming the planet. Polymer nanocomposite has played a significant role in finding solutions to current environmental problems. It has found interest due to its high potential for the reduction of gas emission, and elimination of pollutants, heavy metals, dyes, and oil in wastewater. The revolution of integrating developed novel nanomaterials such as nanoparticles, carbon nanotubes, nanofibers and activated carbon, in polymers, have instigated revitalizing and favourable inventive nanotechnologies for the treatment of wastewater and gas separation. This review discusses the effective employment of polymer nanocomposites for environmental utilizations. Polymer nanocomposite membranes for wastewater treatment and gas separation were reviewed together with their mechanisms. The use of polymer nanocomposites as an adsorbent for toxic metals ions removal and an adsorbent for dye removal were also discussed, together with the mechanism of the adsorption process. Patents in the utilization of innovative polymeric nanocomposite membranes for environmental utilizations were discussed.

The Vyredox and Nitredox Methods of in situ Treatment of Groundwater

1988 ◽  
Vol 20 (3) ◽  
pp. 149-163 ◽  
Author(s):  
Carol Braester ◽  
Rudolf Martinell
Keyword(s):  
Water Treatment ◽  
Surface Water ◽  
Traditional Method ◽  
Treatment Method ◽  
Nitrate Treatment ◽  
The Past ◽  
The World ◽  
Nitrate And Nitrite ◽  
Iron And Manganese

Nearly one fifth of all water used in the world is obtained from groundwater. The protection of water has become a high priority goal. During the last decades pollution of water has become more and more severe. Today groundwater is more and more used in comparison with surface water. Recently we have seen accidents, which can pollute nearly all surface water very quickly. Generally the groundwater is easier to protect, as well as cheaper to purify, and above all it is of better quality than the surface water. During the past two decades, alternatives to the traditional method of treating the water in filters have been developed, that is in situ water treatment i.e. the VYREDOX and NITREDOX methods. The most common problem regarding groundwater is too high content of iron and manganese, which can be reduced with the VYREDOX method. In some areas today there are severe problems with pollution by hydrocarbons and nitrate as well, and with modification of the VYREDOX treatment method it is used for hydrocarbon and nitrate treatment as well. The method to reduce the nitrate and nitrite is known as the NITREDOX method.

Mass Transfer in Tubular Ceramic Membranes for Polluted Water Treatment - Numerical Simulation

2018 ◽  
Vol 20 ◽  
pp. 16-33 ◽  
Author(s):  
J. Saraiva de Souza ◽  
S. José dos Santos Filho ◽  
Severino Rodrigues de Farias Neto ◽  
A.G. Barbosa de Lima ◽  
H.A. Luma Fernandes Magalhães
Keyword(s):  
Mass Transfer ◽  
Water Treatment ◽  
Produced Water ◽  
Ceramic Membrane ◽  
Porous Ceramic ◽  
Ceramic Membranes ◽  
Numerical Results ◽  
Polluted Water ◽  
Separation Processes ◽  
Water Separation

Innovative technologies are needed to attend the increasingly strict requirements for produced water treatment, since most of the separation processes are limited to particles larger than 10 μm. Separation processes using ceramic membranes are attracting great interest from academic and industrial community. Nevertheless, few studies, especially numerical, regarding the inorganic membrane’s application for the polluted water separation have been reported. In the present work, therefore, a study of fluid-flow dynamics for a laminar regime in porous tubes (tubular porous ceramic membrane) has been performed. The mass, momentum and mass transport conservation equations were solved with the aid of a structured mesh using ANSYS CFX commercial package. The velocity of local permeation was determined using the resistance in series model. The specific resistance of the polarized layer was obtained by Carman-Kozeny equation. The numerical results were evaluated and compared with the results available in the literature, where by a good agreement with each other was found. The numerical results, obtained by the proposed shell and tubular membrane separation module, indicate that there is facilitation of mass transfer and hence a reduction in the thickness of the polarized boundary layer occurs.

Sign in / Sign up

Export Citation Format

Share Document